Search:

Type: Posts; User: jstarzy

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    722

    Any help would be appreciated... I have a...

    Any help would be appreciated...

    I have a Lennox Model # G1603/4 100-1 S# 5887G10452 gas furnace. I powered up for the 1st time this fall and smelled gas in the basement. I observed that only 1 of...
  2. Replies
    2
    Views
    803

    I am having landscaping done and not sure to have...

    I am having landscaping done and not sure to have the contractor install the outside AC unit on a full composite pad, a full set of blocks or corner only blocks to allow air underneath the unit....
  3. Replies
    32
    Views
    13,817

    Conclusion to Short Cycling

    CONCLUSION:

    Gas Co. Tech measured draft in flue with old inducer blower and demonstrated how draft kept reducing; at first with inducer, then flame engaged then fan motor. It went below what I...
  4. Replies
    32
    Views
    13,817

    Chimney

    Chimney is only exposed for 1-1/2 stories above garage roof line. There is a 6 inch rectangular liner on the furnace side and a 12 inch liner on the fireplace side. Both have meshed caps to keep the...
  5. Replies
    32
    Views
    13,817

    All...thanks for help so far....here are some...

    All...thanks for help so far....here are some more observations while I wait for the parts...

    Chimney had a healthy amount of vapor comoing out of it this morning that I could see from driveway
    ...
  6. Replies
    32
    Views
    13,817

    Also.... Furnace has a Robertshaw (indicates...

    Also....

    Furnace has a Robertshaw (indicates for Lennox on it) EC pac. There are no LEDs.
  7. Replies
    32
    Views
    13,817

    Tech is from Gas Co. I have a full service...

    Tech is from Gas Co. I have a full service contract with. I hope they are not just parts swappers. Any suggestions on how to proceed if they indicate "it must be the chimney".

    At least all parts...
  8. Replies
    32
    Views
    13,817

    Service tech looked at unit this...

    Service tech looked at unit this morning....verified problem and ordered a new induction motor and pressure switch. Said if that does not fix the problem, the chimney needs to be looked at.

    Any...
  9. Replies
    32
    Views
    13,817

    I will have model and serial number tomorrow....

    I will have model and serial number tomorrow. Current stat is a new honeywell 8500 digital with 4 wire hook up. However...furnace had the same problem with a Rite-Temp 4 wire digital too.
  10. Replies
    32
    Views
    13,817

    Not the stat.

    Toolpusher...

    Thanks for the reply...

    The stat calls for heat and releases just fine over a long period of time. All of the on and off is occurring during the duration of time the stat calls...
  11. Replies
    32
    Views
    13,817

    Can anyone give me an idea of what is causing the...

    Can anyone give me an idea of what is causing the furnace to cycle the gas feed to the burners on for 10 seconds, then off for 10 seconds for the duration of time the thermostat calls for heat?
    ...
Results 1 to 11 of 11
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event