Search:

Type: Posts; User: hcpwr

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    808

    I would greatly appreciate it if anyone has the...

    I would greatly appreciate it if anyone has the wiring schematic for this trane unit. Hot and cold deck being controlled by the honeywell 7080 analyzer. Thanking you in advance. The model# is...
  2. Thread: Model Numbers

    by hcpwr
    Replies
    2
    Views
    975

    Thak you for your reply

    Thak you for your reply
  3. Replies
    2
    Views
    2,300

    Did you check the sensors that the motor...

    Did you check the sensors that the motor protector connects to. There should be a common leg with three sensor wires. Disconnect power to the equipment. Disconnect the sensor wires and ohm out from...
  4. Thread: Model Numbers

    by hcpwr
    Replies
    2
    Views
    975

    Can anyone help me in determining the tonnage of...

    Can anyone help me in determining the tonnage of these Trane units? Trane claims that they are having trouble locating these numbers. Any help would be greatly appreciated. Condenser#1 Model #...
  5. Replies
    19
    Views
    1,445

    I turned in my tools to do sales after being in...

    I turned in my tools to do sales after being in the field for approximatly 25 yrs. I found the experience to be a good one. You learn alot about people and the products you are selling. If you are...
  6. Thread: boiler license

    by hcpwr
    Replies
    3
    Views
    930

    I would check with your local vocational school...

    I would check with your local vocational school and find out if they hold prep courses for a boiler license. I know that bergan county tedh holds courses. Then register to take the test.
  7. Replies
    4
    Views
    1,083

    My company just got a new account and the hirise...

    My company just got a new account and the hirise building has self contained air cool units located above the ceiling. Can anyone suggest how to clean a packed evaporator coil. Power washing is out...
  8. Replies
    11
    Views
    1,193

    That looks like a good way to zone the system. I...

    That looks like a good way to zone the system. I would use an EWC or Honeywell zoning system with a discharge air sensor and a motorized bypass damper that works off of sytem air pressure. You could...
  9. Thread: cooling problem

    by hcpwr
    Replies
    13
    Views
    1,372

    The subcooling was 5deg.

    The subcooling was 5deg.
  10. Thread: cooling problem

    by hcpwr
    Replies
    13
    Views
    1,372

    I will try to pump down when I go back.

    I will try to pump down when I go back.
  11. Thread: cooling problem

    by hcpwr
    Replies
    13
    Views
    1,372

    a # 59 piston

    a # 59 piston
  12. Thread: cooling problem

    by hcpwr
    Replies
    13
    Views
    1,372

    I was working on a split system two and one half...

    I was working on a split system two and one half ton. Carrier 38tra030 approx 12 years old. The complaint was at night it gets cool but during the day the temperature goes up. Here are the pressures...
  13. Thread: curb specs

    by hcpwr
    Replies
    4
    Views
    671

    I would like to thank everyone that has tried to...

    I would like to thank everyone that has tried to help me on the curb specs. It appears that I will have to go measure the curbs as you suggested. Thanks again.
  14. Thread: curb specs

    by hcpwr
    Replies
    4
    Views
    671

    Does anyone have the curb specs on the following...

    Does anyone have the curb specs on the following GE units. BWC036B300C0 and BWC060C300B0? Any info would be greatly appreciated. I have to replace these two rooftops and Trane did not have any...
  15. Replies
    6
    Views
    1,383

    Yes I need the wiring for the 4 step contoller...

    Yes I need the wiring for the 4 step contoller and how the pressure switches are wired in the circuit. High, low and oil pressure switch. Thank you for your reply Maxster
  16. Replies
    6
    Views
    1,383

    Could anyone give me the trane website where I...

    Could anyone give me the trane website where I could get a schamatic for the following unit? CGWBC606MANGG42K
    I would appreciate it very much. Thank you
  17. Replies
    3
    Views
    784

    Worked on a Fresh air fan that was on this...

    Worked on a Fresh air fan that was on this building for about three years. I had to replace the 7 1/2HP motor due to a short in the windings, the new motor has the same specs as the original motor...
  18. Replies
    5
    Views
    720

    I would change the motor to a single phase...

    I would change the motor to a single phase 208/230 volt and than use a motor master or a Icm controller.
  19. piston or actuator

    piston,actuator or capillary
Results 1 to 19 of 20
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event