Search:

Ah ok I'm not thanks.

If its that new chances are sheave may not be set up properly either which would change that tension as well. I would suspect that too. How new is it literally that belt should last a while unless...

I can't figure out how to private message on this site.

Well I work for a Large nationwide company now. I'm familiar with that unfortunately when they virtually never see you that's what happens.

In test mode it's opening on first test? Yes or no or is this the sometimes?

Yes CMS Mechanical.

Sorry that's not a carrier is it. I just looked quickly.

Should be bolts or nut on back side of bottom plate as well. In between rails theres slide openings you'll have to manually push motor too right after loosening all 4.

Would like some insight as to how they are setup in comparison to other nationwide HVAC contractors before I decide to apply or not. Thanks for your time

i confess I am too lazy to press caps and periods lol.

i appreciate your help but i dont see anything wrong with what i wrote b4 pretty obvious it means before and some1 =someone so not sure what i wrote wrong there

i got the handbook ive looked at it countless times today

ok thanks for the post guys ill update tomorrow got me concerned now though on connecting rod that was my biggest concern of being possible problem.

never left it running long enough to check rla or much else became to noisy was trying not to destroy anything

hmm?

.
oh i know none of it added up hence my irritation this job in general
i had some1 go out and break vibration eliminator with hammer on me 2 weeks ago so then i get a new one take it out guess...

with that being said couldve been a pos line drier hmm got me thinking now

thats what i was just wondering myself lol

i quoted a r22 system couple weeks ago it was $7200.00 add about $500 and should cover it for a 48tmf012-610

thats what i tried telling them b4 putting $5000 into a compressor when unit is a 1983 pos

actual reading being takin about 12" downstream as there is 2 service ports there some1 put in

high temp safety plug, are u asking is that where the leaks at now? and initial high pressure reading b4 startup was about 110 but when it reached 140 it never moved much from there wether running or...

yes standard evac and nitrogen holding charge leak check and so on done and yes i went grabbed different set of guages and checked guages later in day elsewhere

then slam head off unit get pissed and leave outta ideas for now

ok only 72 outside and 75 inside so no load but why no pressure movement maybe 5 psi but discharge line and heads getting hot let me hear it again bam here come the fricking hole in the dam manifold