Search:

Type: Posts; User: KB Cool

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    12
    Views
    250

    Ok, low SH means cold line. High sh means warm...

    Ok, low SH means cold line. High sh means warm line. Do you really have high SH and your calling it low SH?
  2. Replies
    12
    Views
    255

    Is there a dryer inside the condensor? Anyway to...

    Is there a dryer inside the condensor? Anyway to get a pressure reading on the discharge line and the liquid line? How long is the lineset? Is it a half inch liquid line instead of 3/8"?
  3. Replies
    12
    Views
    250

    The statement above makes no sense!!! Are you...

    The statement above makes no sense!!! Are you overfeeding or restricted?
  4. Thread: Lost my Wife

    by KB Cool
    Replies
    143
    Views
    3,576

    Oh man!! Terrible news. I'm so sorry to hear this...

    Oh man!! Terrible news. I'm so sorry to hear this hedrash. My condolences to you and your family!
  5. Replies
    14
    Views
    646

    What were your customers doing this whole time...

    What were your customers doing this whole time you were d!cking around with their unit? Did they not live there?
  6. Replies
    53
    Views
    1,580

    Is says it on the compressor data plate.

    Is says it on the compressor data plate.
  7. Replies
    53
    Views
    1,580

    That Sh!t aint no good!!!lol

    That Sh!t aint no good!!!lol
  8. Replies
    53
    Views
    1,580

    So the 407a might be better than "C"? The main...

    So the 407a might be better than "C"? The main reason why i'm using C is because the copeland compressors are stamped r22 or 407c! There obviously designed for it.
  9. Replies
    53
    Views
    1,580

    Yes, don't get me wrong. I still have 22 on the...

    Yes, don't get me wrong. I still have 22 on the truck also for that exact same scenario.
  10. Replies
    53
    Views
    1,580

    Wouldn't it suck if you replace a compressor for...

    Wouldn't it suck if you replace a compressor for a customer. Then 2 days later the discharge line cracks and blows the entire 15 lb charge all over their yard? I'm sticking with 407c on compressor...
  11. Replies
    53
    Views
    1,580

    I have not used the 407 "A" yet. Is that stuff...

    I have not used the 407 "A" yet. Is that stuff compatible w/ Mineral oil or something? I know 407 "C" requires POE. But, all the new compressors come with it anyways.
  12. Replies
    53
    Views
    1,580

    Who said 407c was for refrigeration only? I've...

    Who said 407c was for refrigeration only? I've used it for every compressor replacement this summer and nobody's complained so far!
  13. Replies
    83
    Views
    2,707

    I don't do many installs. But, i've never seen a...

    I don't do many installs. But, i've never seen a trane 410a coil with a piston. I thought they were all TXV.
  14. Replies
    11
    Views
    427

    Could be the headmaster dumping hot gas into the...

    Could be the headmaster dumping hot gas into the receiver when it's hot out.
  15. Replies
    27
    Views
    1,071

    Sounds like something is wrong with the new...

    Sounds like something is wrong with the new motor. Try a different one! Maybe the reversing leads got mixed up! IDK But, i had one that would run in reverse on one cycle. Then the next forward. It...
  16. Thread: Is it my TXV?

    by KB Cool
    Replies
    49
    Views
    2,470

    Yeah, he probably had a coupon for their $29.99...

    Yeah, he probably had a coupon for their $29.99 service special! :grin2:
  17. Yeah, i remember jumping across a low voltage...

    Yeah, i remember jumping across a low voltage contact on a relay. My alligator clip fell off and landed onto the contactor. The tstat down below caught fire. Oops!!:grin2:
  18. Replies
    13
    Views
    684

    Yeah, and the closet access in the kids bedroom...

    Yeah, and the closet access in the kids bedroom is fun too. Got to set your ladder up against the coat hanger and squeeze on in. I've had some right over the bathroom sinks too. And then theres the...
  19. Replies
    13
    Views
    684

    I'll go into an attic to pull the blower in the...

    I'll go into an attic to pull the blower in the afternoon. But, install? No way!!! Not doing it that's nuts!
  20. I just don't see anything other than a cheap...

    I just don't see anything other than a cheap defrost board or a indoor fan control board being fried. Both of which are "not" needed to test out the system! The nest isn't needed to test either!
  21. If the cap being used has a rubber o-ring that is...

    If the cap being used has a rubber o-ring that is the wrong one. Get a flare cap or brass tee instead.
  22. Possibly or a rub-through intermittent short on...

    Possibly or a rub-through intermittent short on RV lead, LP/HP sw, ect.......But, we will never know as the OP called a sales tech and not a troubleshooter. At least the first guy was trying.
  23. 2006 goodman heatpump totally fried, because of a...

    2006 goodman heatpump totally fried, because of a low voltage short? Sounds like you picked some real winners for a second opinion. I would call your friend back.
  24. Yeah really, since his compressor may lock up in...

    Yeah really, since his compressor may lock up in 2 weeks from the sealer. :eek:
  25. Replies
    59
    Views
    4,637

    You got me there. IDk. But, just the overall bulk...

