Search:

Type: Posts; User: mistercrusher

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    18
    Views
    4,223

    that is a very nice job. i commend you on paying...

    that is a very nice job. i commend you on paying attention to detail. i have experienced installers that don't pay that much attention to detail. are you looking for a new job??
  2. Replies
    56
    Views
    18,455

    the reason manufacturers recomend brazing is...

    the reason manufacturers recomend brazing is because most techs do not put the time to do it right, if you clean the fittings good and make sure of a good joint it will last longer than the unit....
  3. Replies
    7
    Views
    2,306

    how did you get the pics on? i tried to post and...

    how did you get the pics on? i tried to post and my pics where too big. the site told me to down size but i don't know how.
  4. Replies
    36
    Views
    3,755

    i would like to hear what they say? a sting...

    i would like to hear what they say? a sting would be nice but might not do much, people don't pay attention. a company around here was investigated, and fined twice for ripping off customers in last...
  5. payson, congrats on new job. i'm sure everything...

    payson, congrats on new job. i'm sure everything will work out well for you. i'm glad to see there is someone out there who appreciates your pride in what you do and seeked your services.
  6. Replies
    13
    Views
    1,213

    that advertising just might be gay enough to...

    that advertising just might be gay enough to actually work.
  7. Replies
    27
    Views
    35,571

    correct me if i'm wrong but carrier is offered...

    correct me if i'm wrong but carrier is offered through sears. and i think carrier makes kenmore. be careful with sears they hire sub contractors, make sure they are reputable
  8. get someone to do a man j room by room, sounds...

    get someone to do a man j room by room, sounds like you need more supply and returns to the den, just increasing size of ah will not deliver anymore air to or from the den. you may need duct...
  9. Originally posted by PaysonHVAC [B] I...

    [QUOTE]Originally posted by PaysonHVAC
    [B]

    I haven't seen it get that bad aournd here yet.



    But is it getting DEEP around here.
    This morning they were looking through our invoices and I...
  10. Replies
    15
    Views
    1,442

    make sure the installer set the dip switches...

    make sure the installer set the dip switches according to equipment size and specifications.
  11. Replies
    19
    Views
    4,054

    the steelers are the only team i know that has...

    the steelers are the only team i know that has had the head of officials call several different times over last 5 years to offer apologies for wrong calls. one that comes to mind bettis's coin flip...
  12. Replies
    29
    Views
    1,932

    Originally posted by RoBoTeq You...

    [QUOTE]Originally posted by RoBoTeq


    You want to dispute what I stated with something more then a contradiction?

    While TXVs control superheat which allows systems to operate more evenly...
  13. Replies
    29
    Views
    1,932

    you tell him DR. i've always said " the man who...

    you tell him DR. i've always said " the man who calls another man dumb is generally dumb himself"
  14. Replies
    5
    Views
    2,809

    it looks like a dryer vent?

    it looks like a dryer vent?
  15. i do not pay on commission for just that reason,...

    i do not pay on commission for just that reason, i don't want my techs selling something that doesn't need replaced. i agree with paying a good hourly wage and do a good thorough and honest job. i...
  16. what size are your supply and return ducts? how...

    what size are your supply and return ducts? how many supply vents and return vents do you have throughout house?
  17. Replies
    12
    Views
    5,063

    Re: AAV

    you can single pipe any of the 90+ furnaces, but it changes heat exchanger warranty to 20 year instead of lifetime
  18. Replies
    12
    Views
    5,063

    sure you can terminate with one penetration by...

    sure you can terminate with one penetration by using a concentric kit
  19. Replies
    17
    Views
    2,631

    no rubber grommet or romex connector on low...

    no rubber grommet or romex connector on low voltage either.
  20. do you show your boss these pics? i've seen a few...

    do you show your boss these pics? i've seen a few of your threads and it seems like alot are from your company. what does your boss say? think? or is he just as much a hack? i hope your the highest...
  21. Replies
    29
    Views
    1,932

    the federal requirement is no cooling units may...

    the federal requirement is no cooling units may be manufactured after jan 26 2006. but anything out standing can be installed. including 10 seer
    and you are correct about txv. except for goodman,...
  22. Replies
    13
    Views
    1,317

    you don't need a seperate air handler, just the...

    you don't need a seperate air handler, just the VS furnace evap coil, and instead of just air conditioner use a heat pump
  23. Replies
    29
    Views
    1,932

    you should be fine as long as you use the piston...

    you should be fine as long as you use the piston that comes with the condenser. you will still lose the 13 seer efficiency but will work ok.
  24. Replies
    13
    Views
    1,317

    i agree with bart, use a carrier or bryant, with...

    i agree with bart, use a carrier or bryant, with infinity or evolution control. and i also recommend using the 2 speed (or 2 stage) condenser too. works great with 2 stage furnace. you could get...
  25. Replies
    8
    Views
    1,244

    i would use the 2 stage variable speed furnace...

    i would use the 2 stage variable speed furnace and would also use a xl19i, or xl16i. these are two speed air conditioners and remove up to 50% more humidity than single speed units. i live in PA and...
  26. Replies
    7
    Views
    1,014

    you can use a 3.5 hp with 4 ton air handler, but...

