Search:

Agreed.

i

Would be safer on that application to just use the on/off pressure switch.

Just remember safety first and secondly it's all pensionable time. No need for speed!

What's the address and startup date, I want to see this!

Basically it boils down to each individual location and type of equipment that you are working on.

You must work mainly with residential or light commercial, trust me you require a pressure washer and Nu-Brite on some equipment. We have pressure washed some coils for 6 hrs and it was still coming...

It was engineered this way, they have a boiler plant don't know why they wouldn't have spec'ed a chiller.

I agree:cheers:

Will be doing another school in May some larger unit's from what I gather, will post some pic's from that job, hope I can make it look as good.

Yes it is an Engineered Air unit, and I appreciate the compliment, I believe this is the way we should all be doing our work nice and neat, most pipe fitter's can so why can't we. I think it give's...

Just used a soft 3/8 tube bender work's fine on hard drawn, after that size you pretty much have to use a hard drawn bender.

Very nice work.

Here's one, my company does not want us to put our time on the sheet so they can figure out what they want to bill the customer that day. And they asked the apprentice the other day to hold back some...

Oop's my mistake, just having lot's of issue's with current company I work for, they are just like the government.

We went thru this so our union got involved and said we would just park the tuck's at the shop everyday. This did not happen because it is not in the best interest for the customer's due to response...

Take a look at Thermalcare with the Turbocor, very nice unit you can also utilize an aircooled condensor if you want to get rid of the tower. I started 6 of these up last year all were on tower's.

Dude I don't know what you are looking at but there isn't any metal to metal contact and there isn't an issue with condensation, all the insulation was pulled up to the clamps and glued, these were...

We are 85 plus truck charge and we make 40.15 hr plus benefits, total package is in low 50$ range.

Yeh kinda suck's having to sell and not get compensated for it. These are tough times and owner's are tightening the purse string's big time. Time to start looking for that institutional job for 40...

If you can get into a union at least up here I have had the last 4 yrs over 90k. Average is about 75k for a slow yr.

That would be armaflex paint as requested by the engineer. Tis a bit messy. As to the configuration of the airhandler I can't remember the exact setup I only piped this, the manufacturer came in...

A little school job I did a couple of yrs. back.

So when I take that occasional 2hr lunch that I get payed for and I am with a potential new customer that's not ok. Maybe what some of the owner's need to understand is that on occasion we TECH's do...

I think this guy's got the right idea.:D