Search:

I use a pan under the unit with a cut-off switch too. It sounds like your drain may have been clogged from the older unit and not the new one. I've had this happen once before. Changed out the...

The louvered cabinet by far is better. It protects the coil from anything. If the cost is close, that should be the deciding factor. JMO

Go with the Trane. You will have less problems and it will last a lot longer for you too.

Sorry to inform you sir (or madam) but if your Gooooman unit hasn't been serviced in a few years, now is the perfect time. I have found that most if not all Goooman package unit heat exchangers...

Just be quick about it!!!:)

It appears that the spiral duct is not reduced after the registers. This will cause low static and make the supply air extremely slow, cold and cause unwanted condensation.

It's hard to tell...

Just like checking a 9v battery. If it don't tingle a little it's bad!!

I'm thinking he's restricted at the new drier. Not sure. He's going back this afternoon, maybe he left something out.

Do you think a bi-flow would blow the desiccant out?? I think they have screens to prevent just that??? IDK??

The extra water in the pan won't go away. The pan is designed to hold some water even after the unit shuts off.

First things first, open all the vents. Just cause you close some don't mean...

He said he put the filter in the discharge line. About a foot away from the compressor. Mufflers in the discharge is what you've been seeing. Not driers!

He definitely said discharge line.

Goodman 5 ton package str-8 air. My colleague changed the compressor out. (pins broke off in molded plug). He said he put a drier in the " discharge" line between the coil and compressor. Now he...

The drain needs to have a ptrap installed. The negative pressure on the drain will cause the air handler to hold water in and when it shuts off the water will rush down the drain. Sometimes...

Love my sman3 gauges!!!

Milwaukee is my choice. The M12 line is awesome! A charged battery lasts for a couple weeks and the drill itself has a battery life display. Makita don't have that.

So you got your universal EPA card.... And no one there or around you mentioned anything about 410-22 conversion??? Sorry, but this trade can't be taught from the yard sale. You need actual training...

So you must be an engineer? Lol

So why did your neighbor put in the last one??

Universal tech in what??

Yes, all of the units with small slabs in them have been leaking. And I haven't been able to get any labor or refer from them either.

Yep!

I can see the unit short cycling at 50 degrees. If its 50 in the house, then that's the temp of the air blowing over the heat exchanger. This low of a temp is likely to cool the chamber down...

A zone system would work fine. When only one zone calls the excess air recirculates through the bypass. This will cause the supply air to drop even lower and help the one zone to satisfy faster. ...

Ditto!!! The sman3 is my first set. No complaints.....yet. :)

They are used to evaporate condensate since they usually don't have open drains