Search:

Type: Posts; User: ACFIXR

Page 1 of 20 1 2 3 4

Search: Search took 0.12 seconds.

  1. 711661711671711681711691

    711661711671711681711691
  2. Replies
    17
    Views
    451

    Evernote rocks!

    Evernote rocks!
  3. Thread: Capacitor Rules

    by ACFIXR
    Replies
    78
    Views
    2,231

    2 caps are better than one "dual". The more the...

    2 caps are better than one "dual".
    The more the better, series is good.
  4. Thread: Capacitor Rules

    by ACFIXR
    Replies
    78
    Views
    2,231

    Something similar to this also happens with "5 to...

    Something similar to this also happens with "5 to 1" grab and go start kits. If you check what the manufacturer recommends for MFD you'll find that the "kits" have higher ratings, I have not had the...
  5. Thread: Capacitor Rules

    by ACFIXR
    Replies
    78
    Views
    2,231

    And another reason why you should check...

    And another reason why you should check compressor manufacturers literature for the right capacitor rating........................
  6. Get your room to temp then go watch your movie,...

    Get your room to temp then go watch your movie, your not living in the room and you'll never hear that mini run.
    This is one we are now doing here in Tucson, notice the double wall construction.
    ...
  7. Replies
    153
    Views
    4,237

    The "friend" needs to sell his tools and get a...

    The "friend" needs to sell his tools and get a job doing something else, maybe selling widgets.
  8. Replies
    47
    Views
    1,445

    What is this angular stainless above the prep...

    What is this angular stainless above the prep table?
    706131
  9. Replies
    47
    Views
    1,445

    Maximize the OSA on the units and check your hood...

    Maximize the OSA on the units and check your hood fan. If you can do some air changes over night that would minimize your indoor load in the am. Giving you a chance to check operation at close to...
  10. Replies
    86
    Views
    15,427

    Replace the elements and then clean the pins. All...

    Replace the elements and then clean the pins. All txv's should be serviceable. not this crap.703381
  11. Replies
    142
    Views
    32,197

    Sealants. Here is what I have found in my limited...

    Sealants. Here is what I have found in my limited experience.
    Sealants are used, obviously where there has been high super heat and loss of capacity. Typically this also means that the compressor...
  12. Replies
    51
    Views
    27,399

    same here, quick and...

    same here, quick and easy...............................
  13. Replies
    199
    Views
    6,622

    "But Merely to Think or Desire Is Not Wrong. On...

    "But Merely to Think or Desire Is Not Wrong. On the other hand, we must be careful to recognize that sexual desire is not wrong as a natural, uncultivated response, any more than anger is, or pain....
  14. Replies
    199
    Views
    6,622

    "Mind sin" is a concept that is only recognizable...

    "Mind sin" is a concept that is only recognizable by a conscience................:grin2:
  15. Replies
    30
    Views
    1,839

    You have no load, hard to trouble shoot something...

    You have no load, hard to trouble shoot something that is not actually doing any work.
  16. Replies
    30
    Views
    1,839

    Yes, i agree that you have a problem here, 58 and...

    Yes, i agree that you have a problem here, 58 and 60?
  17. Replies
    199
    Views
    6,622

    https://www.youtube.com/watch?v=yzgwNyMe_4I ...

    https://www.youtube.com/watch?v=yzgwNyMe_4I

    Threshold thinking-
    To take the way of escape the moment our thoughts are contrary to the truth and righteousness.


    "The key to winning the...
  18. The whole bible is the revelation of, and about...

    The whole bible is the revelation of, and about Jesus.
    The Word is the definition, explanation, and expression of God; hence, it is God defined, explained, and expressed.
  19. When I look at the grand canyon I realize that...

    When I look at the grand canyon I realize that Gods days are infinitely different than mine......................
  20. Replies
    16
    Views
    1,676

    If customers have interior furnaces they...

    If customers have interior furnaces they typically have 200 sq" of C&R duct that can be used for pressure relief. So I recommend opening the furnace closet doors to make use of them. I use to install...
  21. Replies
    16
    Views
    1,676

    I enjoy my evap on my house. We keep our doors...

    I enjoy my evap on my house. We keep our doors and windows open so the dogs can cruise in and out when they want. We started using our cooler yesterday. They are a huge pain to maintain, especially...
  22. Thread: Attic job

    by ACFIXR
    Replies
    29
    Views
    7,259

    Appropriately angled take-off? Where do you see...

    Appropriately angled take-off? Where do you see an appropriate take off? If that is flex it is installed wrong. You should never let your emotions and or feelings help you interpret criticisms of...
  23. Thread: Attic job

    by ACFIXR
    Replies
    29
    Views
    7,259

    567861 Flex should never be installed like this.

    567861 Flex should never be installed like this.
  24. Thread: Attic job

    by ACFIXR
    Replies
    29
    Views
    7,259

    Your right, I couldn't. I guess that big wad of...

    Your right, I couldn't. I guess that big wad of coils at the inside of the radius where the flex kinda flattens out isnt that big of a deal is it? I mean nobody can see it right?
    Do you consider...
  25. Thread: Attic job

    by ACFIXR
    Replies
    29
    Views
    7,259

    I'd make you put a hard 90 on that supply. Looks...

