Search:

Type: Posts; User: mccann

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    33
    Views
    1,129

    Someday I would like to experiment with a unit...

    Someday I would like to experiment with a unit and graph all the values that can be measured as I add refrigerant from 0% to way over charge, at standard indoor and outdoor. Then repeat the...
  2. Replies
    7
    Views
    527

    No. It has R407c, two 10 ton txvs, a top coil...

    No.
    It has R407c, two 10 ton txvs, a top coil and bottom coil, 3 compressors in tandem, One big one and two smaller, hot gas bypass, hot gas reheat, electric heat. The control panel in the photo...
  3. Replies
    7
    Views
    527

    Thanks; I'll know more after today when I have...

    Thanks; I'll know more after today when I have seen it myself. Navigation of the controller is usually my first confusion when deal with any new equipment.
  4. Replies
    7
    Views
    527

    580941580951580961

    580941580951580961
  5. Thread: Part changers

    by mccann
    Replies
    26
    Views
    1,174

    Keep increasing the size of the breaker or fuse....

    Keep increasing the size of the breaker or fuse. The answer will come in a flash.
  6. Replies
    7
    Views
    527

    Military AC units

    Anybody know about these military units? I'm told I will be changing a compressor on a EEI (Engineered Environments, Inc.) It has tandem Trane 15 ton or so compressors. It sits on a trailer with flex...
  7. Replies
    11
    Views
    580

    When measuring ohms and amps on a small 480 volt...

    When measuring ohms and amps on a small 480 volt crankcase heater; if you don't have a sensitive meter, you may think it's open.
  8. Replies
    37
    Views
    8,457

    Looks like a better design than the Sporlan one....

    Looks like a better design than the Sporlan one. Better price too. What will not be connected to our phone in the future?
  9. Replies
    19
    Views
    1,171

    If it saves money, we will be seeing this...

    If it saves money, we will be seeing this everywhere soon. Plumbers have been using it for years. Low bid gets the job. Good thing o-rings never fail, ha ha. I wonder how it will do with heat pump...
  10. I work on a bunch of Lieberts with 407c. All have...

    I work on a bunch of Lieberts with 407c. All have clear sight glasses.
  11. I work on a bunch of Lieberts with 407c. All have...

    I work on a bunch of Lieberts with 407c. All have clear sight glasses.
    I have seen some refrigeration systems that never clear the glass. When it's running nice, the refrigerant will "river" by the...
  12. Replies
    6
    Views
    397

    It is a York,...

    It is a York, YCIV0177VA46VABBXTXXXXXLXXXX44XXXXX...........Typical giant model #.
    The sensor starts reading high by about 10*. It has happened on two different same model units which are right next...
  13. >Dual sensors everywhere: Subcooling, superheat,...

    >Dual sensors everywhere: Subcooling, superheat, ambient, motor temps, supply, return, amps. Differences in adjacent sensors will alarm a fault.
    >Artificial intelligence learns and controls...
  14. It's important to have a solid column of liquid...

    It's important to have a solid column of liquid at the TXV to have it function well. That's the idea of having some subcooling (indicating fully condensed liquid). I would try to get a clear glass...
  15. Replies
    6
    Views
    397

    Temp sensors fail on York chillers

    Is it common to see a lot of temperature sensor failures on a York chiller? This one chiller we do has had the chilled water sensors fail multiple times. Anybody else seen this?
  16. Replies
    14
    Views
    733

    You are not wrong. I do not do such things...

    You are not wrong. I do not do such things lightly. I'm going to speak to our salesman and let him explain the cost risk analysis to the customer.
    This was one reason I was asking for some numbers...
  17. Replies
    21
    Views
    922

    What is the math formula you used?

    What is the math formula you used?
  18. Replies
    14
    Views
    733

    There are no taps or vents. Two 3" gate valves...

    There are no taps or vents. Two 3" gate valves isolate the chiller from the loop. In the winter they shut the gate valves and open a bypass valve so water is just pumped back to the tanks.
    I...
  19. Replies
    14
    Views
    733

    It's fresh potable water. They circulate it...

    It's fresh potable water. They circulate it through the chiller and feed off the tank to mix cement in their trucks. They must have some make up water to keep the tank full.
  20. Replies
    14
    Views
    733

    Yes it is cooling the actual water that is used...

    Yes it is cooling the actual water that is used for the cement. Yes, it does have a strainer. I should open that the first thing when i get back there. I will.
    Question: As a strainer plugs; what...
  21. Replies
    14
    Views
    733

    Jayguy: Why do you say "that explains the...

    Jayguy: Why do you say "that explains the approach?"
    I was hoping to get some numbers in my head to go back with. That approach is high for these brazed plate heat exchangers from my reading, but...
  22. Replies
    14
    Views
    733

    Trane chiller low suction.

    Trane, 60 ton, CGAFC604A10000E000... Both circuits go off on low pressure as the water temperature gets closer to set-point.
    This chillers cools a 20,000 gal tank of water that is used for making...
  23. Thread: Liebert System4

    by mccann
    Replies
    7
    Views
    707

    What is a system 4? I have all the training...

    What is a system 4? I have all the training manuals for Liebert and I don't see it. Do you have a model #?
  24. Replies
    8
    Views
    1,218

    @hvac69. I think you are right. Alas, I was...

    @hvac69. I think you are right. Alas, I was hoping I could change the output to analog. I do not see clear instructions on the web anywhere. I have already called in the "control company" to come...
  25. Replies
    8
    Views
    1,218

    Belimo to controller change output

    I am looking for instructions on how to change the output of a controller.
    I have a Automated Logic controller ZN341v+ connected to a Belimo TR24-SR-T US for a reheat valve on a VAV. On a call...
  26. Thread: Hot loop

    by mccann
    Replies
    8
    Views
    618

    Thanks. Wow, just water going around and around...

