Search:

Type: Posts; User: diy73

Search: Search took 0.00 seconds.

  1. Thread: Too Many Elbows?

    by diy73
    Replies
    20
    Views
    1,931

    Dash, Thanks. I'm not sure I understand your...

    Dash,
    Thanks. I'm not sure I understand your reply. The downstairs zone is working just about right and I don't think we can damper any of the ducts for the first floor. In fact, there's one room...
  2. Thread: Too Many Elbows?

    by diy73
    Replies
    20
    Views
    1,931

    Just one more question about this. The area...

    Just one more question about this.

    The area we're trying to heat and cool is a new finished basement and we're getting very little air from the 3 new ducts that were added to the downstairs...
  3. Thread: Too Many Elbows?

    by diy73
    Replies
    20
    Views
    1,931

    cem, Thanks. They're both 90 degree elbows. ...

    cem,

    Thanks. They're both 90 degree elbows. I don't know if my previous description was confusing, but the new duct is an elbow that comes out the right side of the trunk line, curves up, joins...
  4. Thread: Too Many Elbows?

    by diy73
    Replies
    20
    Views
    1,931

    Thank you, Dash. I'll follow your and...

    Thank you, Dash.

    I'll follow your and Advanced's advice and try to approach this correctly. Like I said, I think everyone is willing to cooperate and make it work.

    Thanks again.
  5. Thread: Too Many Elbows?

    by diy73
    Replies
    20
    Views
    1,931

    Ikey, Sorry if I wasn't clear. I was asking...

    Ikey,
    Sorry if I wasn't clear. I was asking about taking the new 6" ducts off the top of the supply trunk line, which would require 1 elbow -- as opposed to taking them out the side of the supply...
  6. Thread: Too Many Elbows?

    by diy73
    Replies
    20
    Views
    1,931

    Thanks, guys. I knew I would get some good...

    Thanks, guys. I knew I would get some good advice here... but I didn't think I would get so much and so soon. This is a great forum!

    Regarding my problem... I'm still on really good terms with...
  7. Thread: Too Many Elbows?

    by diy73
    Replies
    20
    Views
    1,931

    J, Thanks. I believe the existing supply...

    J,

    Thanks.

    I believe the existing supply trunk is large enough, based on the airflow we're getting at the other registers. In fact, some have had to be dampered.

    I'm trying to determine...
  8. Thread: Too Many Elbows?

    by diy73
    Replies
    20
    Views
    1,931

    Hi to all, We had some remodeling done a...

    Hi to all,

    We had some remodeling done a couple of months ago and needed three additional ducts for a new room. There is about 10 inches clearance above the main supply duct, where I thought the...
Results 1 to 8 of 8
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event