Search:

Type: Posts; User: ddcprogrammer

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    1,264

    Thanks Alcomech

    Thanks Alcomech
  2. Replies
    6
    Views
    1,264

    That would be nice but you know salesmen, "was...

    That would be nice but you know salesmen, "was not in my quote", as I found out yesterday, even the motors are not in the quote. We are going to remove the controller and replace with Alerton and...
  3. Replies
    6
    Views
    1,264

    Yes, it is a VAV but it is not what I would call...

    Yes, it is a VAV but it is not what I would call direct coupled, it is a OLD system and has the board and actuator (small clock motor and some reduction gears) all in one assembly. I am replacing...
  4. Replies
    6
    Views
    1,264

    Trane veritrac dampers

    Can anyone tell me what size the shaft is on a Trane Veritrac zone damper is and if you can mount a Honeywell, Siemens, or Belimo motor on them? Thank you
  5. Replies
    160
    Views
    29,354

    Whoever is the good software samaratin out there...

    Whoever is the good software samaratin out there I am looking for the SetupMS3.exe or the SetupDBACS.exe, what ever is most recent, spent the last hour online looking and can not find it anywhere.
  6. Replies
    4
    Views
    407

    Thanks, I will try to contribute more.

    Thanks, I will try to contribute more.
  7. Replies
    4
    Views
    407

    Originally I was looking in the educational...

    Originally I was looking in the educational section, but I will apply for pro, I have been in hvac for 30 years, 11 of those in controls.
  8. Replies
    4
    Views
    407

    Privileges

    Hello, I have tried to look at posts and even when it says there are threads, I go into the category it says there are no posts. I have been signed up with this site for quite some time and I was...
  9. Replies
    1
    Views
    847

    Dectron Controls

    I am looking to install our controls on a Dectron DK unit (100% outside air) and looking at the electrical drawing there is a CDS valve wired to the temperature control board. I am wondering what CDS...
  10. Replies
    0
    Views
    962

    Automated Logic APT tool

    Hi all, I am looking for some tech literature on using the Automated Logic APT tool, I have a Nortec humidifier that has a Automated Logic controller to convert the information to Bacnet and the...
  11. Replies
    3
    Views
    651

    Thanks for your replies, I have since found out...

    Thanks for your replies, I have since found out that the points that are not available through the Bacnet side need to have a additional "points pac" purchased to break out some of the points that...
  12. Replies
    3
    Views
    651

    Hi all, we are integrating into a Automated Logic...

    Hi all, we are integrating into a Automated Logic system and are in dire need of a Bacnet points list for a VAV controller, can anyone help me out here? Thanks in advance
Results 1 to 12 of 12
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event