Search:

Pull the charge and weigh it back in.Check that hgv is opening correctly,then check txv.Sounds like a charge issue.

I have a couple of their pizza ovens I clean and fix.Look tough when you first see them, but work just like any other oven.If you run into a old one that you can't find the conveyer motor for pm me I...

+1 on the red wings great boot you get what you pay for.They are a little stiff when new but once broke in ,wear like a pair of slippers!!!

I have the same question?? This is a big safety issue if it is done this way!!!
It is against code in my state. Car exhaust and other stuff can be pulled into the ducting and spread around the whole...

Have one customer that uses the outlet water from the water cooled ice machine to thaw sea food I DON'T EAT THERE!!

Fresh air is required by code in our state.Inspector needs to study up a little

Make sure you get the updated stuff, the old style didn't work to good:bump:

6yrs!! you are lucky

IMO money well spent not just in money saved long term, but comfort also!

Tried hotshot in several units a few years ago.IMO the head pressure was to high for my comfort when charged corectly.I have stayed with mp39 and never had a problem, less charge lower head pressure...

Have used this test many times after it was shown to me.Has allowed me several times to fix what others couldn't figure out.

I vote for the "manny". I have seen fewer problems with them long term.Both are good units with very few problems.I would mainly look for the one that you can get service and parts the easiest...

When I first started in refrigeration many years ago it was tough.Lost money for the first year on that side of the company,broke even second year.Made a little money by third year.It is a totally...

We always put ours on.But carry a bunch of service port caps with new gaskets.We always replace the cap when we connect to a system, they are cheap and save a lot of call backs.On the service valves...

Another one to look at.Sliped my mind hadn't had one go bad in a while.When I install remotes I put a shut off on both lines at the cond.
saves customer freon cost on a lot of repairs later down the...

TXV or weak compressor.Try to pump it down to check the compressor and if that checks out replace the txv.I have been having more txv's go bad in the last couple years than in the prior 10yrs.

Always empty it our health dept. requires it.

Nice job really cleaned everything up nice and neat.

It is really the new invisalineset you can't see them LOL.
wrong pic posted will get the one where they are hooked up.LOOONG Day when I posted the pics.

Thanks for the input that is why I like to post my work here.Pros pick out things that customers don't see,which makes me do a better job every time.I looked at the "HOLE" again and am going to try...

Drains do look a little up hill in the photo but do have a slight down hill slope to them I put a level on them to make sure.The hole in the wall I still have to shoot some foam in it and build a...

I wanted to use just 1 unit but customer did not want a big package unit sitting out back or the ducting going up the side of building.I have these wired on a 2 cool 3 heat tstat to bring them on in...

Twin system just done for a outdoor theme park

How long does it usually take after you send your info in to get approved?

Nice copper work, well laid out line sets