Search:

Type: Posts; User: mud

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    10
    Views
    502

    The capillary tube is usually soldered to suction...

    The capillary tube is usually soldered to suction line. That is the heat exchanger referred to


    Sent from my iPhone using Tapatalk
  2. Replies
    5
    Views
    267

    I know we had a machine on start up with with a...

    I know we had a machine on start up with with a couple issues one being a hot gas valve. That machine could not be put in manual harvest and the board was replaced per tech support


    Sent from my...
  3. Thread: Nest

    by mud
    Replies
    18
    Views
    1,247

    Nest

    I had one short out as well. Customer had installed it a week earlier. Short outside by the condenser caused the thermostat not to power up the O terminal. Unit had been working properly until they...
  4. Replies
    7
    Views
    759

    Well the performance sheet at the highest (140...

    Well the performance sheet at the highest (140 cond 15 evap) shows 6.7 amps so I wouldn't think it should open at 6.2 unless there is alot of heat or it is weak. And if it is running at those...
  5. Thread: Trane RTU

    by mud
    Replies
    15
    Views
    977

    And once upon a time didn't Trane want there info...

    And once upon a time didn't Trane want there info taken off the site. Saves some trouble sharing outside the open areas. Just sayin!
  6. Replies
    10
    Views
    1,017

    I've only had one unit that busted a pilot tube...

    I've only had one unit that busted a pilot tube more than once. 2 times within a couple months or something like that. I went out to do the 2nd and found poor connection causing a chatter. Can't...
  7. Replies
    17
    Views
    1,708

    I'm always willing to help someone learn. I'll...

    I'm always willing to help someone learn. I'll part with a brand new 1/2hp for $6000.
  8. Replies
    12
    Views
    5,406

    http://www.trane.com/Residential/Products/Packaged...

    http://www.trane.com/Residential/Products/Packaged-Units/XL16c-Heat-Pump-Packaged

    here's a 16 SEER resi unit
  9. Thread: Music sites

    by mud
    Replies
    9
    Views
    546

    Assuming it was a typo DRM digital rights...

    Assuming it was a typo DRM digital rights management

    http://en.wikipedia.org/wiki/Digital_rights_management
  10. Replies
    7
    Views
    887

    forgot the .com that time ...

    forgot the .com that time

    http://www.hvacrinfo.com/Tecumseh_bulletins/model.pdf
  11. Replies
    16
    Views
    2,507

    To check for hot water entering the machine due...

    To check for hot water entering the machine due to bad mixing valve I've always just made a point to be there 1st thing with whoever unlocks the place to make sure its not getting hot water then....
  12. Replies
    2
    Views
    683

    The slaves just wont have a temp control and...

    The slaves just wont have a temp control and solenoid. If I understand correctly all 3 evaps are in 1 box. If that is the case they should all have heaters.
  13. Replies
    12
    Views
    773

    Your looking for 60hz equipment?? Found a Fujitsu...

    Your looking for 60hz equipment?? Found a Fujitsu distributor in the UK but the specs I saw was 230v 50hz
  14. Replies
    10
    Views
    2,822

    I remember being told those danfoss valves don't...

    I remember being told those danfoss valves don't need to be wrapped and being able to grab one right after brazing cause it didn't absorb the heat. As far as nitrogen though purge purge purge! Just...
  15. Thread: Help locating part

    by mud
    Replies
    41
    Views
    3,016

    I helped lead someone to a motor that showed up...

    I helped lead someone to a motor that showed up in the shop Thursday. But that guy didn't get fired up when I said we don't normally sell just parts. He was cool about it which made me check it out...
  16. Replies
    6
    Views
    547

    If I understand correctly there is just no wall,...

    If I understand correctly there is just no wall, ceiling, or floor space available for ducts. But if the space is available to mount equipment ductless split may be the way to go. Would not be...
  17. Thread: Help locating part

    by mud
    Replies
    41
    Views
    3,016

    Oh you've heard that too? Anybody else? ::DD:

    Oh you've heard that too? Anybody else? ::DD:
  18. Thread: Help locating part

    by mud
    Replies
    41
    Views
    3,016

    You asked a question and got 1 simple response...

    You asked a question and got 1 simple response that was in no way rude, nasty or out of line. The comment was simply this is not a diy site. After that you showed some attitude and got it back.
    Now...
  19. Replies
    75
    Views
    5,347

    If I suspect a float sticking but working ok when...

    If I suspect a float sticking but working ok when on site I'll cycle the float manually like 100-150 times rapidly and check continuity. Have caught a few that way over the years.
  20. Thread: Help locating part

    by mud
    Replies
    41
    Views
    3,016

    Not always! Had a tough one that took that took...

    Not always! Had a tough one that took that took 10 or 11 seconds the other day. Did I do good though only charged the customer $1.50. I rounded it up to 1 minute because they took awhile to answer...
  21. Thread: Pump Power usage??

    by mud
    Replies
    4
    Views
    427

    my first thought would be kwh is how you pay your...

    my first thought would be kwh is how you pay your bill and so watts should be the same and not much difference in the bill. With that being said I agree the numbers don't make sense. Also not sure if...
  22. Can't speak for other brands but the Fujitsus we...

    Can't speak for other brands but the Fujitsus we have installed have been very reliable.
  23. Replies
    18
    Views
    2,781

    My first thought was crackheads will still get...

    My first thought was crackheads will still get it. They'll just see it from farther.
  24. Replies
    24
    Views
    3,391

    because sometimes as mentioned there are regular...

    because sometimes as mentioned there are regular driers with check valves. Flow is through 1 drier for heating and 1 for cooling
  25. Thread: Frozen up

    by mud
    Replies
    12
    Views
    2,400

    Had one recently they wired 115v heater from #4...

    Had one recently they wired 115v heater from #4 to ground. Noticed it when it went into defrost the fans stayed on real slow.
Results 1 to 25 of 198
Page 1 of 8 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event