Search:

Type: Posts; User: josefbrunclik

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    2
    Views
    845

    Very old Wall Furnace

    This is 40 year old wall furnace that has been condemned. My question is, if you guys look to the left of the gas valve, you can see a copper coil. Anybody have any idea what this may have been for?...
  2. Replies
    4
    Views
    873

    These are the "B" type double wall vents for wall...

    These are the "B" type double wall vents for wall furnaces. Some are clean, and others have a lot of soot on them. Most likely a combustion problem, but I sure would like to hear your opinion on it.
  3. Replies
    4
    Views
    873

    Furnace Vent

    I have been doing some basic maintenance work for property management companies. Went up on the roof to check the furnace vents. When you guys see a vent pipe that is all black of soot deposits, what...
  4. Well, what would be the worst case scenario? The...

    Well, what would be the worst case scenario? The controll board detects pressure switch problem and locks out the unit? Or the switch holding closed while the inducer isn' pulling sufficient draft?...
  5. Replies
    6
    Views
    1,043

    Yes, old furnace, no control board. And yes this...

    Yes, old furnace, no control board. And yes this is the diagram I'm looking at. The untimed load would be the gas valve and ignition? And continues and cooling fan would still be routed through the...
  6. Replies
    6
    Views
    1,043

    Wiring question

    I have a ICM 251 fan control. Delay on brake, delay on make. While controlling the fan in heating mode is fairly simple, my question is how to wire this to maintain continues fan and cooling mode fan...
  7. Pressure switch

    Just picked up few pressure switches at Johnstone yesterday. Cheep black plastic, made in Costa Rica.
    Fixing a York, 80% single stage furnace. The old pressure switch would close initially, but...
  8. Replies
    31
    Views
    2,540

    Truck lettering

    Back in 2005 I rear ended a car on the freeway while driving my beautifully lettered work truck. It was a set up. The car in front of me had the brake lights disabled. Another two cars driving on...
  9. Replies
    3
    Views
    620

    Furnace control board

    Do you guys have a good universal control board that you carry in a van, that works for some or most of the early models 80% furnaces?
  10. Replies
    51
    Views
    6,290

    rx11 Flush

    Have been using rx11 to flush my line sets. A lots of it, until it comes out clear and than some more. Insane amount of nitrogen to get it all out. Than puling deep vacuum, brake with N and puling...
  11. Replies
    5
    Views
    698

    Qbooks

    I have been using 2006 version Quickbooks Pro on my MacBook. Works fine for organizing your finances and keeping clean books. Stable, no major issues. Will upgrade soon to the newest version.
  12. Replies
    19
    Views
    5,219

    Flue damper

    Flue Damper shown in relation to the inducer. Makes a little sense. The importance of having a clean and non-obstructed HX being stressed at every level, this damper effectively reduces the flue gas...
  13. Replies
    19
    Views
    5,219

    Flue damper

    I have had the same problem on a Bryant 2 Ton Gas Pack, roof top unit. With new inducer, new rollout switch, gas pressure adjusted, the unit continued to cycle off on the rollout switch. The flame...
  14. Replies
    21
    Views
    3,030

    Has anyone actually know of someone who got...

    Has anyone actually know of someone who got caught venting and had to pay the fine?
  15. Replies
    4
    Views
    461

    Still learning....

    Thanks Flange, this is a good info! Heaterman, it's the
    Bryant 582ANW024040NAAD - fairly new unit, installed couple years ago by someone else. I went ahead and inspected the other units on the...
  16. Replies
    4
    Views
    461

    I should add, this is Bryant, 2 Ton cooling,...

    I should add, this is Bryant, 2 Ton cooling, 40000 BTU gas heating unit. I have seen the same restrictions on Carriers also.
  17. Replies
    4
    Views
    461

    Flue Gas Vent

    I work on RTU gas-electric packages. One kept going off on the FRS. The flame did not look right. New inducer, manifold pressure adjusted, still the same problem. I noticed a plate in the flue gas...
  18. Replies
    150
    Views
    43,097

    Sticky: So far I'm the only one in the Los Angeles area.

    So far I'm the only one in the Los Angeles area.
  19. Replies
    1
    Views
    605

    Home beer brewing - cooling project

    I would like to set up a cooling unit to draw the brew temp from 200+ deg. down to about 60 deg. I have a few water fountain units that I was going to use for parts. The heat exchange copper coils...
  20. Replies
    2
    Views
    466

    Another school project

    Hi guys! A question came up today in the class about a system pump down. Closing the high side service valve while running the system and trapping the ref in the condenser, before opening the system....
  21. Replies
    1
    Views
    386

    I'm a student my self, taking HVAC classes at...

    I'm a student my self, taking HVAC classes at community collage. The book we are using right now is Fundamentals of HVAC/R by Carter Stanfield and David Skaves. Very good book, over fifteen hundred...
  22. Replies
    26
    Views
    2,395

    I would like to get one of those heavy duty steel...

    I would like to get one of those heavy duty steel boxes and bolt it to the floor and keep all my tools in it. Than, they will probably steel the whole van!
  23. Replies
    3
    Views
    397

    Strait A!

