Search:

Type: Posts; User: acg

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    23
    Views
    1,867

    Ben a long time I last posted , just wanted to...

    Ben a long time I last posted , just wanted to add my 2 cents. I all ways clean flame sensor at heat check out to prevent possible go back. Most of the older Rheem boards just needed 1.5 microamps...
  2. your probably moveing to much return air threw...

    your probably moveing to much return air threw grill , if blower cfm right you need larger or more return air grill or go with grill with larger opening on loovers.
  3. Replies
    9
    Views
    1,408

    If every thing is good with pilot flame check...

    If every thing is good with pilot flame check millivolts on thermopile disconnected-without
    load then connect and read millivolts with a load. It may be the safety part of the valve bad.
  4. Replies
    2
    Views
    454

    dont have my blue book with me to look it up but...

    dont have my blue book with me to look it up but if you get all the numbers off compressor and around the age then you could tell.
  5. Replies
    67
    Views
    4,438

    I wonder where the leak was? a rusted out drier...

    I wonder where the leak was? a rusted out drier ok replace it, but a leak in a evaporator
    coil thats 18 years old, unless its a distributer tube that rubbed on a turn bend a good clean braze , but a...
  6. Replies
    11
    Views
    6,509

    Hey! check out what btu capacity those...

    Hey! check out what btu capacity those compressors have on them, at least on the last version of the GSC you may be shocked.
  7. Get a heat load done on house so you know exactly...

    Get a heat load done on house so you know exactly what you need , before you get a a/c contractor to install it for you. Its not ilegal to install a 10 seer condenser just smarter to install new 13 +...
  8. Replies
    40
    Views
    3,312

    If ducts & system sized right most manufactures...

    If ducts & system sized right most manufactures count on running 1st stage longer to dehum but that dosnt allways work. T/stats that have d-hum opthion use an average of temps to display rh% and set...
  9. Replies
    8
    Views
    1,284

    you said solenoid in compressor 2 stage. If your...

    you said solenoid in compressor 2 stage. If your talking about the rectifier-solenoid on a scroll compressor it self verify, disconnect both 24 volt wires to it & see if it over amps or blows fuse...
  10. Thread: Hot on upper floor

    by acg
    Replies
    72
    Views
    6,252

    Find an A/C contractor that can size all your...

    Find an A/C contractor that can size all your supply and return ducts right for the upstairs and if your A/C system is sized right, and you have enough room at plenum also get a 2 zone damper system...
  11. Thread: filter grille size

    by acg
    Replies
    4
    Views
    743

    did you mean the discharge plenum ???

    did you mean the discharge plenum ???
  12. Thread: filter grille size

    by acg
    Replies
    4
    Views
    743

    residential around 160 sq " per ton for a filter...

    residential around 160 sq " per ton for a filter return grill, 80 sq" for a larger loovered one.
  13. Replies
    20
    Views
    1,414

    Heat load, need exp-tech to recheck for proper...

    Heat load, need exp-tech to recheck for proper refrigerant charge,air flow, air leaks,
    t/stat wireing and configuration. Also install humidistat to control the D-hum better.
  14. Replies
    19
    Views
    1,202

    The Lennox solar kit only produces 190 watts on a...

    The Lennox solar kit only produces 190 watts on a good sunny day. Its expensive to install solar power for your home , but I hear theres a device comeing out this year thats installed on new or...
  15. Thread: RUN CAPACITORS

    by acg
    Replies
    3
    Views
    540

    RUN CAPACITORS

    IM shure every ones had problems with run caps on all brands of equipment.
    Ive tried other replacements Global , mars etc. those brands continue to go out , Done ok with Turbo run caps. Can anyone...
  16. Replies
    415
    Views
    21,779

    I dont know what your average temp or load...

    I dont know what your average temp or load calculation is in your area. But if all has been done on my first statement then give some more feed back.
  17. Replies
    415
    Views
    21,779

    If heat load was done and correct find out if...

    If heat load was done and correct find out if they figured it just for 20*diff / ave 100* fig 80*/ 20* difference.
    If a/c operating correct & the right tonage.Concentrate on a flow hood test for the...
  18. Replies
    2
    Views
    1,016

    I went to visit my Dad in Hewitt / WACO TX. and...

    I went to visit my Dad in Hewitt / WACO TX. and looked at the system that had just been installed. The primary drain line wasnt insullated (thats not to complain about)but the vent pipe was two...
  19. Replies
    18
    Views
    1,763

    I would call a new a/c company just to do a good...

    I would call a new a/c company just to do a good electronic leak test of your system, and believe it or not
    I had a customer that had a R#22 leak problem & come to find out the neighbors kid was...
  20. Replies
    4
    Views
    1,559

    I dont have # handy it should be around 41,000...

    I dont have # handy it should be around 41,000 BTU
    3.5 ton 51 week of 1990
  21. Replies
    2
    Views
    1,004

    by code some inspectors would like to see a...

    by code some inspectors would like to see a return 10'from a fire place or wood burning stove.
  22. Replies
    21
    Views
    3,615

    Sorry drk I just heard the brush method didnt do...

