Search:

Type: Posts; User: craftyringwiseveteran

Search: Search took 0.00 seconds.

  1. XP-SP3 with a PCC-10 card is a practical solution...

    XP-SP3 with a PCC-10 card is a practical solution (no real need for VMWare). It is not supported by Honeywell but most Honeywell techs use it. But, there are some quirks. In order to "restore" a...
  2. The connector on the old style "flat cable" is...

    The connector on the old style "flat cable" is notorious for failing. Open it up and give it a close look. I always carried a spare. Perhaps the problem might provide an excuse to move to a laptop...
  3. Replies
    5
    Views
    589

    The real question is what is the L7033 connected...

    The real question is what is the L7033 connected to? These are 500 Ohm balco sensors and I doubt that you're going to find a direct replacement. The good news is that quite a few of the controllers...
  4. How are you using them? 0-10 VDC, Floating, 2...

    How are you using them? 0-10 VDC, Floating, 2 Position? I have seen similar actuators that have failed becasue the control operating them caused them to reposition every few seconds.
  5. Replies
    7
    Views
    956

    This is the Ask Our Pro's forum. In order to post...

    This is the Ask Our Pro's forum. In order to post a response here, you must have verified qualifications and have been approved by the AOP Committee. You may ask a question by starting a new thread....
  6. Replies
    52
    Views
    6,271

    Commercial construction is a strong possibility....

    Commercial construction is a strong possibility. Find a smallish company where you can be upfront with the boss. No major corporation is going to listen to your story and they ARE going to do a...
  7. Replies
    5
    Views
    495

    Each DDC program in a R7044 has a program error...

    Each DDC program in a R7044 has a program error point assigned to it. I believe (we're going WAY back here) that the value is a three digit integer. When a program has an issue such as a sensor...
  8. Replies
    20
    Views
    2,048

    Sounds good on paper...

    But I haven't seen a successful implementation in a typical commercial building. I have a couple of questions:

    If you manually operate the fans and dampers in the manner intended by the CE can you...
Results 1 to 8 of 8
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event