Search:

Type: Posts; User: kls-ccc

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    8
    Views
    226

    Did they run a room-by-room load calc on this...

    Did they run a room-by-room load calc on this house before sizing the system and duct work? I have a 33 x 30 room {round numbers} that doesn't have that much air going into it. This is not to say...
  2. Replies
    543
    Views
    7,812

    As I have said numerous times, I'm not from the...

    As I have said numerous times, I'm not from the south, never lived in the south, and really have no ties to the confederate flag itself pro or con.

    The point I keep trying to make is you can make...
  3. Replies
    8
    Views
    226

    My question has to be why 8" runs. I look at it...

    My question has to be why 8" runs. I look at it this way, if a room is big enough that it needs so much air it has to be supplied by an 8" run then it is probably big enough to use 2 - 6" runs and...
  4. Replies
    543
    Views
    7,812

    I'm just asking a question, but now that you ask...

    I'm just asking a question, but now that you ask it does bring up the point that if you want to use that flag you posted are you talking about going back to the values, morals, and ethics of the...
  5. Replies
    543
    Views
    7,812

    Why would you want to use the flag that only...

    Why would you want to use the flag that only represents the contiguous US not including Alaska and Hawaii? Or didn't anyone else notice this?
  6. Replies
    19
    Views
    268

    If you pull the blower wire and cond fan wire so...

    If you pull the blower wire and cond fan wire so neither fans will run then start the unit the pressures will have to change from lack of air flow both inside and out. High side will go up and low...
  7. Replies
    259
    Views
    17,930

    Don't know why it popped but it did. Went to...

    Don't know why it popped but it did. Went to this movie with my girlfriend, now wife. This was the only good part of the whole show.

    http://youtu.be/r6Jb2CA_xx8
  8. Replies
    872
    Views
    40,664

    That's the great thing about insurance . . . you...

    That's the great thing about insurance . . . you don't need it, until you need it.
  9. Replies
    170
    Views
    5,407

    Well his makes me feel good as this is what I...

    Well his makes me feel good as this is what I suggested back in post 32.
  10. Replies
    1,178
    Views
    130,641

    I wish I could tell you, I have not seen anything...

    I wish I could tell you, I have not seen anything like that with mine. Did you clear the user inputs before you started?
  11. Replies
    872
    Views
    40,664

    Where is it written that you can't turn it into...

    Where is it written that you can't turn it into your insurance yourself after you've paid the bill yourself? You just need to show the paid receipt to the insurance company so they don't send the...
  12. Replies
    41
    Views
    2,942

    Thinking about it I remember working on a install...

    Thinking about it I remember working on a install at a business with the plenum going up through the dropped ceiling T-bar. I noticed I would get a tingle every time my arm came across the edge of...
  13. Replies
    1,178
    Views
    130,641

    Jim, I don't want to let the cat out of the bag...

    Jim, I don't want to let the cat out of the bag so if you don't want to say on an open forum I understand but are there any plans in the works it add electrical probes to the system to get real time...
  14. Replies
    1,178
    Views
    130,641

    We do very in depth service agreement, check...

    We do very in depth service agreement, check everything on the system. Last year I was using a Cooper MFM 300, it worked well. This year I started out using 1 cooper then got smart and used 2 which...
  15. Replies
    226
    Views
    4,125

    No, he would look like your daughter. I'm...

    No, he would look like your daughter.

    I'm sorry that was out of line but I couldn't help myself.
  16. Replies
    1,178
    Views
    130,641

    I'm no expert, I'll leave that to Jim but I would...

    I'm no expert, I'll leave that to Jim but I would guess that that the system isn't getting profiled correctly.

    I've had one for almost 2 weeks now, the first day I wanted to throw it in the box...
  17. Replies
    41
    Views
    2,942

    I remember as a young tech, that was a long time...

