Search:

Type: Posts; User: Hwolfe

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. IMO. I would give the customer price of repair...

    IMO. I would give the customer price of repair and replace. It's the customers money and its there decision to spend it not mine. Personally I would repair over replace considering that the older...
  2. Replies
    6
    Views
    1,471

    Customer smelled smoke

    389921
    Some other company told her to turn the breakers off and wait till Monday. I got get cooling but had to wait on parts for heating side before I go back and require the system.
  3. Replies
    2
    Views
    1,235

    Check this gas line out.

    389901389911
    Hope there's not a gas leak. I'm sure it tee's in there and goes to the hot water heater.
  4. Thread: Contractors

    by Hwolfe
    Replies
    36
    Views
    4,083

    There's no crank case heater in this Rheem. I...

    There's no crank case heater in this Rheem. I know some of them do have two pole contacters. So I looked over the schematic before I replaced it with a single pole. Schematic shows a single pole....
  5. Thread: Contractors

    by Hwolfe
    Replies
    36
    Views
    4,083

    Contractors

    Found this today. I'm guessing the guy thought he had to have a single pole contactor. 381671
  6. I agree with the other guys. But it could also be...

    I agree with the other guys. But it could also be possible that his hoses on his gauges do not have a good seal or could be leaking.
  7. Replies
    9
    Views
    818

    My parents converted there pool to salt a couple...

    My parents converted there pool to salt a couple years ago. A lot easier and cheaper to maintain and the water temp rises faster that the chlorine water did. No salty feeling like the ocean and it...
  8. Thread: Knee pads

    by Hwolfe
    Replies
    21
    Views
    2,821

    I use those cheap gardening kneeling pads. Or a...

    I use those cheap gardening kneeling pads. Or a piece of arma flex wrapped with duct tape.
  9. Replies
    31
    Views
    2,923

    "I'd not sign a contract, have coil cleaning...

    "I'd not sign a contract, have coil cleaning every two years. Today's units are designed to last ten years, that's why the ten year warranty."

    Stud[/QUOTE
    With warranty vs service check, if you...
  10. Yes. And with it being a heat pump it should have...

    Yes. And with it being a heat pump it should have some type of crank case heater or way to heat the oil in the system at low ambient temps.
  11. Tell tour technician to check the crank case...

    Tell tour technician to check the crank case heater.
  12. Thread: 200 AMP Jumper

    by Hwolfe
    Replies
    9
    Views
    2,583

    Well I agree on newer homes. This house...

    Well I agree on newer homes. This house originally had the old knob and tub wiring. It's had been up graded with a square d box but some of the circuits still utilize the old wiring which is stupid...
  13. Thread: 200 AMP Jumper

    by Hwolfe
    Replies
    9
    Views
    2,583

    328861 That looks similar to this 20000 amp fuse...

    328861
    That looks similar to this 20000 amp fuse I found on a pull out disconnect for a thirty amp a/c. Yes I swapped them out for actually fuses.
  14. Replies
    45
    Views
    6,371

    I agree. Don't see a furnace gas explosion...

    I agree. Don't see a furnace gas explosion causing that amount of a blast. A lot of those suburb homes in Indy are the jagoe concrete slab homes maybe a huge gas leak and build up under the slab...
  15. Replies
    13
    Views
    3,266

    I just turn my head. Lol.

    I just turn my head. Lol.
  16. Replies
    9
    Views
    1,369

    Call a tech.

    Call a tech.
  17. Replies
    19
    Views
    2,289

    I am the other Guard guy that works with Tommy...

    I am the other Guard guy that works with Tommy Knocker. I worked for the company a total of 3 years. 2 the first round (I left due to a slow winter and starting a family needed a steady pay check)...
  18. Replies
    199
    Views
    11,641

    There has been a cost of living increase based on...

    There has been a cost of living increase based on the cost of living each year but not an actual pay increases. When bush was in office there was a cost of living increase and then six months later...
  19. Replies
    199
    Views
    11,641

    I'll give you one. The military hasn't had a pay...

    I'll give you one. The military hasn't had a pay raise in the last four years. At least the republicans supports our troops.
  20. Thread: Any Help

    by Hwolfe
    Replies
    247
    Views
    19,487

    I've keep up with this thread since the start....

    I've keep up with this thread since the start. Yeah he's a dumb@$$ for even thinking a company relies on only one service tech. I'm a young tech and still have enough common since to know better. I...
  21. Replies
    18
    Views
    3,548

    I've done both mainly service though. I've heard...

    I've done both mainly service though. I've heard the words "I won't have to service it." And with being that said is were most of the Battle comes from. The company I work for the installers a...
  22. Thread: Work boots!

    by Hwolfe
    Replies
    122
    Views
    17,619

    I've had timber wolf slip on that wore with in...

