Type: Posts; User: TEK723
Not a person that like HONDA that's for sure!
Im from Robinson Twp PA
Does the vent pipe extend 8" from the wall? Or does it just have an ell on it?
I say what Twilli said:D
Isn't the coil tubing to thin for repair? Hoe do you repair them?
are these wall of shame pictures?
I believe you said you had an 80% furnace. Was the flue tied in with the hot water tank? Does the tank flie have a 3" liner in the chimney?
I went through that myself last month on my first GB-142 install. It was driving me nuts trying to figure out how the AM10 was supposed to be mounted!!! I call my supplier and he said upside down....
You guys are making this up! lol
In the picture, it would appear that it should be a deeper trap.
I would think the water would be pushed out of the trap being on the positive side of the fan.
Thank you, obxtech! Do you use a software for duct sizing?
I'm interested in buying software for load calculations. I see R.H.V.A.C. RESIDENTIAL CALCULATION and J8 for windows on the ACCA site. Does anybody have any recommendations?
See if you suction line is freezing up at the furnace or outside.
Was born and raised in it, Dad was an ac tech and so am I. I feel better in the cooler temps. Just the way I was made! lol
I've read here to take statis pressure readings berfore the evap coil and after the filter on a furnace. If you were checking a evap air handler, would you test further doen stream to avoid VP?
I second that !
I updated my Mothers system 8 years ago after my father passsed away and I guesstimated it was 30 plus years old and still operating. I thought about calling the company to see if they wanted to do a...
Could be a restriction in the liquid line. I found one after a compressor failure. Copper dryer/strainer acting like a metering device.
Looks like a poor braze job to me also. I don't see a kink.
Good call cat man!
Dam near took the words right out of my mouth. Try to anticipate your journeymen. I'm new to the site, and read alot of great stuff. Your alright beenthere.
I responded to the wrong thread shallowluv, sorry! still learning the site.