    I remember as a young tech, that was a long time ago, I pulled the cover off a air handler and found one of the 240 V feed wires into the unit had welded itself to the cabinet and didn't trip the...
  18. Replies
    872
    Views
    40,664

    I guess that's the difference. It sounds like...

    I guess that's the difference. It sounds like you you know your going to get raped, just want to know who is going to do it, and the fact that they can change the deal any time they want cause you...
  19. Replies
    872
    Views
    40,664

    I ran into 2 different people that were so mad at...

    I ran into 2 different people that were so mad at MC, the problem is where else can they go?




    NOWHERE !!!!!!!!!!!!!!!!
    Wanted to let you think on that a minute.

    If we go to single payer...
  20. Replies
    259
    Views
    17,930

    Considering we have had over 90 degree temps with...

    Considering we have had over 90 degree temps with over 50%rh this seemed appropriate.

    http://youtu.be/C070_4ya98Y
  21. Replies
    543
    Views
    7,812

    I agree with you PHM but you left out 1 thing . ....

    I agree with you PHM but you left out 1 thing . . . TRUST. It's been going on for more than the last 6 years but it seems worse the last 6, how we are outright lied to. The bank bailout, Benghazi,...
  22. Replies
    543
    Views
    7,812

    Sounds like you got it. Don't you wish we were...

    Sounds like you got it. Don't you wish we were as smart as the negotiating team Obama set over there.

    I swear they all wear slip-ons because they aren't smart enough to tie regular shoes. I...
  23. Replies
    872
    Views
    40,664

    Gary, I can agree with most of what you said. I...

    Gary, I can agree with most of what you said. I especially agree with your point that most everyone is looking at it from a "What's best for me" attitude. I have tried to look at it from a what's...
  24. Replies
    543
    Views
    7,812

    Obama's the only guy I know that would have hard...

    Obama's the only guy I know that would have hard facts on a car dealership putting stickers on new cars 50% inflated pricing, go in and negotiate with the receptionist for 3 weeks on a price, give...
  25. Darrell, I don't know why they don't work on...

    Darrell, I don't know why they don't work on copper tubing but they aren't even close. I have been told that if you put tape on the tube and shot the tape it will be closes but I have never had...
  26. Replies
    1
    Views
    146

    Many ERV's have this feature built into them with...

    Many ERV's have this feature built into them with the wiring diagram in the instructions.
  27. Replies
    1,178
    Views
    130,641

    Jim, I will have a lot of learning to do on the...

    Jim, I will have a lot of learning to do on the iConnect. I have seen the benchmark feature but have not played with it to see how it works or what you do with it. I will be glad to share any and...
  28. The closet register,is usually the first one off...

    The closet register,is usually the first one off the duct or plenum, it has the least amount of duct/pipe on it. It also has the least amount of loss so it will be closest to coil temp.

    IR...
  29. It may be fine, it may need a tech. That type of...

    It may be fine, it may need a tech. That type of test doesn't tell you a lot, but it does give you an idea.

    First you want to check the closest supply register to the unit and only the register. ...
  30. Replies
    1,178
    Views
    130,641

    Jim, I have another question on a situation that...

    Jim, I have another question on a situation that has not come up yet but I'm sure it will soon. On Water Source Heat Pumps, since water is the medium used to either add or remove heat from the...
  31. Replies
    16
    Views
    792

    Let me ask you this question and then you can...

    Let me ask you this question and then you can answer your own.

    How do you lower a temperature below the medium used to cool it?
  32. Replies
    1,178
    Views
    130,641

    Jim, I bought a kit from Trutech Tools. It had...

    Jim, I bought a kit from Trutech Tools. It had the iConnect, HP probe, LP probe, 2-humidity probes, a temp/repeater probe and several wired sensors to plug into the probes. I normally use the...
  33. Replies
    25
    Views
    626

    It took a while for me to grasp how duct leakage...

    It took a while for me to grasp how duct leakage in a conditioned space is an issue but someone did finally get it through the titanium plate skull I have.
  34. Replies
    25
    Views
    626

    One other point to consider with the duct n the...

