Type: Posts; User: blx1
Thanks, I did throw some new sensors at it since they were that 1.8k thermister.
I'm going to quote it keeping the 102-AX's and removing the 301's and 511. Can one of you send me the LNS plugin for the 102-AX? Thanks for all the help!
If I kept the vav controllers 102-ax's, could I do all the setup through the jace or would I need another software package to connect directly if I had issues with a vav? My goal is...
We are currently exploring options with the customer on the integration or start all over. This is a very good customer of ours and we service several of their buildings and don't want to head down...
Not sure, how can I tell?
I have a TAC project that I would like to integrate to. They have a Xenta 511 controlling 8 RTU's with 301's and 37 VAV's with 102-AX. Has anyone done a successful AX integration to these products?...
hvac69 - not sure how they have the drive in hand mode since they only have told us about the issue. They have to continuously cycle the unit on and off until the unit will eventually build enough...
We just took over a building that has three York Millennium model #Z22AS22Q1CBSAK RTU's and they keep locking out on fan fail on start up. They have factory VFD's and can't build enough static...
Looking for a manual on the JCI M5 Workstation Software. Trying to figure out how to add new points in a DX9100 to the graphic.
My email information is in my profile. I would a greatly appreciate any information you can send my way.
Do you have any manuals?
Does anyone have any programming manuals on a 7718? Does it require special software to do the programming. They have the INET 7 workstation onsite but not sure if you can do programming through...
I have a client that has CSI in one of his building and would like us to service the building. Does anyone have any information on the following controllers?
I/NET (Seven) Release 2.13...
I'm looking for Distech Visio templates and associated wiring details.
Thanks for sharing your library!!
Does anyone have links or stencils they are willing to share with me?
Does anyone know of a good third party package to do controls drawings and has a good library of equipment?
Who can you purchase this programming software through?
Is it possible to purchase the ALC programming software?