    you can use a 3.5 hp with 4 ton air handler, but not recommended it is better to match sizes. if you do this you definatly need to install a txv
  27. Replies
    7
    Views
    1,014

    are you using a trane 13 seer hp with a goodman...

    are you using a trane 13 seer hp with a goodman 12 seer airhandler? if so, by doing this you will lose the 13 seer efficiency. but you should install a txv and discard the piston that comes with the...
  28. Replies
    8
    Views
    864

    i don't live in your area and can't relate to 20%...

    i don't live in your area and can't relate to 20% humidity in summer. but the humidifiers can operate by humidity alone. i would use a powered humidifier and mount it on supply duct to replace the...
  29. Replies
    685
    Views
    48,653

    i own an hvac company and read a few of the many...

    i own an hvac company and read a few of the many notes on this. too many to read all. but my recommendation is that your contractor should have done a manual j load calculation to determine right...
  30. Replies
    14
    Views
    1,811

    i own an hvac company and sell bryant and trane....

    i own an hvac company and sell bryant and trane. bryant is the same as carrier. i too prefer carrier over trane. here trane is more expensive and no more reliable. i also recommend 2 stage variable...
  31. Replies
    19
    Views
    4,054

    ah yes the greatest city in the world. i can't...

    ah yes the greatest city in the world. i can't tell is that the fort pitt, or squirrel hill tunnels? great pics of a happy time. but i think we lost randle-el today to redskins.
  32. Replies
    21
    Views
    2,932

    it's always interesting to see what people call...

    it's always interesting to see what people call things from different parts of country. what you call joist lining, we call panning. do any of you guys pre make "blockers" the end caps at end of a...
  33. Replies
    16
    Views
    2,813

    that is a sweet looking job collin

    that is a sweet looking job collin
  34. Replies
    21
    Views
    2,932

    it's always interesting to see what people call...

    it's always interesting to see what people call things from different parts of country. what you call joist lining, we call panning. do any of you guys pre make "blockers" the end caps at end of a...
  35. Replies
    18
    Views
    2,613

    Re: suggestion

    i agree the tape makes the install look like a patch job. silicon is much better choice
  36. Replies
    170
    Views
    21,194

    and make sure they put in a float switch, if the...

    and make sure they put in a float switch, if the drains clog and water backs into pan the switch should shut off system. we did a attic job and i will post a pic next week for you.
  37. Replies
    45
    Views
    7,389

    what is the reason why you guys can't install in...

    what is the reason why you guys can't install in front of disconnects? here condensers must be at least one foot from wall. which leaves adequate access to disconnects
  38. Replies
    33
    Views
    5,462

    i understand where your coming from, i worked for...

    i understand where your coming from, i worked for a guy like that he used to get pissed at me for using too much metal. he came out on the job once he tried to show me how to basically fudge it. he...
  39. Replies
    7
    Views
    2,151

    your probably right. i was being sarcastic.

    your probably right. i was being sarcastic.
  40. Replies
    29
    Views
    6,755

    that is what annual P/M's are for. all flame...

    that is what annual P/M's are for. all flame sensors oxidize and need cleaned. although they probably will grant the warranty, they shouldn't
  41. Replies
    2
    Views
    1,066

    did you hear about the two polish gentlemen who...

    did you hear about the two polish gentlemen who opened up a paper mill.
    it blew away
  42. Replies
    14
    Views
    1,713

    started as a tool fetcher and grunt...

    started as a tool fetcher and grunt boy........now i own the company
  43. Replies
    7
    Views
    2,151

    idiot installers, how many times has ice had to...

    idiot installers, how many times has ice had to be removed from intake? mabye thats why its tilted?
  44. Replies
    16
    Views
    3,157

    deal :)

    deal :)
  45. Replies
    2
    Views
    1,683

    work like this comes from lazy installers, but...

    work like this comes from lazy installers, but thier laziness is in their thought process. by not thinking it out they will use more materials and actually will spend more time doing it wrong than...
  46. Thread: 3

    by mistercrusher
    Replies
    16
    Views
    2,396

    not to mention the 4 or 5 whiskey guzzlers and...

    not to mention the 4 or 5 whiskey guzzlers and two busty bar maids
  47. Replies
    19
    Views
    4,784

    around here any system in garages must be...

    around here any system in garages must be enclosed in its own little room and with fire rated walls and doors
  48. Replies
    16
    Views
    2,642

    yeah mabye, up until this site i've never talked...

    yeah mabye, up until this site i've never talked with other hvac in other areas of country. around here the metal fabricators take offense if you don't know your fittings. and they've been known to...
  49. Replies
    16
    Views
    2,642

    yeah mabye, up until this site i've never talked...

    yeah mabye, up until this site i've never talked with other hvac in other areas of country. around here the metal fabricators take offense if you don't know your fittings.
  50. Replies
    13
    Views
    3,777

    "hey clark...sh**er was full" (christmas...

    "hey clark...sh**er was full" (christmas vacation)
Results 1 to 50 of 78
Page 1 of 2 1 2
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event