    One other point to consider with the duct n the conditioned space. In my neck of the woods most ductwork is in the basement which is not only conditioned but finished so the duct is covered by a...
  35. Replies
    1,178
    Views
    130,641

    Jim, I just got an iConnect last week. I have...

    Jim, I just got an iConnect last week. I have used it close to a dozen times and for the most part love it. I have noticed that I have an issue with probes dropping out. The first time I used it I...
  36. As others have said refrigerant doesn't go bad. ...

    As others have said refrigerant doesn't go bad. As far as weighing in the refrigerant, all the scales I have seen are temperamental, if they are not on a flat solid surface they are not accurate. ...
  37. Replies
    22
    Views
    678

    I have said this I think every time there is a...

    I have said this I think every time there is a thread about NATE. I have 9 certs, all of them have been renewed several times. Some on here say NATE is book smarts, I don't think most people use...
  38. Replies
    752
    Views
    25,419

    Assuming this is true then wouldn't the prudent...

    Assuming this is true then wouldn't the prudent thing to do be get as much global warming now that you can to take the edge off the mini ice age that's coming. You know if you start at 75 and drop...
  39. Replies
    240
    Views
    18,766

    So did you hear about in Oregon the state will...

    So did you hear about in Oregon the state will pay for kids as young as 15 to have a sex change operation without parental consent, and Medicaid will pay for it. Talk about sick and twisted.
  40. Replies
    543
    Views
    7,812

    Your excused!!!! And no, you weren't the...

    Your excused!!!!

    And no, you weren't the first on this thread to disagree, most thread don't go over 400 posts if everyone agrees.
  41. Replies
    543
    Views
    7,812

    I think it's a sad day in America today. Not...

    I think it's a sad day in America today. Not that a patch of red cloth with a blue X ans some stars came down, but that another american icon has bit the dust for no "good" reason. The scary thing...
  42. Replies
    543
    Views
    7,812

    I may be wrong here but it seems to me we were...

    I may be wrong here but it seems to me we were having a pretty civil dialog, then someone comes along talking about hate and what has been civil seems to have turned for the worst. But isn't that...
  43. We did that last election, voted in 3 new people...

    We did that last election, voted in 3 new people in 2 Rep, 1 Dem. All of them voted with Obama on the trade deal. Go figure.
  44. Replies
    543
    Views
    7,812

    The funny thing is we are suppose to be tolerant...

    The funny thing is we are suppose to be tolerant of others but for some reason that street only goes one way. What ever happened to if you don't like something just avoid it? A few people had...
  45. Replies
    170
    Views
    5,407

    If you are paying for the man. J I guess it's...

    If you are paying for the man. J I guess it's yours to do what you want with but if company A is doing it as part of their sales process please do not give it to the other company, let them do their...
  46. Replies
    543
    Views
    7,812

    Scroog, in general I would have to say I agree...

    Scroog, in general I would have to say I agree with you on this, I try not to purposely offend anyone. However in today's society you can offend someone for telling them their shoe is untied because...
  47. Replies
    35
    Views
    3,519

    I ordered a iConnect over the weekend, should...

    I ordered a iConnect over the weekend, should have it in a few days, I can't wait.
  48. Head on 410 at 100 will be in the 375 - 400...

    Head on 410 at 100 will be in the 375 - 400 range depending on surrounding conditions, sun, heat load inside, dirt on the coil. high suction pressure could be from a high load, bad compressor,...
  49. Replies
    4
    Views
    230

    deleted.

    deleted.
  50. Replies
    170
    Views
    5,407

    ! question, these blowers don't have ECM motors...

    ! question, these blowers don't have ECM motors on them do they? As I understand you can't tie 2 ECM motors on the same duct system or they fight each other.
Results 1 to 50 of 1000
Page 1 of 20 1 2 3 4

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Quality Home Comfort Awards