Search:

Type: Posts; User: ldmth44

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    16
    Views
    1,238

    Agree with the sealtight and tie-wrap issue and...

    Agree with the sealtight and tie-wrap issue and would have used all rubber pads as the cork will eventually deteriorate as the pads get wet. But overall, looks good.
  2. Personally, I use a thermistor plugged into my...

    Personally, I use a thermistor plugged into my meter for an accurate reading and hang it in air flow close to a diffuser, or insert into supply or return plenum. I would use an IR thermometer for a...
  3. System will have to be off (no A-C) for a while...

    System will have to be off (no A-C) for a while as A-C causes condensation on uninsulated surfaces, and run fan only for a while to completely dry out the box. Insulation is not supposed to "absorb"...
  4. IR thermometers, for the most part, read surface...

    IR thermometers, for the most part, read surface temps. If checking a duct or register, it reads the surface temp of the material carrying the air. Reducing blower speed cold cause other problems...
  5. Thread: Very unhappy!

    by ldmth44
    Replies
    7
    Views
    569

    Not enough info to go on. Were there any mods to...

    Not enough info to go on. Were there any mods to ductwork, registers? Was thermostat replaced, what are you reading room temps with as compared to thermostat? Can you verify the thermostat reading...
  6. Give them a box fan then tell them to go buy a...

    Give them a box fan then tell them to go buy a block of ice...
  7. Replies
    15
    Views
    2,401

    Looks a bit extreme to me, regardless of the...

    Looks a bit extreme to me, regardless of the "approved vendor" moniker.
  8. Replies
    5
    Views
    394

    As stated in last response, coil maybe still...

    As stated in last response, coil maybe still frozen. It must be completely thawed before adding any gas and readings should be checked then. Check that airflow is good throughout system (i.e. dirty...
  9. Replies
    10
    Views
    2,191

    She definitely ran out of "smoke!"

    She definitely ran out of "smoke!"
  10. Have used a small hacksaw blade to literally cut...

    Have used a small hacksaw blade to literally cut across the threaded part of a male PVC adapter that was stuck inside the unit's metal female fitting, then used a screwdriver to pry out the broken...
  11. Just cut the existing trap off at the 90 and...

    Just cut the existing trap off at the 90 and unscrew the adapter out of the unit and install new.
  12. Amen, brother!

    Amen, brother!
  13. Replies
    15
    Views
    2,401

    At least everything is at "eye-level" now!

    At least everything is at "eye-level" now!
  14. Replies
    6
    Views
    1,303

    Their dog must have recently died and they found...

    Their dog must have recently died and they found a good use for the doghouse since Fido didn't need it anymore.:cheers:
  15. Gotta love those calls ...especially when you...

    Gotta love those calls ...especially when you tell or show the customer that the system was vandalized. They look at you and ask, "Can you do something with it to get me some cooling?" :D
  16. What's with the double pan setup?

    What's with the double pan setup?
  17. Replies
    8
    Views
    1,464

    It's in the car parked along side.

    It's in the car parked along side.
  18. Replies
    10
    Views
    1,624

    Agree with toocoolforschool, filters aren't that...

    Agree with toocoolforschool, filters aren't that bad by the looks of that pic, but you still need to thoroughly check the system and if the filters were the culprit, teach the HO the importance of...
  19. Replies
    14
    Views
    2,279

    This video is meaningless. We don't know the...

    This video is meaningless. We don't know the reasons for any of the comments. Could have been a slow day, since there were two systems, maybe needed three guys to do the work as one could be going...
  20. Replies
    10
    Views
    1,624

    Doesn't matter...we should all realize that we...

    Doesn't matter...we should all realize that we are there to solve the problem at hand, not blame anyone.. Anything else is just complaining...be thankful we get these calls as most are billable...
  21. Replies
    10
    Views
    1,624

    Doesn't matter...we should all realize that we...

    Doesn't matter...we should all realize that we are there to solve the problem at hand, not blame anyone.. Anything else is just complaining...be thankful we get these calls as most are billable...
  22. Thread: Craigslist ad

    by ldmth44
    Replies
    18
    Views
    2,911

    All I have to do is specify what I am looking for...

    All I have to do is specify what I am looking for and it will be here by Monday, will be delivered at 3:00am though...:whistle:
  23. Thread: Craigslist ad

    by ldmth44
    Replies
    18
    Views
    2,911

    Could buy a new one for $50 from the local...

    Could buy a new one for $50 from the local crackhead!
  24. Thread: Ladder Safety

    by ldmth44
    Replies
    24
    Views
    3,726

    Especially since those clouds look pretty scary! ...

    Especially since those clouds look pretty scary! Thunderstorm moving in?
  25. Replies
    23
    Views
    3,907

    Self-rinsing cleaner, should have vacuumed first...

    Self-rinsing cleaner, should have vacuumed first then sprayed, but not wipe--potential damage to coils. Wasn't dirty to begin with but tube sheet looks like crap. Coil is NFL (Not For Long), leak...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event