Search Results - HVAC-Talk: Heating, Air & Refrigeration Discussion

Search:

Type: Posts; User: SJProwler

Page 1 of 9 1 2 3 4

Search: Search took 0.01 seconds.

  1. Old Thread with an update, My Dealer just...

    Old Thread with an update,

    My Dealer just replaced my 2nd reversing valve Saturday. After being in cool mode all summer and working fine, the first time the XP-21 went in to heat mode it had the...
  2. Thank You VERY much for the bulletin you sent. ...

    Thank You VERY much for the bulletin you sent. My tech just left. Reversing valve sticking, both switching in to cool and switching back to heat. As soon as he tapped lightly with the handle of...
  3. Kevin, If there is an alert out from Davenet...

    Kevin,

    If there is an alert out from Davenet on this can you e-mail me the number or info on it so I can share it with my Dealer.

    My XP21 (2 ton installed in Dec.) will not heat since this past...
  4. I guess you didn't try googling it did you... ...

    I guess you didn't try googling it did you...

    Only about 625 results for it...Google Search
  5. I played around with the settings, either ended...

    I played around with the settings, either ended up with the blower trying to go wide open at full capacity, or causing high limit lockouts. The system is smart and the defaults that it recommends...
  6. I switched my SLP98 from Fixed CFM to Fixed DAT...

    I switched my SLP98 from Fixed CFM to Fixed DAT using the default temps. At the lower firing rates it runs the blower slightly slower but as the firing rate changes the blower speed changes to...
  7. Replies
    10
    Views
    1,912

    I have no choice on the location of mine, it's...

    I have no choice on the location of mine, it's under the left grill (looking from the access panel) of the condensing unit. Even at night it's a few degrees off from my Davis Sensor. Odd thing...
  8. I'm not sure that I'd rely on that being an...

    I'm not sure that I'd rely on that being an accurate indicator of the humidity in your home. Get yourself an electronic hygrometer/thermometer to get a more accurate measurement. Most home centers...
  9. Not attempting to hijack the OP's thread but I...

    Not attempting to hijack the OP's thread but I have 2200 amps of -48v batteries that I'm planning to charge off-peak and run on during on-peak as soon as I can afford the inverters. And eventually...
  10. Here is the fuel cost comparison using the...

    Here is the fuel cost comparison using the current rates in my area.

    My heat pump has a COP of 3.59 at 47f and 2.18 at 17f
    My furnace is rated at 97% AFUE
    My off peak electric is .03918...
  11. That is not necessarily true, I also have the...

    That is not necessarily true, I also have the on-peak/off-peak electrical rates.

    Down to 17 degrees my HP (HSPF 8.7) provides heat during the off peak rate for less than half the price of my 97%...
  12. Some of the guys around here take the old but...

    Some of the guys around here take the old but still servicable units and donate them to the Habitat for Humanity Re-Store. Then they can deduct them as a charitable contribution.
  13. Thread: TOM D

    by SJProwler
    Replies
    12
    Views
    811

    The best thing you can do to prevent the same...

    The best thing you can do to prevent the same damage to your furnace is to make sure filters are changed on a regular basis, airflow is good and have an annual checkup by an HVAC Pro. (Preferably...
  14. Replies
    35
    Views
    3,421

    At 20 degrees F I am still getting 95 deg air out...

    At 20 degrees F I am still getting 95 deg air out of my registers with my heat pump. The gas backup is locked out to that point during my off peak electric periods.
  15. Replies
    112
    Views
    9,021

    I would try to contact the gentleman that posted...

    I would try to contact the gentleman that posted right before your last post. He is from Denver and may be able to make a recommendation.
  16. Replies
    15
    Views
    1,022

    Nowhere in my manual does it say anything about...

    Nowhere in my manual does it say anything about requiring a power humidifier to use the precision setting and mine has been working fine.

    As far as your airflow issues, sounds like the ductwork...
  17. Thread: Clean House

    by SJProwler
    Replies
    26
    Views
    1,610

    After 15 years as a telephone repairman I've seen...

    After 15 years as a telephone repairman I've seen all the above and sometimes not just in the bad part of town. One family was a repeat offender. Guy was a bigwig with the worlds largest appliance...
  18. Replies
    15
    Views
    1,022

    Actually, choosing "precision humidity control"...

    Actually, choosing "precision humidity control" in setup on the icomfort will do the same as wiring to the EAC terminal. In fact if you aren't running continuous blower and there is a call for...
  19. Just did a network install in the summer home of...

    Just did a network install in the summer home of the CEO of the Morningstar Fund. Heating was all pex radiant floor, heated by ground source heat pump hot water.
  20. Replies
    24
    Views
    1,384

    Monroe, isn't that pretty close to the "No Heat,...

    Monroe, isn't that pretty close to the "No Heat, No Cool Action Fast" Area?
  21. Replies
    18
    Views
    2,090

    Dragging this one out of the mothballs... On...

    Dragging this one out of the mothballs...

    On Dec 21, 2010 an outstanding small local Lennox Dealer that was highly recommended by friends, family and co-workers did an outstanding job of...
  22. Replies
    5
    Views
    2,912

    I've had mine installed since 12/21/10. No...

    I've had mine installed since 12/21/10. No issues with operation or performance.

    There are only a few issues I've found and those are listed here;

    Loving my SLP98
  23. Replies
    5
    Views
    2,912

    Known issue, here is a link... Burner box fix....

    Known issue, here is a link...

    Burner box fix.
  24. Replies
    5
    Views
    745

    My old Rheem would have very little output of...

    My old Rheem would have very little output of condensate while it was running, however as soon as the inducer shut off a large amount would drain. Perhaps it's holding more condensate in the...
  25. My 2 stage heat pump runs in low, if it can't...

    My 2 stage heat pump runs in low, if it can't maintain it switches to high before it ever attempts to use aux heat. Not sure why you'd want aux heat strips coming on before you even get to the 2nd...
Results 1 to 25 of 215
Page 1 of 9 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event