Search:

Type: Posts; User: Heatpump1$

Search: Search took 0.00 seconds.

  1. I bought the Bacharac H-10 and I find this works...

    I bought the Bacharac H-10 and I find this works the best of any I have used. Takes a little practice to get the hang of but I have found known leaks that other techs have missed. The sensor needs to...
  2. I had same problem and in the end some one had...

    I had same problem and in the end some one had installed return air grilles that housed filters. Homeowner had lived there for three years and was not aware. These filters were like plywood.
  3. Replies
    2
    Views
    299

    New to site.

    Hello all,
    Looks like a great source of info. I have 6 years experience with 80% of that in residential and the rest in light commercial.
  4. After sharing the operating data with the...

    After sharing the operating data with the Frigidaire tech he advised to pull charge. The install is two years old and an approved combination. Pressures still are a little high but unit has 28 degree...
  5. This installation is using an approved coil and I...

    This installation is using an approved coil and I did not ad extra for the 35 foot lineset.
  6. I pulled 1.5# of charge out and this seems to...

    I pulled 1.5# of charge out and this seems to have everything working good. First time I have overcharged by weighing at name plate. Every brand has their own quirks. Thank you everyone on your...
  7. to daniel87829, what is ymmv? Thanks

    to daniel87829,
    what is ymmv? Thanks
  8. The unit was under charged upon first visit and...

    The unit was under charged upon first visit and it would trip sooner than with full charge. Suction pressure with correct charge stayed fairly constant but head pressure steadly climbed. Opening up...
  9. Had a look and it is clean.

    Had a look and it is clean.
  10. Frigidaire FT4BF-060k

    Frigidaire FT4BF-060k
  11. Cause of high pressure in heat pump heating.

    Hello All,
    Having an issue with a heat pump running at high discharge temp and pressure and tripping on high pressure. I pulled charge and weighed it back in. Was low on charge which was caused by...
Results 1 to 11 of 11
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event