    I've had timber wolf slip on that wore with in three months. I wear red wing slip on now Irish setter and they are awesome.
  23. Replies
    18
    Views
    3,548

    I lied signal stage furnace.

    I lied signal stage furnace.
  24. Replies
    18
    Views
    3,548

    80,000btu two stage.

    80,000btu two stage.
  25. Replies
    18
    Views
    3,548

    Nope it's illegal here as well

    Nope it's illegal here as well
  26. Replies
    18
    Views
    3,548

    Install vs service

    Found this pain in the butt today. Had no room to get to the gas outlet port and thank god the igniter tested good. This was not installed by the company I work for. The company that installed it is...
  27. Replies
    14
    Views
    1,656

    I've seen them run through the wall. How long has...

    I've seen them run through the wall. How long has the unit been installed? And has it ran in cooling? If it has you would see the water marks on your wall.
  28. Replies
    3
    Views
    1,627

    Yes

    Yes
  29. Replies
    6
    Views
    911

    How is it stealing when you took the picture?

    How is it stealing when you took the picture?
  30. Replies
    6
    Views
    911

    Oh no I have fun on the job when I can. 316181...

    Oh no I have fun on the job when I can.
    316181
    Hey look the humane society caught a wolf.
  31. Replies
    19
    Views
    3,137

    I would check your amp draw on your motor after...

    I would check your amp draw on your motor after replacing capacitor to insure condition of the motor.
  32. You could also tell the customer your not going...

    You could also tell the customer your not going in their crawl space until they get there infestation taken care of. Told one I wasn't going in his attic when it was 115 outside this year. He wasn't...
  33. You could take a bottle of map gas with you and...

    You could take a bottle of map gas with you and burn what ever gets close to you. Just don't burn the house down. Other than that never really thought about I just dive in head first. But then again...
  34. Thread: Forum apps

    by Hwolfe
    Replies
    5
    Views
    758

    Don't worry I am too. Yes I am using ISO 6....

    Don't worry I am too. Yes I am using ISO 6. Haven't had a problem. Just updated to it last weekend.
  35. Replies
    31
    Views
    2,763

    You would think the guys fighting for our country...

    You would think the guys fighting for our country would get the top of the line product out there however. When it comes to the government there check goes to the lowest bidder.
  36. Thread: Forum apps

    by Hwolfe
    Replies
    5
    Views
    758

    I downloaded the tapatalk app and haven't had any...

    I downloaded the tapatalk app and haven't had any problems uploading pics. You can't edit profile with it but it is definitely easier to use and may help to fix your problem.
  37. Replies
    43
    Views
    4,968

    I'm one of the younger guys that tommy knocker is...

    I'm one of the younger guys that tommy knocker is talking about. I split wood at the bosses house before and was fine with it. He even bought us lunch. But no I don't even get a two hour show up due...
  38. Thread: capacitors

    by Hwolfe
    Replies
    27
    Views
    2,921

    I would like to have a copy emailed to me as...

    I would like to have a copy emailed to me as we'll please.
  39. Replies
    9
    Views
    1,133

    Been in an attic once that had a family of coons...

    Been in an attic once that had a family of coons living it. Freakin nasty crap every were. I feel ya.
  40. Thread: capacitors

    by Hwolfe
    Replies
    27
    Views
    2,921

    That's good to know. Have to get me one now.

    That's good to know. Have to get me one now.
  41. Thread: capacitors

    by Hwolfe
    Replies
    27
    Views
    2,921

    You are correct compressor do not. Not for sure...

    You are correct compressor do not. Not for sure where to find it on an after hours call.
  42. Thread: capacitors

    by Hwolfe
    Replies
    27
    Views
    2,921

    Data plate on the motor.

    Data plate on the motor.
  43. Thread: capacitors

    by Hwolfe
    Replies
    27
    Views
    2,921

    Call the local supply house or look on the data...

    Call the local supply house or look on the data plate.
  44. Replies
    14
    Views
    1,342

    Sounds like bad compressor to me. A hard start...

    Sounds like bad compressor to me. A hard start kit may help but never know for how long.
  45. Replies
    41
    Views
    4,352

    If there has been a compressor change on the unit...

    If there has been a compressor change on the unit I have seen the needle in the txv black and dirty from the torching/old compressor burn out. Especially when brazing without nitrogen.
  46. Thread: Timber!

    by Hwolfe
    Replies
    8
    Views
    2,535

    Timber!

    311691
    Found this after a storm. Tree landed on it. Would have ran and cooled if the fan blade wouldn't have hit the sides of the unit.
  47. Replies
    1
    Views
    519

    The model number on the compressor will tell you...

    The model number on the compressor will tell you your tonnage.
Results 1 to 47 of 55
Page 1 of 2 1 2
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event