Search:

Good day to all. I hope the summer has been hot enough for you all. I am doing a rebuilt on a York YDTL-120. When I recovered the refrigerant from the unit there was water in the refrigerant(found...

Hvacr update your email and I'll send you one.

Hot-shot works the best. R409 was one of the first drop ins I've used both and by far hot-shot works best, lower discharge theps and lower discharge pressures.

Just work on my first style G. i like some on the changes. modbus communication from the VSD and the integration of the ACC board into the 2430 board should eliminate some of those com faults. (Like...

Thank I'll look into that.

I'm embarrest:o I don't get many requested for my picture:D:D Just kiddin I'll take some pics, of the compressor.

I emailed you what i found. You should be able to order through Baltimore parts.

I got a pretty good breakbown somewhere, ill look tonight. Not too much you can do to them in the field.

Yup!!! Slide valve it is,:( The slide valve rod is gone too.:eek: Does anyone have service bulliten sbc9908? already ordered part RCD suggested.

Should be here.http://www.trane.com/Commercial/LiteratureSearchList.aspx

Tried 1279s Idea, no luck:confused::(.Well recover refrigerant and tested solenoids, found the unload solenoid leaking so we both of them. Removed the oil supply line and the oil return line and...

What style of chiller, post Model# and post your email address on your profile and I'll see what I can get. If i don't have it I know 56 or K will.

Carrier M#23xl4343nd60 Ser#4996j55208 Chiller will not load up. After reading some old threads My best bet would be a leaking slide valve. I already ordered the load and unload solinoids. Called...

Bard makes a wall mount unit thats single phase, you might want to check with them.

Ya had this problem a few times. We found that if your short on charge the discharge gas will flow through the head master valve for extended periods of time causing the valve to seize in the bypass...

Now that's how you post!!!, short, conscience and to the point.

We install non fused disconnect after making sure your main breaker is properly rated, if not then a fused disconnect should be used. regardless if the drive likes it or not safety and code...

I know where your going with K. I have a big problem with post (almost always by newbies) That ask a question then have highly trained professionals (some factory trained)bend over backwards to try...

You might take this opportunity and sell them on a PM contract. then maybe you can work something out on the repair cost. Leasing ice makers can be very profitable.

From your post i'm assuming you took thoes reading when the drive was in the run state, If this is the case than your missing the ground on the VSD enable. En will go to ground when in the run state....

I think Sammy's concern is more for his reputation and cash flow than the fact that he's going to work harder while his help is on Vacation, and in a small town sometimes your reputation is your...

:o:o Ya I knew that!!!!:) But I though he was on restriction;)

Wow Thanks JJ, I would go as far as saying everyone that particpates in this forum is important....including yourself. As for your response I'm not sure what theses other guy are talking about, I...

Here in Texas everyone has a gun, Including our pets:D This cat can shoot a tic on a Bores bacfkside at 300 yards with the wind blowing 25mpr while eatin catnip. ya I like this site too, Just goes to...

I was talking about a Hatfield and McCoy feud. Or Mississippi and Alabama feud. None the less never mind.:o...Just my Alzheimer kicking in again.