    Sorry drk I just heard the brush method didnt do so well
    thats all.
  23. Replies
    21
    Views
    3,615

    Duct cleaning is good.If there is a mold problem...

    Duct cleaning is good.If there is a mold problem thers no cleaning to fix it ,repair air leaks,cut out the infected area and rebuild and or replace ducting.Most brush types of cleaning doesnt do so...
  24. Replies
    21
    Views
    3,615

    Without a doubt the very best method in the USA...

    Without a doubt the very best method in the USA does a lot
    better than the brush method. Call (210)732-9772 talk to Lee Haun you will profit from this Info.
  25. Thread: Need serious help

    by acg
    Replies
    23
    Views
    2,195

    I guess your right! why dont you just adapt a...

    I guess your right! why dont you just adapt a window a/c to
    use in your enclosure with a humidistat/stepdown tranaformer 24v to a 24v relay to drop fan speed down to
    help d-hum.
  26. Thread: Need serious help

    by acg
    Replies
    23
    Views
    2,195

    You can install panel mount units like what spint...

    You can install panel mount units like what spint uses on there wireless equipment,also what alot of electrical panels use to cool down there equipment.I just dont know who makes them????
  27. Thread: FORT WORTH RSES

    by acg
    Replies
    8
    Views
    871

    The RSES MEETING went well at the PLASA...

    The RSES MEETING went well at the PLASA HOTEL.Heat pump classes went well and demo on the new upgrades for low volt
    current protection-trouble shooting those shorts & easy way to install single...
  28. Replies
    19
    Views
    3,284

    The Tittan III is a good one.The Photo-Cat is...

    The Tittan III is a good one.The Photo-Cat is used to help slow down pollutants ect...and coated with Titania what makes white paints white!so it can reflect the UV light and rays better.The newer...
  29. Thread: RSES CONFERENCE

    by acg
    Replies
    8
    Views
    1,020

    On low voltage circuits. A new type of fuse that...

    On low voltage circuits. A new type of fuse that replaces all styles of fuses used on 40 va transformer systems,and a two wire tool that protects your controls that saves you time locating your...
  30. Thread: Zoned system

    by acg
    Replies
    6
    Views
    842

    room 5& 6 should have there own zoned damper also...

    room 5& 6 should have there own zoned damper also if needed a barometric damper to releave SP.
  31. Thread: Blown transformer

    by acg
    Replies
    21
    Views
    2,997

    Use the short-pro tool to locate 24 volt short it...

    Use the short-pro tool to locate 24 volt short it will protect your 24 volt circuits while you test, and after
    that install the resttable fuse.
  32. Thread: RSES CONFERENCE

    by acg
    Replies
    8
    Views
    1,020

    RSES

    I didnt know there was a fee, I was doing a demo at 10:15 am on the 12th on the new low voltage current protection
    and trouble shooting,also single phase voltage protection.
  33. Replies
    26
    Views
    4,938

    What kw heat srip did you have before?The...

    What kw heat srip did you have before?The refrigerant charge may need to be rechecked. And if the 3.5 ton evaporator coil is correct for the 2.5 ton heat pump
    you still may have to lower the blower...
  34. Thread: RSES CONFERENCE

    by acg
    Replies
    8
    Views
    1,020

    RSES DALLAS-FT WORTH CAPTER conference on March...

    RSES DALLAS-FT WORTH CAPTER conference on March 11&12- 2005
    will have Copeland,Sporlan,Lennox,Nu-Calgon,Trane....
    Also the newest upgrades on low voltage current protection.
    24 volt shorts and the...
  35. Thread: Ozone Generators

    by acg
    Replies
    11
    Views
    2,802

    The older type of ozone generators had some...

    The older type of ozone generators had some health issue problems, for sure.When the lungs take in an oxygen molecule your hemoglobin absorbs it and releases a carbon dioxide,
    but when O3 is...
  36. Thread: HVAC - GARAGE SALE

    by acg
    Replies
    1
    Views
    780

    A garage sale will be held saterday 2/5/2005...

    A garage sale will be held saterday 2/5/2005 located at
    5410 Jackwood Dr. San Antonio,Tx. 78238. Ladder racks ,
    office desks , metal shelves,pot-relays,pilots,fan/limits
    VANS! van seats!all offers...
  37. Replies
    25
    Views
    6,912

    You said it was new construction right? if you...

    You said it was new construction right? if you dont think its a power supply problem you must have a intermitent short. Check your ground voltage and locate that short pro tool & reset fuse at Insco....
  38. Replies
    25
    Views
    6,912

    yea chech the primary line voltage to transformer...

    yea chech the primary line voltage to transformer and wire in correct tap.you could be having inrushes of too much voltage blowing fuse. (power surge or spike) I recomend the short-pro-tool if...
  39. Replies
    12
    Views
    842

    E-mail me at dmitchell48@netzero.com Imin the...

    E-mail me at dmitchell48@netzero.com Imin the hvac Industry
    also getting my own products out now. Im interested in your idea and I have direct contact with a damper/zone
    manufacture and major...
  40. Thread: CALLBACK TROUBLE

    by acg
    Replies
    31
    Views
    2,423

    What city do you work in?

    What city do you work in?
Results 1 to 40 of 74
Page 1 of 2 1 2
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event