Search:

Type: Posts; User: mixsit

Page 1 of 7 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    58
    Views
    1,419

    I can only imagine what some owners might be...

    I can only imagine what some owners might be thinking if they're poking around in that 'Maint is a waste of..' thread..:(

    Anyway a sheave question- after looking at the vid.
    They used the 'start...
  2. Replies
    27
    Views
    813

    'Hot gas drier-- Yes seen a few put in the...

    'Hot gas drier--
    Yes seen a few put in the discharge lines LOL
  3. Replies
    10
    Views
    371

    My experience (since this is being very general...

    My experience (since this is being very general about it) for motors even seeing open vent ports the grease was about as likely to purge' into the motor as come out the port.
    I've pretty much...
  4. Oops. Check again. One was probably 24 volt the...

    Oops. Check again. One was probably 24 volt the other 120. I did the same, on a start up - 'won't go' :whistle:

    Right now I have one dangling outside that plastic comp box- a vibration theory'...
  5. Disable the alarm enunciation? (that would be one...

    Disable the alarm enunciation? (that would be one thing. Going jumpered.. No thank you : >)
  6. Anyone familiar with Liebert / Copeland false comp O/L lockouts?

    For the past few years weve been seeing sporadic but reoccurring comp O/l trips on a small percent of DS units with the Copeland ZR190s at a facility we service.
    But for the exceptions where...
  7. Replies
    5
    Views
    245

    Ah how timely! Simply 'coating/painting. I was...

    Ah how timely! Simply 'coating/painting. I was just looking into the same and I see now Rubatex is recommending this..
    http://www.kflexusa.com/HomePages/ProductLineHome.aspx?ID=20&prod=34&line=8
  8. Replies
    22
    Views
    780

    This... and this.. And in this case (this...

    This...
    and this..

    And in this case (this fan blade vs various blower wheel type fans) is just the opposite; draws less amps with the coil side panel off (air bypassing the coil) than with it...
  9. Replies
    22
    Views
    780

    'Cause I didn't do this.. and toss their...

    'Cause I didn't do this..

    and toss their 'frikin horse power labeling.. 6.6' is not one horse -nor 1.5 for that matter- it is (or very close to) two hp, which is where we landed.
  10. Replies
    22
    Views
    780

    Is this "1hp" cond fan more like two hp?

    I put this Marathon 1 1/2 horse in to replace this '1hp' Carrier, but my amps came in high- 6.2 vs its 5.4 rating at 230volts.
    Got home and looked at some motor amperage charts, all indicate that...
  11. Replies
    17
    Views
    1,020

    I've not heard of oil level being related to...

    I've not heard of oil level being related to foam' in the sight glass. There's different kinds of 'flashing ('bubbles vs other..
    I'd ask rather how's the sub cooling.
  12. Replies
    92
    Views
    4,484

    Friday on call, stopped on the way home to git me...

    Friday on call, stopped on the way home to git me some 4th-O July BBQ.
    Some guy approached me with 'hey you know what this (insert full blown spanking new looking oxy acet cutting tip! 'thing might...
  13. That's pretty much what I've done all along- :>)...

    That's pretty much what I've done all along- :>)

    This looked like it'd do it..
    http://www.elecdirect.com/basket.aspx
    But for for the min order bump. Guess I'll wait till Monday and call around a...
  14. Replies
    92
    Views
    4,484

    Had a guy find the 3/8 (?) allen I left in the...

    Had a guy find the 3/8 (?) allen I left in the bottom of a 5H120

    No, no damage associated :grin2:
  15. Ah ok. I saw that and thought the insulation...

    Ah ok. I saw that and thought the insulation didn't seem as thick.
    Thank you
  16. What do you call that thick insulation control wire..

    they use in ac units..?
    And why can't I find some (or where)
    Seems like something -like a 'ten footter bag' ought to be available in the parts houses. :angel:
  17. Replies
    92
    Views
    4,484

    Hmm, that'd make for a fun offshoot thread (pun...

    Hmm, that'd make for a fun offshoot thread (pun there? ;)
    How many bullets have you found up on roofs and such?
    My fave was a 30 cal FMJ that was bent about 20 deg from glancing off the cement.
  18. Just to drum this home..

    Just to drum this home..
  19. Ya know I just realized something- ha! ironic (or...

    Ya know I just realized something- ha! ironic (or telling maybe!) considering the questions I'm asking :whistle:
    The 407 lieberts.. are using modular type high and low switches!
  20. This unit (R-22 BTW) was healthy about a month...

    This unit (R-22 BTW) was healthy about a month ago when I was on it last.
  21. Liebert rep says more or less, the same thing is...

    Liebert rep says more or less, the same thing is in the P66 ('wiper instead of a two-position sw of course- I've only seen a few leaks there) and, he sells about ten a month (the LP/HPCO's) - i.e....
  22. Liebert LP amd HPCO's - looking for your input here

    I just had yet another failure - leaks in around the bellows, LPCO this time, and the loss of 100+lbs of 22.
    This is approximately 2000' vintage DS units. The last time this came up -a year ago, we...
  23. I'm curious and maybe don't understand what's...

    I'm curious and maybe don't understand what's going on where.
    I never seen a failure to pump down' alarm, but what would that have to do with long line sets? And, I would think (for what seems to be...
  24. There was a slew of units back several years agao...

    There was a slew of units back several years agao that came out with 'improved discharge valves that flat out would not stay pumped down. But that would have 'short cycle alarm as the symptom ( "more...
  25. Replies
    47
    Views
    7,674

    When I did that, rightly I suppose- it'll be like...

    When I did that, rightly I suppose- it'll be like 'wow.. what?! .."
    I for one was very sceptically - not that it wouldn't work, but what of all the possible unforeseen consequences? Even after I had...
Results 1 to 25 of 165
Page 1 of 7 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event