Search:

Type: Posts; User: docjones

Search: Search took 0.01 seconds.

  1. Replies
    13
    Views
    3,639

    Sounds like you have a Beacon II, probably with a...

    Sounds like you have a Beacon II, probably with a MAC condensor if you're at McDonald's. Best way to check the sensor is just put a thermometer next to it and compare the readings. Or 32,650 ohms @...
  2. Replies
    5
    Views
    1,003

    New solenoid, new sensor, new board, same...

    New solenoid, new sensor, new board, same problem?
    Check your ground. Specifically check your ground is good at DC connection, at line voltage connection behind machine and back to load center.
    ...
  3. Replies
    4
    Views
    1,331

    I just E-mailed you the info.

    I just E-mailed you the info.
  4. Replies
    4
    Views
    1,331

    I might be able to help you out. E-Mail me.

    I might be able to help you out. E-Mail me.
  5. Replies
    13
    Views
    1,766

    Assuming the float switch is good, if you're...

    Assuming the float switch is good, if you're getting a premature harvest the most likely cause is loss/lack of water in sump.
    A quick check- turn the machine off then back on. watch the drain line...
  6. Thread: Any ideas?

    by docjones
    Replies
    16
    Views
    1,426

    Schofield Barracks. I was the 65th Engineers...

    Schofield Barracks. I was the 65th Engineers years ago.
    Talk to the MWR office, they'll set you up with an electrician.
  7. Thread: Oil Trap?

    by docjones
    Replies
    16
    Views
    7,468

    http://hvacloads.com/talkpics/wall/11.jpg ...

    http://hvacloads.com/talkpics/wall/11.jpg


    This is actually something I run into fairly often. Line sets for an Ice machine condensor. How hard would it have been to cut the lines to length and...
Results 1 to 7 of 10

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech 365