Type: Posts; User: oshimi15
JCI is at it again...
Look for another company to be bought******
Why don't you use the UNOCC mode all the time.
This way you can setup UNOCC setpoints and the fan will
cycle according to UNOCC setpoints.
On the XP --do you have AI jumpers set for voltage
If you are metasys to just view the controller then you
should be OK. We were letting the metasys start and stop
the 100% OA unit but upon startup the unit would lock itself out and there was...
NOTHING but trouble..DON"T DO IT!!!!!!!!
Also, if you are using a Local Setpoint instead of a ACO that can burn your EPROMM and you would have to replace the DX. But I would try to add another Loop first.
I am from Illinois and rumors were around last week but
my supervisor confirmed it yesterday. Although he
wouldn't be specific other than saying mechanics will be performing rep 1 and 2 work (PMs)....
x-wrenchturner---where are u from?
There are rumors flying around the branch
about mechanics getting computer classes but nothing was said about them doing any tech work.
There are other rumors...
I am working on a Carrier Chiller right now
and we have a LON card connected to CCN just
to get Chiller Info then we have local Lon controller
for Chiller ON/OFF logic. I recommend this solution...
Do you have a workstation?
If so take the battery(top right corner) out
cycle power on NC...
it should get download from workstation.
thanks special ed
Can anyone give me the capacity of the following furnace?
Comfortmaker Synder General
Also the tonnage of the following condensor?
Kenmore Hi Efficiency 5000
the above plan is replacing their little geographical teams
JCI Service Dept has a new theory on service.
Illinois will be rolling out the Milwaukee's
pilot program and then everyone else.
Something like vertical market scheme that failed