Search:

Leaky evap coils are famous these days

The outdoor TXV is stuck open, you can try putting the bulb in ice water to see if TXV closes and also putting the bulb in hot water to see if it opens. Watch your suction pressure. You need to...

At 50 degrees outside there is no load on equipment and pressures will be off in cooling mode. The proper way to charge heat pump is to recover the refrigerant and weigh in the factory charge. But...

Check the Discharge line temp outside the outdoor unit. If extremely hot like in the 200's the outdoor TXV is bad. I had a armstrong unit do the same thing. Run fine in cooling but in heat i had...

Trane does make a good unit, for all you trane lovers

York themselves don't advertise its the dealers. Im a york dealer and i have to say what few problems we have with them york backs us 100% not like crappy trane. We use to be a trane dealer to but...

The LRA on the plate is what that compressor is tested at. I have seen alot of units run past that rating but not very long.

If compressor is pulling LRA then it needs to be replaced.

He's old school

I have seen 10 to 16 degrees at 6 inches from body.

I agree over 150 ohms and replacing.

Is it the right evap piston for that outdoor unit

TXV problem

Sounds like its over charged

Its a matter of time before it fails

If its pulling high amps then condemn the compressor

Just experience using different hoses

What is the LRA and what is the compressor rated at? 30 plus amps sounds high in a 5 ton system.

Yellow jacket makes ball valve end hoses, they are very nice. I think RE Michel sells them for $120.00

I used yellow jacket low loss hoses and had trouble with the high side too. I think the low loss ends are not made for anything above 325psi. I use there ball valve ends now and no problems

Is the compressor pulling high amps on start up? Double check the wiring at the current sensing relay.

Mitsubishi makes a flush ceiling mount air handler unit

Maybe a window unit

I have seen 115 to 125 degrees at about 95 degrees outside

You add refrigerant to raise subcool and remove refrigerant to lower subcool