    Thanks. Wow, just water going around and around in the pipe makes so much heat. Fascinating.
    Yes, the pump should be off, but apparently some nimrod bypassed the bad contactor and never followed...
  27. Thread: Hot loop

    by mccann
    Replies
    8
    Views
    618

    Hot loop

    A small chilled water loop is 130*f.
    The chiller is off. The 3-way valve by the one air handler is in bypass; so no water is going through the air handler. The chilled water pump is jumped out and...
  28. Replies
    2
    Views
    302

    They look like standard temperature probes that...

    They look like standard temperature probes that you might strap to a pipe or hang in a duct. They do not have mounting hardware, just the little probe. We would have to replace them all. The plans...
  29. Replies
    2
    Views
    302

    Room sensor location

    I have a building with 2 Carrier boxcar units and about 12 VAV boxes each. The room sensors are in the return air registers. It does not control well, constant complaints. Different guys have tried...
  30. Replies
    10
    Views
    883

    Thanks, I think you are right. I will keep...

    Thanks, I think you are right.
    I will keep doing what I do and wait for the Singularity.
  31. Replies
    10
    Views
    883

    I don't disagree with you. (Rant) I came from...

    I don't disagree with you.
    (Rant) I came from the supermarket world (20+ years). We worked with the high level control guys all the time and I have great respect for them. I don't want to mess with...
  32. Replies
    10
    Views
    883

    That looks nice. Things are advancing...

    That looks nice. Things are advancing exponentially. I hate to spend a 10,000 hours and dollars to learn all the old junk. I think I will leave that to the specialist. Everything will eventually be...
  33. Replies
    10
    Views
    883

    yep, I'm not a controls guy

    yep, I'm not a controls guy
  34. Replies
    10
    Views
    883

    Not a controls guy, but

    I will never be a "controls guy." If you read the Controls section on HVAV-TALK, it looks like they're speaking Greek. I have respect for their ability and type of mind. However, we in the commercial...
  35. Replies
    51
    Views
    2,473

    Wow. Some systems are so bad. Get some pictures....

    Wow. Some systems are so bad. Get some pictures. Years later you'll look and say, oh yes, that POS; found a beer can in the oil separator.
  36. Replies
    51
    Views
    2,473

    The large oil separator should be fine. It is the...

    The large oil separator should be fine. It is the drop in velocity of the hot gas the drops out most of the oil from the refrigerant, so big is better. The helical style work great. The problem with...
  37. Replies
    2
    Views
    329

    New Carrier tripping VFD

    The VFD to the indoor blower has tripped a few times on over-current fault. It would run a couple days then be tripped.
    The unit is running in high speed fan, 60 Hz, because it is in economizer...
  38. Thread: Noisy duct

    by mccann
    Replies
    20
    Views
    1,022

    Balancing damper screw loose?

    Balancing damper screw loose?
  39. Thread: Liebert AC4

    by mccann
    Replies
    2
    Views
    521

    On Lieberts, you need to always shut the unit off...

    On Lieberts, you need to always shut the unit off with the off switch before killing power or it creates a power fail alarm. To reset it you need to power it off correctly again with the off switch...
  40. Replies
    11
    Views
    834

    Why don't vacuum pumps have a check valve?

    Why don't vacuum pumps have a check valve?
  41. Replies
    46
    Views
    2,860

    The solid wires should be pre-twisted together...

    The solid wires should be pre-twisted together with linemen's pliers before putting the stranded to it.
    If putting stranded to a solid or group or solids, strip the stranded longer so the end sticks...
  42. Thread: A/C Renew

    by mccann
    Replies
    31
    Views
    3,359

    We just had the same thing happen on a new...

    We just had the same thing happen on a new Liebert Minimate. After 24 hours it started running great. Suction went from 20# to 65#.
  43. Replies
    84
    Views
    4,988

    Lieberts now come with 407c in them. Many with...

    Lieberts now come with 407c in them. Many with the same R-22 compressors they always had. There's a small difference in settings but no big deal. I do not know if Liebert did a bunch of research and...
  44. Replies
    19
    Views
    1,433

    I find several issues with these units. It's...

    I find several issues with these units. It's hardly redundant. The unit has two compressors and two heat exchangers with no isolation valves, and one very expensive pump. The controller has no useful...
  45. Replies
    19
    Views
    1,433

    Unit is a KKT Kraus, model KSC 215-L-U/S, Bladder...

    Unit is a KKT Kraus, model KSC 215-L-U/S, Bladder style expansion tank which is part of the chiller. Closed loop. No storage tank. One pump. Everything on it is in German. Can't shut anything off...
  46. Replies
    19
    Views
    1,433

    Good idea.

    Good idea.
  47. Replies
    19
    Views
    1,433

    Yes it has an expansion tank. It sounds empty....

    Yes it has an expansion tank. It sounds empty. You are right there must be a leak. It has very thick insulation. I shall not give up.
  48. Replies
    19
    Views
    1,433

    This is a sealed loop.

    This is a sealed loop.
  49. Replies
    19
    Views
    1,433

    Where does the water go?

    We take care of a couple of little Kraus chillers for some MRI machines. We have had to add a little water (perhaps a gallon or two) to them a few times because the suction side of the pump goes down...
  50. Replies
    2
    Views
    330

    What company is that from?

    What company is that from?
Results 1 to 50 of 160
Page 1 of 4 1 2 3 4

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech365 Virtual Event