Type: Posts; User: Le_Bear
Search: Search took 0.00 seconds.
09-01-2012, 01:32 AM
Thank you so much, Mark, I'm turning it back to high. As well, with what JT said, I'm also thinking put a pedestal fan in front to toss the cold air into the room, while the (bigger draw) AC fan is...
09-01-2012, 12:57 AM
(i'm thinking keep it on low, and put a more energy concious fan in front? like a super-charge maybe?
09-01-2012, 12:55 AM
Aha! so... the only variance in energy used will be the fan draw?
09-01-2012, 12:40 AM
lol! Thanks, JT, I'll turn it off ; )
08-31-2012, 11:54 PM
I posted a quiery here recently about a Fedders window unit, that I had cleaned up a good bit, and installed....
08-10-2012, 12:47 AM
Here's a picture of the beast ; ) 299181 Not having a front Bezel, I fashioned one, to cast the output upwards, towards the center of the room, and help keep it from going straight back into the...
08-10-2012, 12:34 AM
Thanks so much for your reply Jim. You nailed the top and bottom one, but the middle one I'm not sure. Top to right is high fan/no compressor, top to left is low fan/no compressor. Beyond that in...
08-09-2012, 11:32 PM
here's what it says when I click on one of the photos, to see if they showed up
"Le_Bear, you do not have permission to access this page. This could be due to one of several reasons:
08-09-2012, 11:29 PM
Am I to take it my photos didn't post? I see I've only posted 4 comments, and when I click on one of them, it tells me I don't have the rights to see it
08-09-2012, 10:51 PM
Thanks Beenthere :) I have some photos I hope will help, and since installing this I've found that the lower knob, L-R, is basically compressor Off/low-On/full.The middle, most important one is still...
08-05-2012, 08:14 AM
Well, I found a site with some user's guides, and although it didn't have the same model I found as similar as possible and it recommended a half a bubble tilt on the unit, seems kinda steep but...
08-05-2012, 07:30 AM
Any Clues? When I did my initial search I didn't get any results, but coming back this morning hoping to find an answer I noticed the A1R in the model, and wondered if I had entered it correctly,...
08-04-2012, 08:15 PM
Hi, I've just found this site, and hope the questions I'm asking are within the rules and guidelines. I've been given an old 05/93 Fedders window unit model A1R08F2B Series 1473, 110v, 7500btu, and...
Results 1 to 13 of 13