    I'd make you put a hard 90 on that supply.
    Looks good.
    Where's the overflow switch?
    How's that evap supported?
  26. Replies
    16
    Views
    1,676

    Hvacker, His original design i thought was a MAU....

    Hvacker, His original design i thought was a MAU.

    Don't do the water softner hookup, unless you want to see your service bill spike on that thing. Evaps can use large volumes of water. Just figure...
  27. Replies
    16
    Views
    1,676

    A bleeder is the only way to keep that crap off....

    A bleeder is the only way to keep that crap off. It also helps to maintain the highest water level possible to keep the concentrated minerals to a minimum. Timed dump pumps are a pain due to the fact...
  28. Replies
    20
    Views
    5,202

    I think this like thing could get pretty...

    I think this like thing could get pretty ugly.....................:beat:
  29. Replies
    113
    Views
    19,524

    :cheers: I dig those box's.................easy...

    :cheers: I dig those box's.................easy quick access. Old school.............
  30. Thread: Trane piping

    by ACFIXR
    Replies
    3
    Views
    814

    There is a chart included with the service facts...

    There is a chart included with the service facts in the CU.
  31. Replies
    113
    Views
    19,524

    The clip thing that holds onto your pocket breaks...

    The clip thing that holds onto your pocket breaks off to easily, I wont be buying the Milwaukee markers anymore.
  32. Replies
    113
    Views
    19,524

    That's hilarious Birmingham

    That's hilarious Birmingham
  33. Replies
    37
    Views
    5,367

    Klein 12 in 1 screwdriver.

    Klein 12 in 1 screwdriver.
  34. Replies
    113
    Views
    19,524

    It's amazing how handy that long handled 5/16 nut...

    It's amazing how handy that long handled 5/16 nut driver is.
  35. Thread: Funny Signs

    by ACFIXR
    Replies
    29
    Views
    13,141

    Sign on the Navajo Nation: ...

    Sign on the Navajo Nation:

    http://i1201.photobucket.com/albums/bb359/Chuck_Phelan/HVAC/Sheep4sale.jpg
  36. Replies
    113
    Views
    19,524

    http://img2.wikia.nocookie.net/__cb20070711224710/...

    http://img2.wikia.nocookie.net/__cb20070711224710/starwars/images/f/f7/YodaForceLift.jpg

    The tool you are to be.
  37. Replies
    113
    Views
    19,524

    I tried the little bag/pouch routine and always...

    I tried the little bag/pouch routine and always kept adding tools....................:gah:
  38. Replies
    113
    Views
    19,524

    No freekin way.

    No freekin way.
  39. Replies
    113
    Views
    19,524

    http://i1201.photobucket.com/albums/bb359/Chuck_Ph...

    http://i1201.photobucket.com/albums/bb359/Chuck_Phelan/Tools/clubs.jpg

    Hijack, whats in your bag?:grin2:
  40. Replies
    113
    Views
    19,524

    If you were out here you could actually put those...

    If you were out here you could actually put those tools to use..........................:cheers:
  41. Replies
    113
    Views
    19,524

    http://i1201.photobucket.com/albums/bb359/Chuck_Ph...

    http://i1201.photobucket.com/albums/bb359/Chuck_Phelan/Tools/ToolBin.jpg
  42. Replies
    23
    Views
    2,869

    I have "new", clean reclaim tanks I use for 22...

    I have "new", clean reclaim tanks I use for 22 and 410. These are my "virgin" tanks that I recover the last 5 or so lbs from new tanks. Then my wholesaler takes back empties at no charge. Nothing...
  43. Replies
    24
    Views
    4,422

    If your bored and have nothing better to do,...

    If your bored and have nothing better to do, rebuild it. Then baby sit it. Then bask in the glory of your accomplishment.

    Sell a new unit.
  44. Replies
    51
    Views
    20,003

    X2. Always have some on hand.

    X2. Always have some on hand.
  45. Thread: Leak Lock

    by ACFIXR
    Replies
    26
    Views
    10,324

    All of the "leak stoppers" have their ideal...

    All of the "leak stoppers" have their ideal application like y7turbo said.
    I carry and use at least 3:

    1. Nylog for mating surfaces.
    2. True Blue for pipe threads.
    3. Leak lock for leaking...
  46. Replies
    24
    Views
    4,422

    Hell, you have already talked me out of this job...

    Hell, you have already talked me out of this job ............................:grin2:
  47. I'm trying to dig in and learn as much as...

    I'm trying to dig in and learn as much as possible about the icm450, it has become the goto for protection. Therefore the reason for me attempting to get banter going about all aspects of this thing.
  48. #1 and #3 do not power the monitor. They are just...

    #1 and #3 do not power the monitor. They are just an input signal. Do you have the parameter setting "control mode" to "on" or "off" ? The delay can be set up to 10 minutes.
  49. So you have the ICM in control mode and it will...

    So you have the ICM in control mode and it will initiate a time delay before closing 4-6 if there is a loss of power at 1-3?
  50. What do you wired to terminal #1 and #3 ?

    What do you wired to terminal #1 and #3 ?
Results 1 to 50 of 1000
Page 1 of 20 1 2 3 4

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech 365