Search:

Type: Posts; User: newyorkjets

Page 1 of 3 1 2 3

Search: Search took 0.01 seconds.

  1. Replies
    7
    Views
    301

    i did drop them into the bin to clean them. i...

    i did drop them into the bin to clean them. i used a clean rag with a allen key to wipe them off.
  2. Replies
    7
    Views
    301

    scottsman ice machine problem

    scottsman ice machine
    model # cme656ae-32a
    S# 121666-12b

    The controller reads full bin when there isn't a full bin. I cleaned the sensors and the unit would run for a few hours then reads full...
  3. Using A/C easy seal by nucalgon on a cap tube system

    I have a small prep table that has a leak that i cannot find. I have heard mixed feelings on using the a/c easy seal by nucalgon. Has anyone used this much? Had any problems afterwards? The system...
  4. pilot problems with and older gordon piatt burner

    we have been having problems with flame failure on an older gordon piatt burner for a boiler. there was a guy from my company there the other day that had adjusted the pilot pressure and air. i got...
  5. Replies
    6
    Views
    513

    hey appreciate the info. lol

    hey appreciate the info. lol
  6. Replies
    6
    Views
    513

    reznor direct fire make up air unit

    reznor
    m#RDF1-65

    I got this old make up air unit from 1986 that is having problems staying lit. I only had a few minutes to check it out today and have to return in the morning. no wiring...
  7. Replies
    1
    Views
    213

    dayton wall unit question

    I got a troubleshooting problem im a bit unsure about. The unit will call for heat. The pilot will light and when it goes to light the main burner the gas valve starts clicking and making noise...
  8. Replies
    4
    Views
    403

    figured it would be cheaper. how much does the...

    figured it would be cheaper. how much does the bosch run? i did find out that if you use a pump with the instant hot water heaters it voids the warranty... so thats out of the question
  9. Replies
    4
    Views
    403

    infloor radiant heat questions

    Can a instant hot water tank be used for infloor radiant heat?

    If so what brands and models do you suggest

    I havent done much infloor radiant heat so any suggestions would be appreciated.
  10. Replies
    7
    Views
    294

    done. thank you

    done. thank you
  11. Replies
    7
    Views
    294

    do you have a link for this design software?

    do you have a link for this design software?
  12. Replies
    7
    Views
    294

    infloor radiant heat question

    Im looking for some information on installing infloor radiant heat into floors joist spaces. Sizing of the lines, maximum lengths of runs... info like that. I havent ever installed just work on it...
  13. Replies
    1
    Views
    309

    hydronic heating question

    Im going to be installing an outdoor wood boiler in a friends house for heat but he doesnt want to have baseboard heat. So i suggested infloor radiant heat. For backup he still wants a forced air...
  14. Replies
    13
    Views
    682

    i have also ohmed out the windings of the...

    i have also ohmed out the windings of the compressor. I got 1.3 between each.
  15. Replies
    13
    Views
    682

    sorry should of given you guys some more info....

    sorry should of given you guys some more info. This is a data aire heat pump unit ( water cooled). Voltages and amp draws after replacing the fuses look good. Then after a day or so of running the...
  16. Replies
    13
    Views
    682

    problem with blowing fuses

    I have a problem with this unit blowing fuses. The fuses are in the compressor curcuit. The only two loads in the curcuit are the compressor and the crank case heater. The cch is wired off the...
  17. anyone have a troubleshooting manual for honeywell economizers??

    could use it for tomorrow if anyone does thanks
  18. Replies
    15
    Views
    675

    i guess im not sure how to message him lol

    i guess im not sure how to message him lol
  19. Replies
    15
    Views
    675

    it was wired the same as the other one and none...

    it was wired the same as the other one and none of the wiring was damaged.
  20. Replies
    15
    Views
    675

    the module in separate from the motor

    the module in separate from the motor
  21. Replies
    15
    Views
    675

    they seemed to work fine on the other rtu. then...

    they seemed to work fine on the other rtu. then when i put them in the rtu that was running in free cooling the unit continued to run in free cooling. Thats why i was confused... i didnt think there...
  22. Replies
    15
    Views
    675

    i swapped both parts from another rtu and had no...

    i swapped both parts from another rtu and had no luck
  23. Replies
    15
    Views
    675

    yes they did

    yes they did
  24. Replies
    15
    Views
    675

    carrier RTU aboiut 10 years old

    When i got on site the rtu was in free cooling mode. There was another identical unit near by. So i first swapped the enthalpy sensor... still ran in free cooling. Then i swapped the honeywell...
  25. Replies
    4
    Views
    373

    tripping on oil pressure

    I got a split system with a trane semi hermetic compressor. The model of the compressor is M# 2F5A58. When i got on site the compressor was tripped on oil pressure. Then I reset the switch and...
Results 1 to 25 of 52
Page 1 of 3 1 2 3
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event