Type: Posts; User: fix_it_dude
Search took 0.01 seconds.
Dude Only 15%
Yes yes flux - Staybrite a must.
Dude, it's R410a not R22.
Check your pressures, it's low.
Like the other Guys said use PT chart and check it and charge it properly.
Never done that dude.
But it Should work, the only problem is access for service and cleaning .
But do things right man for you or for the next person. Replace the unit . lol
that York product is the same as a Coleman . And I do mean the same.
So what ever you think about the Coleman , well that's what it is. Lol
I'll go with something better.
I never have use 414- I use 409 for a replacement.
Yep different oil different metering device.
My question to you. is did you get the job inspected by the county and was that the only way to run the ducts.
A tip for you and all who reads this, always get at lease three estimates.
If that's a new system and charge with freon it's 410a.
All r22 new system have nitrogen so make sure.
Note at lease that's what I have seen in Florida. No more pre-charge r22 units.
I going back to check on the unit vfd get back to you guys later dude thanks.
Live and work in Florida (Thank GOD)
Never had to work on equipment where outside temps drop below 32F.
But it sounds like the unit is tripping on a safty switch. low/high or stat.
I just would like to know, what will cause a clicking noise like a relay clicks.
on a vfd cutlar hammer 9000.
drives works on hand not auto.
checked out motor and lines and voltages. all is...
To your question
answer: anything with a remote sensor will work.:D
Hey Rebate Reviewer DUDE
Duuude Relax man take it easy dude :D
dude just do like you say
get a temp split (delta T)
see if is cooling at all man and talk to the customer that helps. and...
hey what does chapeloaks mean?
in the shade takes my vote.
but make sure trees or anything else covers the unit.
Hey AGi Dude
have you tried anything?
The time delay relay is to make sure you compressor is not restarting if their was a power failure. (you know when the lights turn off and on...
on that picture shown
the cover shows a white sticker or label on the inside.
by chance see if their is any info there.
address,state company etc...
question - do you need...
in my opinion
don't like it and wouldn't use it, at lease not all around as the main duct insulator. (I'm talking about foil bubble wrap.)
I have seen it once for repairs and i still...
you just may need a start kit
or better fuses (time-delay fuses)
or a time delay relay
Hey wefix Dude or Dudes
Don't for get to make sure the blower is rotating in the right direction.
_tip of the day___________________no charge:D
Hey Dude or Dudes = WEfix
seen it - done it ...
Now your talking Dude :)
sure Dude, in no time you'll be chilling :D:rolleyes:
gcandrews I agree with ckone180 dude.
where he said (poor airflow, maybe a design issue)
gcandrews dude, design issue could be under size unit or duct.
seen home owners connected new flex...
need more info
has this always been that way - meaning from day 1?
is their enough air flow ?
was it size properly ? (ducts,units)
Do call a tech.
but I'll give it a shot.
Hey Dan of sw fl
no offense dude
but I think that he live in Canada :D