Search:

Type: Posts; User: chloeourdog

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Woke up to yet another System Malfunction. ...

    Woke up to yet another System Malfunction. Pattern is always the same - multiple inducer faults, then active limit faults, then system locks into high heat only with message on the Infinity Control....
  2. Carrier Infinity 58MVC - system malfunction

    Update: After 67 more inducer faults and 3 limit faults (locked furnace to high stage)...

    HVAC Company installed concentric vent kit (I paid labor and parts). The original flue vent had a 180...
  3. Dougfamous - I'll have our HVAC tech inquire -...

    Dougfamous - I'll have our HVAC tech inquire - hopefully they can figure out the inducer fault issue too. Thanks for the info!

    As for the setting - watched the tech set the dip settings and reset...
  4. Recent update: the inducer faults did return -...

    Recent update: the inducer faults did return - have 56 recorded since last week. 1 limit fault. HVAC company is going to investigate the flue next - they are currently adding supply ducts to our...
  5. Update - HVAC technician recommended having...

    Update -

    HVAC technician recommended having the furnace circuit breaker (in our house breaker panel box) replaced. This appears to have fixed the problem - we have not had a single fault since...
  6. Carrier Infinity 58MVC - system malfunction

    Another system malfunction last night with a bunch of inducer faults and limit faults resulting in high stage only operating. The increase in airflow did not prevent the faults from appearing. ...
  7. I'll have our HVAC technician verify the...

    I'll have our HVAC technician verify the switches. Thanks!




    Sent from my iPhone using Tapatalk
  8. HVAC technician removed all of the condensate...

    HVAC technician removed all of the condensate drain piping, ran water through to rinse it and cleaned the trap, checked all of the vent hoses, and set the furnace to the efficiency mode instead of...
  9. I'll be having our HVAC technician return - I'll...

    I'll be having our HVAC technician return - I'll post back what he discovers - this is a real challenge.

    So far - HVAC company will install 2" flue if I want them to (I will pay cost as I would...
  10. Hurtinhvac, The furnace is generating the...

    Hurtinhvac,

    The furnace is generating the errors according to the service technician. He stated that he could swap my two Infinity Thermostats and the errors would stay with the furnace, not the...
  11. Got a limit fault (code 33) this morning. There...

    Got a limit fault (code 33) this morning. There is definitely something going on .... the HVAC technician did test the pressure switches yesterday and showed me that there are no restrictions in the...
  12. Carrier Infinity 58MVC - system malfunction

    HVAC company that installed the unit replaced the inducer and limit switch today. BTW I had 60+ inducer faults codes. And another couple of low stage limit faults.

    Now since about 5:30pm, I...
  13. HVAC installer is coming today to replace the...

    HVAC installer is coming today to replace the limit switch and inducer. Carrier seems to think the inducer is malfunctioning causing the low-stage overheat problem. Since the problem did not show...
  14. Spoke to our installer yesterday - he stated that...

    Spoke to our installer yesterday - he stated that the Infinity controller was set to Low Heat Rise = On - that should take care of the bypass humidifier. He had me verify that over the phone.

    He...
  15. Markwolf, rafterrat and hurtinhvac - thank you...

    Markwolf, rafterrat and hurtinhvac - thank you all for your help! Everything you mentioned would explain why my 58MVC is having problems. Running in low stage with the flue pipe in a different...
  16. Forgot to mention - system is NOT zoned.

    Forgot to mention - system is NOT zoned.
  17. From the installation manual .... Sounds like...

    From the installation manual ....

    Sounds like I should discuss having our HVAC company abandon the 3" roof flue and have them install a 2" pvc pipe (for the flue) next to the 2" cumbustion intake...
  18. Carrier Infinity 58MVC - system malfunction

    I will talk to our HVAC company technician about the flue - some of the suggestions point to deficiencies there.
  19. Markwolf, The humidifier is controlled by the...

    Markwolf,

    The humidifier is controlled by the infinity system.

    The intake pipe was added when the furnace was installed. It takes air from a pipe located here:471991




    Sent from my...
  20. Here is a link to what the inducer sounds like: ...

    Here is a link to what the inducer sounds like:

    http://youtu.be/GcUD14m3QUk


    Sent from my iPhone using Tapatalk
  21. 471411471421471431471441471451471461 I just...

    471411471421471431471441471451471461

    I just noticed the flue pipe is close to the wall/roof with some discoloring of the Facia. The radon pipe is the one with the two 90's. Flue pipe come...
  22. Hurtinhvac - thanks for the suggestions. I paid...

    Hurtinhvac - thanks for the suggestions. I paid the tech for the original visit (even though he did not want to charge me) and I fully intend to pay for troubleshooting. The installing company does...
  23. Yesterday the furnace registered another code 33...

    Yesterday the furnace registered another code 33 limit fault. It was at 1:15am on a very cold morning (about 5 degrees outside). I keep the thermostat held to 72 degrees 24/7. The thermostat did...
  24. Tech came out two weeks ago and checked the...

    Tech came out two weeks ago and checked the codes. He also performed electrical checks on inducer, limit(s) and a few other things. He reset the system andthe system works like it should (3 stages...
  25. Filter is replaced once a month - and we don't...

    Filter is replaced once a month - and we don't use pleated ones. I made sure the registers were open. Each room has a large return near the ceiling, so no blockages. Tomorrow the company that...
Results 1 to 25 of 93
Page 1 of 4 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event