Search:

I installed a few copeland compressor before and had the same problem , what I did to solve the condition , I ran a hose to the condenser and had the water running at a very low rate per gallon and...

One important point that must be done it to first choose the correct orifice , most of the time there are two or three sizes that come with the evaporator. then after you got the system charge and...

Udate on trumpet noise..... the heat has been on now for two days for the high temp for the past two day has only been 65 degrees but in the past two days I have not heard this noise so far..... it...

Indoor and condenser match , what get me is that is does not happens all the time... and when it does the trumpet noise last for a good minute to minute and half..... if there was a bad check valve...

I just installed a new Cormfortair Heat Pump to replace the one that got damage during hit by 4 hurricane.....
this unit is a 5 ton unit and replace it with a 5 ton unit that has 14 seers.... now...

I repaired a lot of Scotsman Ice Machine, and I know about bad bearing and seal , this is common on this type of machine but let me tell you that when I see a condition like this I usally rebuilt the...

What is different, the amout of electric usage, the time is drop down to temperature, if you say they perform differently that it not put together the same..
plus at what day are they being built...

The way you posted your question , look like the sensor or the ice bin or the water level has gone bad.. most of the time it the water sensor that goes first. you can run the machine if you got a...

you need to install a door vent with a heater so when the door closes the pressure would be release from the room
If you look inside your truck there is one in there also if you can find it.
...

I have four sets of gauges and the way I check my gauges is I got a Trojan tee coupler that I can attach two or three set at once and if they all read the same I know the gauges are pretty accurate....

I did one cap tube job and it was the last cap tube job. for first of all if the cap tube is plug there is a reason for it and unless you replace the cap tube and solder the tube to the suction line...