Search:

Type: Posts; User: jegs

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    1,922

    ::DD:

    ::DD:
  2. Replies
    680
    Views
    46,041

    I think your contractor is right. SEER rating is...

    I think your contractor is right. SEER rating is a marketing ploy IMO. To achieve advertised SEER everything has to be perfect. And even then SEER performance can change on a daily basis according to...
  3. Replies
    34
    Views
    1,609

    I wonder if the OP is the same guy that owns this...

    I wonder if the OP is the same guy that owns this pickup.
    http://hvac-talk.com/vbb/showthread.php?t=609492
  4. It would cost more to have your electrical...

    It would cost more to have your electrical service upgraded than it would to go out and buy another new single phase condensing unit.
  5. Thread: New Lennox system

    by jegs
    Replies
    218
    Views
    17,769

    Compared to what he had it looks like the Lennox...

    Compared to what he had it looks like the Lennox booth at a trade show.
  6. Replies
    15
    Views
    1,397

    Get a new service tech and a new system.

    Get a new service tech and a new system.
  7. Replies
    19
    Views
    1,188

    The engine should never reach 5000 RPM while in...

    The engine should never reach 5000 RPM while in drive under any conditions. I would say the transmission is on it's way out.
  8. Replies
    20
    Views
    1,551

    I've heard that if you leave them in the box and...

    I've heard that if you leave them in the box and wrap a bunch of electrical tape around them they will last longer. :D
  9. I think the positioning of the service panel on...

    I think the positioning of the service panel on the CU alone deserves the #1 spot on WOP list.
  10. No offense taken and none intended towards you. I...

    No offense taken and none intended towards you. I have nothing but respect for you and all the professional members on this site. On an internet forum it is hard to make that point come across...
  11. If the coil is acceptable I would have the fan...

    If the coil is acceptable I would have the fan speed slowed one speed down. If it is already on low then have the coil cleaned. As far as cleaning the coil yourself I'll let beenthere or one of the...
  12. Did the tech check to see if the evaporator coil...

    Did the tech check to see if the evaporator coil was dirty while he was there? Your coil is not cold enough. If the pressures were good I would suspect a dirty coil or fan speed too high. If either...
  13. Thread: HVAC Installation

    by jegs
    Replies
    21
    Views
    1,496

    If you botch the setup and the vent system for...

    If you botch the setup and the vent system for the furnace because you don't know what you're doing you could be subjecting yourself and everyone in the building to carbon monoxide poisoning. Why...
  14. Replies
    30
    Views
    1,914

    There should be a bi-flow drier already in the...

    There should be a bi-flow drier already in the system from the factory. If you are converting to R-410a this original drier MUST be changed as you will never get all the old oil out of it. Just...
  15. Replies
    24
    Views
    3,099

    I would say the installer has a sensor wired...

    I would say the installer has a sensor wired wrong somewhere.
  16. No DIY here and there is a reason the owner...

    No DIY here and there is a reason the owner doesn't get a copy of the setup manual. If the installer sees that the setup is changed on the thermostat they will probably void the warranty of the...
  17. Replies
    49
    Views
    6,035

    It's the insulation on the ducting coming out of...

    It's the insulation on the ducting coming out of the top.
  18. Replies
    49
    Views
    6,035

    The first pic looks like Indiana Jones opening...

    The first pic looks like Indiana Jones opening the Holy Grail.
  19. Replies
    680
    Views
    46,041

    Modulating compressor.

    Not trying to throw more irons in the fire but this would be perfect for you blue.

    http://www.frigidaire.net/splitsystemiQ.asp

    http://hvac-talk.com/vbb/showthread.php?t=140806
  20. Replies
    12
    Views
    765

    Lol. Whoops!

    Lol. Whoops!
  21. Replies
    55
    Views
    4,002

    Cold coil (27 degree delta) + compressor power...

    Cold coil (27 degree delta) + compressor power interrupt (low pressure switch). Sounds to me like it's low on refrigerant.
  22. Replies
    14
    Views
    3,052

    Or maybe it had just had enough and committed...

    Or maybe it had just had enough and committed suicide.
  23. Replies
    14
    Views
    3,052

    I would say that one literally took a dump.

    I would say that one literally took a dump.
  24. Replies
    35
    Views
    2,114

    Being a dad also means being your child's friend....

    Being a dad also means being your child's friend. If you treat them like you are their boss they won't have enough respect for you to listen to you when you tell them something they are doing bothers...
Results 1 to 24 of 39
Page 1 of 2 1 2
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event