Type: Posts; User: cdn hvac
Search: Search took 0.01 seconds.
Its the same as Carrier's Infinity Systems. Top of the line in my books!
I have seen direct vent units where the vent gases are being pulled into the intake due to ...
1 Damaged Cap ( Wont work with out it)
2 Disconnected vent at F\P ( expensive to fix )
Re postion the vent motor and your in bussiness.
If that oil had leaked the clean up costs can run high
$10,000 to $100,000.
If the oil got into a near by pond or lake then you would be in real big trouble mister.
I can see a red apple on that document holder. Is Apple part of the name of your company? Nice job , humidifier drain not as good as the other drains.
Did you leave the HWT C-vent at 3" ? Has to...
Nice. But I think that 2" to 3" pvc vent reducer should be in the vertical position not horizontal. Condesate will build up in it causing gurrgles! Check the installation manual it should explain.
07-25-2006, 08:58 PM
1996 I was on a nosiy furnace call. I had the home owner right beside me while i was reaching into the blower wheel to see if something was in there. I gave it the usual spin and feel and felt...
I stoped in at the local Goodman Dealer today to pick up a part for a warranty call. I wish I had my camera because some hack bought some codensers and coils and was removing them from there boxes so...
07-18-2006, 06:50 PM
Not sure if this will work but I think some Carrier furnaces like the STA MXA or CVA you can change the cont fan speed by switching the fan switch at the Thermostat from ON to Auto and Back to on and...
Maybe they did not want to take down the tin foil from the windows! Looks like they set the unit up in front of a bedroom door? Also most doors open into a room so they probably faced the wrong way...
Whats that you got on the end of the cordless drill Thoglow? It looks like a flex bit 1/4 or 5/16 ? Where can I get one!
It only ends up as junk after its
installed incorrectly and unsafe.
I'v worked with Goodman and Carrier
products and yes Carrier is a much
better product but when it comes to
Goodman canada ontario will no longer sell there products to anyone who does not have valid trade licenses and contractors regristation # from TSSA.
This week in ontario we had a little heat wave...
05-20-2006, 08:33 PM
Hmm why do they put these floor vent thingies under windows? I'll just cover it up with this end table.
I hate those 3x10 or 4x10 filters that home owners stick in the supply vents ! Or when the...
Nice Job ! Why hide it behind Tin Tape?
Try clear or silver duct caulk next time.
You may find it cheaper and less work.
Keep up the good work gasguy.
New Carrier condensers look like UFO's or those shiny camper trailers from the 1950's .
I like the threaded hangers on the blower unit much better than blocks or drive cleats i always see.
Is that a 120 or 140 requiring double return air's ? Never seen it done like that but looks good.
I like the case coils and the UV lights seem to be in high demand!
Have to have 2 ft in front of furnace. Thats code up here in ontario, canada.
How would Tubby,Chunky or Tiny service it?
If they had only made those old boilers with copper you could retire after a couple jobs !
Thats one for the spider !
O thats just a service panel to check left side of cells.
We call them gravity furnaces and if I remember correctly they used coal. I'v removed alot of them and talked with one old timer who actualy used coal before oil or gas. The house still had the coal...
04-12-2006, 07:50 PM
If you dont like cubes?
Where did I put my shark spray ? This pink dildo is only making it madder!
[Edited by cdn hvac on 04-10-2006 at 10:44 PM]
No french drains around these parts, Ontario Canada.
We use black abs pipe with yellow glue here for venting and clear tube for drains(NEW HOMES). Some area inspectors require we use pvc for...
Results 1 to 25 of 105