Search:

Type: Posts; User: frigeman

Page 1 of 3 1 2 3

Search: Search took 0.01 seconds.

  1. Replies
    42
    Views
    2,064

    Sorry sloppyjoe1 its 4-5 lbs when started at room...

    Sorry sloppyjoe1 its 4-5 lbs when started at room temp. 9-10- lbs back pressure is a overcharge. This is what I do. Best procedure is to charge with a charge cylinder by ounces then walk away.
  2. Replies
    8
    Views
    823

    It would trend too drop back into start as the...

    It would trend too drop back into start as the run contact amps are not high enough to hold it in run.
  3. Replies
    4
    Views
    501

    The rc series of relays are known compressor...

    The rc series of relays are known compressor killers. Get the right relay and check the run cap if so equipped. If it still wont start its a bad compressor.
  4. Replies
    34
    Views
    1,572

    If your readings are correct and you tapped it...

    If your readings are correct and you tapped it properly it would be a inefficient compressor.
  5. Replies
    8
    Views
    722

    Sounds to me like you have a restriction-Thats...

    Sounds to me like you have a restriction-Thats why the compressor would not start-It had not unloaded-The ice on the liquid line at the cap tube is a clue. Normally there is a dryer just ahead of...
  6. Replies
    52
    Views
    9,050

    I used it one time. Installed per manufactures...

    I used it one time. Installed per manufactures instructions. In 3 days the compressor was locked up-never again. :gah:
  7. Replies
    2
    Views
    1,120

    In domestic there is a oven sensor that cycles...

    In domestic there is a oven sensor that cycles the tempature. If there is one it would be suspect. Get the owners manual or service manual, it will tell you the failure per defect code. If those are...
  8. Replies
    5
    Views
    948

    I give her kuddos for having the grit to be a...

    I give her kuddos for having the grit to be a female tech. No problem there. Its just that the encounters they showed is nothing like it is in the real world.

    For instance after replacing a oven...
  9. Thread: Freon

    by frigeman
    Replies
    29
    Views
    4,723

    The original Hot Shot had propane in it and was...

    The original Hot Shot had propane in it and was not to be used in automotive air conditioning.
    They have since removed it from the formula.
  10. Replies
    5
    Views
    948

    The appliance Tech called the oven sensor a...

    The appliance Tech called the oven sensor a thermostat. The sensor was prehung for her. Checked the old sensor after replacing it. I was not impressed. The whole segment seemed too be a lot of fluff...
  11. Replies
    27
    Views
    2,012

    Short simple advice from a old timer. The...

    Short simple advice from a old timer.


    The only washer I would buy for my own use is a whirlpool top loading washer.

    :grin2:
  12. Replies
    22
    Views
    4,089

    X2

    X2
  13. Replies
    13
    Views
    1,248

    Electronics and household refrigerators have not...

    Electronics and household refrigerators have not been a good marriage. The high cost of electronic componrents just to see if you need another has ruined a once profitable business. Consumers are...
  14. Replies
    22
    Views
    1,583

    I had a customer ask how much my service call was...

    I had a customer ask how much my service call was so I told her. She then said if you can get here today and gaurantee me that you can fix it for the cost of the call come on out. Told her I did not...
  15. Replies
    5
    Views
    729

    Nothing goes in a refrigeration system except...

    Nothing goes in a refrigeration system except refrigerant and oil. There are many horror storys here about the use of leak stop products. Find the leak and fix it period.




    :CU:
  16. Replies
    42
    Views
    4,025

    Run

    Run
  17. I do beleive that is the worst I have seen...

    I do beleive that is the worst I have seen here-go figure
  18. Replies
    47
    Views
    7,520

    Try This

    Try This
  19. Replies
    20
    Views
    2,359

    Thats ugly-I wouldnt do that even with your...

    Thats ugly-I wouldnt do that even with your tools.


    Good finished product
  20. Replies
    31
    Views
    6,515

    What were they thinking? :oops:

    What were they thinking?





    :oops:
  21. Replies
    4
    Views
    1,780

    Thats a older model. The defriost timer is behind...

    Thats a older model. The defriost timer is behind the light sheild on the RH side of the food section top back.

    It is a mechanical 4 wire timer and not electronic-It defrosts for 21 minutes every...
  22. Replies
    4
    Views
    1,780

    Thats not a complete model number. If its under...

    Thats not a complete model number. If its under 10 years old its under the control panel where the lights are in the food section top. Its electronic and is in the RR area in a white plastic box.

    ...
  23. Replies
    14
    Views
    1,470

    Did you get this fingured? Post up the progress...

    Did you get this fingured? Post up the progress and we will play with it some more.
  24. Replies
    14
    Views
    1,470

    This model has a mechanical damper that controls...

    This model has a mechanical damper that controls the air flow from the freezer. Based on the info you have given me then there has to be ice in that duct blocking the air flow from a stopped up...
  25. Replies
    14
    Views
    1,470

    Moisture in the mullion and top panel area...

    Moisture in the mullion and top panel area indicates a ice build up in the freezer-Either failing to defrost or defrost water not draining. Either way it is a freezer problem.

