Search:

I grew up on fieldpiece and like the accessories. I bought a fluke and have it for a spare. I have had issues with my fieldpieces mainly in the temp areas but then I dont treat them like I should...

Tostaky, Do what the tech that is working on it told you to do!!! He is the one that is on-site and will be there. If you screw it up by doing something besides what he told you to do then your A$$...

I'm with BT on all points including the original call of the RV being the cause.

:cheers: yep lol

Not sure what the design temps are. Engineers are tight with their calcs. I tried to get the heat load out of them, they responded with " you don't need them".

Our frost line is at 18" thats a...

Thanks Eric it does help. The pipe is at 4' depth. They are concerned about the glycol/water at 32* freezing the ground and affecting the slab at that time. The point is really moot as we have...

We are looking at running our GLS & GLR under the building vs around the building. The engineer said that its ok as long as we insulate the pipe to keep the ground from freezing from low pipe temps....

Welcome pirate. Lots of good info here with good guys. I've seen the site grow from a 1 street town to a metropolis. lol I cant spell or type either and sometimes catch grief 4 it. just roll with it...

I'm with Bob on all points also.

IMO Sounds like the gas valve to me, as it is mechanical with an accent of pressure change( for lack of better explanation lol). Removing the cover eliminates the sound, their is a pressure...

A manual J load calc is what you want. The calculation takes the building structure and calculates your heat loss or heat gain. At the top of the page it says hvac calc in the blue banner. I believe...

:ditto: Another price check would be best.

:LOL:

If he knew you were going to replace the whole system when he did the furnace, then you guys should of replaced the coil also. If he has to tear the furnace back out again to replace the coil. Then...

That question is going to get answers accross the board.
Currently not enough info to give you input.

I like high efficency equipment matched indoor and outdoor.
If your just changing the...

You had a tech out? And Move the das is all he suggested?

Your going to have to get a tech out that knows what he's doing. Your system is running in heating mode if cold air is blowing out of the...

Tostaky go on line and google it, they will get you a ball park amount.

I have replaced whole units vs a compressor before that was just out of warranty. For the same cost as a compressor change...

I don't think he's laughing at you but, He obviously doesn't feel he made a mis-judgement enough to warrant fixing the situation.

My advise is just have someone else repair the unit, pay for it...

If you wait til the C model comes out in 2 months you'll get 3 extra zip-ties. Just kidding, I'm not sure when the C model comes out.

All the uv light issues I've seen are from bad installs.

I'm a Lennox dealer and you most likely get your Lennox parts cheaper than me. Closest warehouse is is 3 hours away, freight charges apply if I don't have it.

I agree 200%

Your enlish is god I have no problem with it.

I wonder how he is going to fix your warranty with Lennox?

No I dont think a 18 months is normal for a compressor to fail. It should be warranteed...

You have an expensive repair thats agood reaon to lie. In fact thats the #1 reason we get lied to.

i bought my nephew an expensive bicycle to do tricks on in the dirt. Well hes out just trashing...

I don't understand the claim.

Lennox is going to stand by the contractor. Why should they give away parts when its not taken care of.

Sounds like you have it going. Hope your installing it as per manufacture first then getting your measurements written down before making your changes. Otherwise your changes are just moot...

1) Probably when you call because that's why you have to call. So contact the warranty department, give them the information they need to look it up and go from their.
2) That is instruction when...

My vote goes to low propane level. Only because I had service calls within a week of each other with the same problem and same solution.

Let us know what you end up doing. I curious if the architech has a new line that we're not aware of.

Second tech is right. I entered you seial number and the following message came up.
Application Type
select
--- Select a Type ---Residential
*


Your Reference #

Unit...

Are they going to perform a load calc on your home. Unless your 2.5 ton was having a hard time keeping the area cool, you may only need a 2 ton vs a 3 ton. The return air maybe ok, .5 ton is 200 cfm....

I'm an "Official" Lennox dealer and I called them. They gave me the same info as you.

For whatever reason the techs from 2 companies wont warranty your compressor. Like I said in my first post....

Lennox says its a 2010 model with a 10 year compressor warranty and 5 year parts. Theirs no issue with your warranty or notes.

Post the model and serial number.

:nopity:

:LOL: Not funny except I've been there. Thats why he lies to you, comparing your income and his. He sees you working, he knows what you want. He knows you wont ask after he does the ol wage comp with...

I agree with Tin... And your worries are most likey not warranted. Your stat is set at what it is suppose to be, O.

In any senerio here the issue isn't the RV now. Its not going to shift by...

Thats what the install manual says.

The first week of March.

My diagnosis says a burning smell is most likely an object that is being heated up beyond a temperature it was designed to handle.
Call a tech.
:.02::censored: deleted

So your unit is a month old or 13 months old? Call your contractor, at a month their should not be a charge. Or take your option and freeze or choke to death.

I bought a used tundra, smelled...

2 techs have checked it. Sounds like a locked rotor.

My concern is tostaky. Your reversing valve is stuck? Or is it that you still have your stat set to B? If your stat is the reason, ask the...

http://www.docs.hvacpartners.com/idc/groups/public/documents/marketing/848-113-080199.pdf
Heres a carrier

Sounds like its going into defrost

Good post Skip.

I believe the max GPM is low at 2-3 gpm. Thats the only thing. If your washing clothes thats about all your going to do.

I see a difference though. The word "Where" is omitted from our code making the kitchen exhaust required here. Where IRC says if you have it.

Sorry was a .3 not .4
http://publicecodes.citation.com/icod/irc/2009/icod_irc_2009_15_sec003_par002.htm
M1503.3 Kitchen exhaust rates. Where domestic kitchen cooking appliances are equipped with...

Ours is modeled after the IRC

M1503.4 Domestic kitchen cooking appliances shall be equipped with ducted range hood or down draft and shall be sized IAW:

M1507.3 Minimum exhaust rate for...

Thanks :cheers:

Agreed