    You got me there. IDk. But, just the overall bulk and heft of some of the supposedly small motors should tip you off. Afterall, the tech is the manufacturers worst enemy. Unless the unit's still...
  26. Replies
    59
    Views
    4,637

    I think some of the equipment manufacturers lie...

    I think some of the equipment manufacturers lie about the motor hp used in their equipment. It maybe labeled a 1/4hp. But, in all reality it's really a 1/3. I'll stick to amp rating instead of HP...
  27. Replies
    101
    Views
    4,945

    My tek-mate sucked with the newer refrigerant's....

    My tek-mate sucked with the newer refrigerant's. But, great with 22. Did inficon upgrade the sensors in the newer models to work w/ the 400 gases?
  28. Nice, your one of the lucky ones! Mines in the...

    Nice, your one of the lucky ones! Mines in the attic and it was a B!tch to replace. Had to get the wife and the kid to help me get the A/H up the access hole!
  29. Why are u asking? Admit it, your too old to be...

    Why are u asking? Admit it, your too old to be climbing around in your cramped little attic pulling your squirrel or your indoor coil. :grin2:
  30. Yes, technically it's the indoor coil.

    Yes, technically it's the indoor coil.
  31. Since it is a heat pump the majority of the...

    Since it is a heat pump the majority of the charge will be lost in the winter time due to the higher pressures in the evap. But, i'm sure you already knew that?
  32. I think the guy's got a big leak in his...

    I think the guy's got a big leak in his evaporator and won't admit it. He called for a tune-up because of the first lb. was free. 7 oz. my @ss!!! More like 7lbs!! He's hoping it last all summer!...
  33. How old was the old system or was it a new...

    How old was the old system or was it a new install that went totally wrong?
  34. Okay, in that case you'll be b!tching how much...

    Okay, in that case you'll be b!tching how much the evaporator replacement will be. For your sake i hope it's aluminum! :grin2:
  35. Hopefully, one of this guys reversing valve...

    Hopefully, one of this guys reversing valve capillary tubes snaps off this weekend and dumps his charge all over his backyard. :grin2:
    I can hear him now. "the part only cost $$ and your going to...
  36. About an hr.

    About an hr.
  37. Yes, they like to sell capacitors. Quick and easy...

    Yes, they like to sell capacitors. Quick and easy to replace. Half the time they just leave the new one still in the box and wrap some tape around it :grin2:
  38. I'm with you. If it isn't broke. I don't want to...

    I'm with you. If it isn't broke. I don't want to look at it!!! I've seen too many as it is. :grin2:
  39. Well, a highly trained guy who's seen thousands...

    Well, a highly trained guy who's seen thousands of heatpump's in his career. Isn't going to take 5 hrs to figure out if it's good to go for the summer.
  40. Next time, just call for regular service instead...

    Next time, just call for regular service instead of a tune-up. A smart guy like yourself should have known a low cost tune-up is just a way for a company to get themselves in your door and up-sell....
  41. Around here. All the rookies do tune-ups. I don't...

    Around here. All the rookies do tune-ups. I don't really know why. But, i guess at $39.99 a pop. You really can't afford to send a seasoned tech. :grin2:
  42. I call BS on his entire post. He had 6 SC to...

    I call BS on his entire post. He had 6 SC to start with and claims an additional 4 gave him 8 more degrees. Sounds like he just came in here to make himself feel good. Boasting how smart he is and...
  43. Seven ounces gave an additional 8 degree temp....

    Seven ounces gave an additional 8 degree temp. drop across the evaporator. I can't beleive it!!! And if your so good at doing our job. Why call for service. Do it yourself!!!Or are you too cheap to...
  44. Replies
    101
    Views
    4,945

    This is the only dye i've used. They claim it's...

    This is the only dye i've used. They claim it's OEM approved.
  45. Replies
    101
    Views
    4,945

    I don't know. But, in reality who's going to...

    I don't know. But, in reality who's going to question a warrantied part? I could yank my perfectly good compressor out of my home a/c tommorrow and get new one for free on Tuesday if i wanted...
  46. Replies
    101
    Views
    4,945

    It's the leak sealers that take out compressors...

    It's the leak sealers that take out compressors and clog strainers. Not the dye!!
  47. Replies
    101
    Views
    4,945

    It's probably buried in the coil. Or in the rear...

    It's probably buried in the coil. Or in the rear u-tubes where you can't see unless you pull it. Dye doesn't cause restrictions and is also an excellent tool.
  48. Replies
    12
    Views
    583

    That happens when your hose isn't fully...

    That happens when your hose isn't fully depressing the shrader core, if i'm following your post correctly?
  49. Replies
    27
    Views
    3,058

    Yeah, i've seen them in York too from the factory.

    Yeah, i've seen them in York too from the factory.
  50. Replies
    38
    Views
    2,087

    I actually ran a call similar to this. The guy...

    I actually ran a call similar to this. The guy had a heat only stat w/ a toggle to turn on the a/c condensor w/ no thermostatic control. Just on and off with a switch. Maybe i'm one of the guys who...
Results 1 to 50 of 1000
Page 1 of 20 1 2 3 4

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech 365