    Most modern...
  26. Replies
    14
    Views
    1,470

    The primary reason for a poor food section...

    The primary reason for a poor food section tempature is the freezer evaporator is blocked or partially blocked with a ice build up from a defrost failure.

    Take the freezer section tempature if it...
  27. Replies
    25
    Views
    1,318

    Some people try to raise themselves up by tearing...

    Some people try to raise themselves up by tearing other people down - It seldom works except in the reverse.

    Good post
  28. Replies
    12
    Views
    2,396

    You wont be in over your head the board is on the...

    You wont be in over your head the board is on the cabinet back under a removable cover that has 1/4 in hex headed screws in it. Then its just snap on spacer mounted with a screw on the ground wire...
  29. Replies
    12
    Views
    2,396

    You can find the info you need at...

    You can find the info you need at
    www.appliance.junk.com

    They have service manuals you can download(keep the motor)
  30. Replies
    12
    Views
    2,396

    It will be the board. We have had several that...

    It will be the board. We have had several that when the fan motor goes bad it also knocks out the board.

    Try explaining that to the customer.


    :)
  31. Replies
    64
    Views
    2,241

    We need to give our President a chance to do the...

    We need to give our President a chance to do the job we hired him to do. I dont see many conservatives doing that.

    Our country gave GWB 8 years. Look what he done with it.


    Got us in a never...
  32. Replies
    19
    Views
    1,010

    Or give him a chance to to the job that by...

    Or give him a chance to to the job that by popular vote we hired him to do.

    After 8 years of Bush you conservatives amaze me.


    Its going to take more then 3 months to undo the damage that 8...
  33. Replies
    312
    Views
    10,088

    Your avatar is a little out dated - Here use this...

    Your avatar is a little out dated - Here use this one if you wanna


    :)
  34. Replies
    312
    Views
    10,088

    A good answer here would be at least we agree:) ...

    A good answer here would be at least we agree:)

    I do not care for some of the programs our new leader has put forward. Like all Americans I know were in a fix and something needs to be done. What...
  35. Replies
    312
    Views
    10,088

    Does anybody have a solution to the current...

    Does anybody have a solution to the current crisis? I did not see one from the previous administration unless it was cut the taxes on the wealthy, deregulate big business and let it trickle down to...
  36. Thread: What Crack?

    by frigeman
    Replies
    5
    Views
    1,407

    Looks normal for a property owner.

    Looks normal for a property owner.
  37. Replies
    6
    Views
    2,302

    The Trane That Did

    Work for 17 years with no PMs.

    Ill bet this owner buys a new car and never changes the oil until it quits.

    460 lbs head 98 pounds suction and not cooling.

    Sometimes I just shake my head.
  38. Got any photos of the units and a coil? Also...

    Got any photos of the units and a coil?


    Also how much for just a condensing unit-Are they 10 or13 seer?
  39. Replies
    3
    Views
    577

    You can find em at thrift stores. Someone is...

    You can find em at thrift stores. Someone is always donating one. They can be bought quite reasonably.

    Your welcome.

    :D
  40. Replies
    15
    Views
    25,820

    Outside temp is 10F. I wonder-Aw someone else...

    Outside temp is 10F. I wonder-Aw someone else tell him.
    :D
  41. Replies
    15
    Views
    936

    -5 NW Mo :)

    -5 NW Mo


    :)
  42. Replies
    43
    Views
    9,584

    Amazing-I do beleive that is the best one i have...

    Amazing-I do beleive that is the best one i have seen.

    Idiots


    :D
  43. Replies
    13
    Views
    3,395

    Good Job :)

    Good Job

    :)
  44. Replies
    6
    Views
    1,935

    Looks like he knew what he had to do. :)

    Looks like he knew what he had to do.



    :)
  45. Replies
    21
    Views
    1,684

    The largest single problem we have with houshold...

    The largest single problem we have with houshold refrigerators is they fail to defrost. When that happens the evaporator is blocked up with ice it is 15-20 degrees in the freezer and 50-60 degrees in...
  46. Replies
    14
    Views
    3,617

    Makes me wonder how some people survive.

    Makes me wonder how some people survive.
  47. Thread: Toyota Tundra

    by frigeman
    Replies
    42
    Views
    2,613

    Your right we have a Ford and a GM assembly plant...

    Your right we have a Ford and a GM assembly plant in our area.
  48. Replies
    22
    Views
    1,468

    Yes it is :D

    Yes it is



    :D
  49. Thread: SUPER SEAL!!!

    by frigeman
    Replies
    115
    Views
    51,269

    In my opinion this is not good stuff. The one...

    In my opinion this is not good stuff. The one unit the customer ask me to put in seized up(locked compressor) within 24 hours.

    How they get by selling it at $50 a can and telling you it works is...
  50. Replies
    18
    Views
    1,295

    I have some first hand exsperience with them ...

    I have some first hand exsperience with them

    The main problem is that their allegience is first to their religion and to their immediate family.

    They may immigrate to our country and become...
Results 1 to 50 of 149
Page 1 of 3 1 2 3
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event