Type: Posts; User: Ctl-fool
Any chance someone could send me the lonHoneywellAxWizards jar file to? :putergreet:
If soneone could send me the jar file, I'd appreciate it. :putergreet:
any chance I could get those reference manuals? Need some more late-night reading material. :eek2:
You should have a VAV calibrate schedule that I believe opens and closes the air valve and water valve during this recalibration.
I'm pretty sure the calibration drives both valves closed and then...
Does anyone know of an easy way to globally force Trane VAV UCMs on a summit network to drive all the reheat valves open? I know there is a check box setting on one of the UCM tab pages in UCM...
Any chance I could get the apogee insight users manual? email is in profile.
would greatly appreciate it.:angel:
any 0-10v inputs on this controller? Heard of ahu controllers resetting if the input goes over the 10vdc limit.
Anyone seen anything new on this? Hardware components/IT requirements/interfaces for 3rd parties?
Just wire +/- to +/-. I think Ive done that for an FX60 once and it worked.:putergreet:
Interesting....id suspect that there has to be some software separation that differentiates webctrl from i-vu. I cant imagine that they would allow for ALC ifos/branches and Ivu dealers to go...
Anyone familiar enough with both to say what the main differences are? I-vu speaks CCN for the legacy controllers, and Bacnet with the Open controllers, the pretty much look like the ALC stuff...
Am looking for an older piece of ALC equipment to do CMnet to Bacnet, the Portal module which used the older exec 4 or exec 6 firmware.
Anyone have one of these lying around?
too bad....RZ had an interesting product, with alot of 3rd party drivers for legacy integration.
So, this is the death of Richards-zeta/cisco, or will RZ be spun back off into a seperate company?
Yup, I know we could keep the bmtw to use as a gateway, just looking at options should we want to take the bcu out. currently the bcu has 1 comm2 (red) for centravac, 1comm3(red) for VAVI, 1comm3...
Anyone know of a prtocol gateway available for the old Trave VAVI ucm's
Here was an interesting situation I ran into recently:
ALC module (ME Controller) using its 0-10vdc analog output to another ALC (OEM I/O Zone controller) analog input set at 0-5v at In1. Both...
Any new reviews on this yet? How does it compare with Ax or Struxureware?
anyone know if a non-jci workbench laptop will work on an FX-60?
this file still avail? Cant find it on the site - anyone have it?
any hint on the "secret code" thingy?:censored:
I am pretty sure that Belimo still makes an actuator that has a 0-20 phase cut signal. Simplest would be to just use the phase cut signal as is and wire same.
Or you could just change out the...
Since he referred to a "UNC" instead of an ENC, I think he may be referring to R2, not Ax (Schneider/TAC):.02:. I think it still can be done, though.
Have a site with the following:
1 DX with Xt, 1 AHU01, and 1 UNT. Could your new device work with these?
Any chance you could send me a beta module to try out?
Found this on the web. Hope it helps.