    Hey guys,
    I just thought I would stop by and let you know I just finished the summer semester over at the El Camino Collage! This was my very first HVACR class on my way to become a Tech, and I...
  24. Replies
    13
    Views
    2,739

    Hi Guys, I have been considering Penn Foster for...

    Hi Guys,
    I have been considering Penn Foster for a while, but I have already read a lot of books and manuals on my own, so I went to our local community collage for some hands-on. The class is...
  25. Has anyone been to El Camino collage?

    Hi guys, hope everybody is well.
    Question for all the guys here in California, Los Angeles.
    Has anybody been to either El Camino Collage or Harbor Occupational Center in San Pedro for your HVAC...
  26. Replies
    30
    Views
    1,132

    Well, you certainly came to the right place. I'm...

    Well, you certainly came to the right place. I'm an A/C student my self, and this forum is absolutely amazing! The amount of information that's hiding under each and every folder is insane! I always...
  27. Replies
    29
    Views
    1,902

    Hey guys, maybe now is the time to go out and...

    Hey guys, maybe now is the time to go out and sell some EAC systems! Guaranteed to kill every virus and bacteria in the house. And since the flue is a Mexican bug, I prescribe a shot of Tequila!
  28. Replies
    31
    Views
    1,376

    Back in the good old days, we used to go camping...

    Back in the good old days, we used to go camping a lot and I decided to install a CB radio in my truck. Thinking how great it will be to talk to all the nice folks on the road while driving. Little...
  29. Replies
    27
    Views
    1,324

    Give the guy some credit. He spends money on...

    Give the guy some credit. He spends money on tools, not toys.
  30. Replies
    45
    Views
    1,944

    I have never killed a charger with an inverter,...

    I have never killed a charger with an inverter, but I did killed an inverter with a charger. It was my 2500 W unit. The charger that killed it was a kid's toy charger. I have overloaded the inverter...
  31. Replies
    64
    Views
    6,267

    Buy a Mac. I have never owned a one single piece...

    Buy a Mac. I have never owned a one single piece of anti virus software. And I have been on the internet for longer than I care to admit. On the other hand, Mongolia depends on PC owners for steady...
  32. Replies
    20
    Views
    1,363

    There are people here in LA, who demolish old...

    There are people here in LA, who demolish old houses, load everything up on a truck and haul it down to Mexico. Over there, they sell it as a construction material, even an old garage door! Who...
  33. Replies
    28
    Views
    2,058

    A smart man can learn something even from a fool....

    A smart man can learn something even from a fool. A fool never learns.
  34. Replies
    11
    Views
    518

    I'm also new to this site. Don't have my pro...

    I'm also new to this site. Don't have my pro membership yet, but I'm already learning a great deal! Forums are by by far the best source of information.
  35. Company vehicles

    No changes, no alterations. Not even a bumper sticker. Standard protocol.
  36. Replies
    29
    Views
    2,507

    I was born and raised in the Check Republik -...

    I was born and raised in the Check Republik - central Europe. Picking wild rooms was the thing to do, every year during the summer and the fall. I remember getting up at five in the morning and...
  37. Replies
    34
    Views
    2,379

    http://hvac-talk.com/vbb/attachment.php?attachment...

    http://hvac-talk.com/vbb/attachment.php?attachmentid=19102&stc=1&d=1236230621
    Wife don't make stakes. Guys make stakes! Wife love guys who make stakes!
  38. Replies
    133
    Views
    12,119

    You put tears in my eyes! My first american truck...

    You put tears in my eyes! My first american truck was 73 Chevy - the same color! I loved that truck! I could walk on top of the engine hood! I could get inside the engine compartment! I was getting...
  39. Thread: GPS

    by josefbrunclik
    Replies
    0
    Views
    363

    GPS

    I got me a new Garmin GPS street navigator. I was not sure about the value of the GPS since most of the time, I operate in close neighborhood, but OMG! How could I ever live without one? It's...
  40. Replies
    45
    Views
    1,944

    Power invertor

    Very nice! I have always had a power inverters on all my rigs! My latest is 800 W unit, got it at Pep Boys auto-parts. It's sitting under the driver's seat, wired strait to the battery with 10 gauge...
  41. Replies
    16
    Views
    966

    This is probably something the insurance carrier...

    This is probably something the insurance carrier came up with. My insurance have always required names and lic. numbers of anyone driving our vehicles.
  42. Replies
    16
    Views
    888

    I would be afraid your motor controller may not...

    I would be afraid your motor controller may not be able to handle the higher amps of the 500 W motor. The voltage is not a problem. These motors usually work with a wide range of voltages.
  43. Replies
    15
    Views
    5,038

    I have spent 25 years of my life in communist...

    I have spent 25 years of my life in communist Czechoslovakia. What is happening now in the US, I have seen it all before, and it was not a pretty picture. But I tell you one thing, like it or not:...
  44. Nice!

    This would have gone a long way for two friends of my! Both skilled and experienced craftsman, they now have only seventeen fingers between the two of them. All thanks to a table saw. As for the...
  45. Replies
    13
    Views
    2,739

    HVACR-on line education

    As many have been asking about online schools and education, I found Penn Foster school, which offers a HVACR class.
    Here is a direct link to the HVAC segment:...
Results 1 to 45 of 64
Page 1 of 2 1 2
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event