Search:

Type: Posts; User: vapor52

Search: Search took 0.01 seconds.

  1. shophound, I don't understand if opening it up to...

    shophound, I don't understand if opening it up to basically 0 pressure doesn't change it then why will having the accurate readings tell me anything? Am I correct in assuming the TXV can't cause this...
  2. 6-12 SC, like to see max 14 on SH, I don't know...

    6-12 SC, like to see max 14 on SH, I don't know the term delta on water, I have a flow meter in line and have slowed the water down by throttling the ball valve on several different occasions but it...
  3. I did leave the door off for the test--------rick

    I did leave the door off for the test--------rick
  4. beenthere, my unit is horizontal in my crawl...

    beenthere, my unit is horizontal in my crawl (concrete floor) and connects to a 24"x 24" el turned up into my plenum. Today I cut a 20 x 16 out of the end of the el in line with the blower output...
  5. Actually the original 3T had a 3.5 T coil and a...

    Actually the original 3T had a 3.5 T coil and a 100,000 BTU furnace w/ 1500 cfm (on high ) blower as the back up system. It has 3 zones and the zones are configured so that 1 zone = 1st stage, 2...
  6. High pressure and high SH on Geothermal heat pump

    I have a Miami Heat Pump 3 1/2 T R-410A geothermal unit and I have high, high side pressure and high SH readings in heat mode on full capacity. On 1st stage the readings are normal. With...
Results 1 to 6 of 6
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event