Search:

Type: Posts; User: Glenn54

Search: Search took 0.01 seconds.

  1. Great. Wanted to make sure I wouldn't be...

    Great. Wanted to make sure I wouldn't be overloading a circuit. Thanks.
  2. Can two wires share the C terminal on my York furnace terminal board?

    I plan to upgrade my 20 year old Honeywell Chronotherm III programmable thermostat with their newer wifi model. My C terminal on my York furnace is currently being occupied by a line running outside...
  3. Did a full cleaning and dusting and wiped off the...

    Did a full cleaning and dusting and wiped off the flame sensor. Alls working just fine now. Starts right up with one push of my remote :)
  4. Older Heat-n-Glo flame extinguishes after 15-20 minutes.

    I have an older model Heat-n-Glo system Model 6000DVT. It was installed by the builder when I moved in my house back in 93. Sad to admit, I haven't done much with it as far as servicing over the...
  5. OK, so in addition to isolating the lineset, I...

    OK, so in addition to isolating the lineset, I stuffed some fiberglass insulation between the lineset and my ceiling. This lowered the noise level to a managable level that I can live with. I surfed...
  6. Where can I find vibration limiters?

    Where can I find vibration limiters?
  7. OK, I turned the a/c on inside and then went...

    OK, I turned the a/c on inside and then went outside and dropped the breaker to the a/c unit. Came back in and heard no hum noise at all.
  8. OK, I removed the remaining holding clamps...

    OK, I removed the remaining holding clamps completely decoupling the lineset from my house framing. That reduced the noise a bit. Would wrapping the line in additional padding help any or is this...
  9. Any tricks of the trade to quiet it a bit?

    Any tricks of the trade to quiet it a bit?
  10. The lines were not replaced, however one thing, I...

    The lines were not replaced, however one thing, I thought lowered the sound just a bit, I removed the line-set holding bracket that secured the line to the floor joist. I thought it was vibrating...
  11. Low pitched hum from furnace blower when AC cycles on

    Hello all. Glad to be a new member of the site:). I have a 15 year old York furnace, mod#P2MPD14N08001B 115v-1PH-60hz. The York A/C unit was replaced about 3 years ago with a Frigidaire FS5BD and...
Results 1 to 11 of 11
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event