Search:

Type: Posts; User: jeepgrady

Page 1 of 4 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    10
    Views
    495

    So the tech came today. Good news is that he...

    So the tech came today. Good news is that he found several of the ducts in the attic were somewhat contorted. Bad news: he missed one of the rafters and went through my bathroom ceiling in my two...
  2. Replies
    10
    Views
    495

    I don't think it will be a problem. I have had...

    I don't think it will be a problem. I have had several conversations with the owner of the company in the past, the last one being in November. He said he would address everything when they do my...
  3. Replies
    10
    Views
    495

    Insufficiant air from some registers

    My home is two years old with a dual fuel hp/propane system. The home was newly built at the time. In gas heating mode I noticed that several registers produce very little air. While in HP heating...
  4. Replies
    5
    Views
    400

    My question is more of a generic one. I did a...

    My question is more of a generic one. I did a search on google and the answers are all over the place. Some say leave unused rooms closed and some emphasyze to leave them open especially with a hot...
  5. Replies
    5
    Views
    400

    No registers were closed in these rooms.

    No registers were closed in these rooms.
  6. Replies
    5
    Views
    400

    Best heat distibution with hot air

    I've got a two stage HP with propane back-up. The stat is in the living room. I have been keeping the two unused bedroom doors shut. When going into these rooms I notice that it is quite a bit...
  7. Difference between 80% and 95% gas furnace

    Could someone please explain the difference between an 80% and 95% gas furnace? While I know the difference relating to efficiency, I'm curious how different they are mechanically, such as why doe...
  8. Replies
    11
    Views
    1,031

    There are 15 registers in the main zone. I want...

    There are 15 registers in the main zone. I want to close four. The second zone upstairs has two registers that will remain open.
  9. Replies
    11
    Views
    1,031

    There is no bypass damper. One zone covers the...

    There is no bypass damper. One zone covers the main floor and the second zone is for the 15X32 ft. room above the garage. The registers I want to close are all on the main floor. None of them are in...
  10. Replies
    11
    Views
    1,031

    Already checked. There aren't any.

    Already checked. There aren't any.
  11. Replies
    11
    Views
    1,031

    Closing several registers

    I've got a two zone Carrier system. The ducting is in the attic and there are only two motorized dampers that feed each zone. There are several rooms that could use a bit more air. I have a walk-in...
  12. Replies
    13
    Views
    1,711

    Forgot to mention, Living area and master br have...

    Forgot to mention, Living area and master br have 12 ft. cathedral ceilings which obviously needs a lot of heat.
  13. Replies
    13
    Views
    1,711

    We are retired seniors. In our younger days 65...

    We are retired seniors. In our younger days 65 was comfortable. No more. You'll see. One of the downsides of age, but consider the alternative. Yes we do have a bypass humidifier. Usually keep it...
  14. Replies
    13
    Views
    1,711

    It is now 19 od, inside set to 72. It is cycling...

    It is now 19 od, inside set to 72. It is cycling on and off and only running on low stage.
  15. Replies
    13
    Views
    1,711

    Furnace running non stop

    New app. 2500 Sp. ft. home in NE Pa. Infinity two stage 60,000 BTU propane furnace. Last night OD temps 6 deg. Indoor stat set to 71 deg. Furnace ran all night mostly in low stage, and...
  16. Replies
    5
    Views
    471

    While the furnace is in a conditioned area, all...

    While the furnace is in a conditioned area, all ductwork is through the attic and down mostly exterior walls.

    The main floor is one zone, and the room above the garage is another. Stat on main...
  17. Replies
    5
    Views
    471

    Vent temp. variances in different rooms

    New home with hp and propane back-up. While in gas mode I measured vent output temps using an infrared gun. Some vents read 110 deg. while others read 95. In addition in room above garage, the vent...
  18. Replies
    24
    Views
    3,551

    This is the Ask Our Pro's forum. In order to post...

    This is the Ask Our Pro's forum. In order to post a response here, you must have verified qualifications and have been approved by the AOP Committee. You may ask a question by starting a new thread....
  19. Replies
    14
    Views
    1,510

    OK, 6 votes for hot and 4 for cold. Now I'm...

    OK, 6 votes for hot and 4 for cold. Now I'm really baffled. While everyone has opinions, who should I, being the novice listen to?
  20. Replies
    14
    Views
    1,510

    Bypass humidifier question

    My dealer will be installing a bypass humidifier on my Infinity furnace. Is it better to use hot or cold water for the supply, and why?
  21. Replies
    5
    Views
    1,166

    It's only my wife and myself. Lately, the outdoor...

    It's only my wife and myself. Lately, the outdoor rh has been around 90% at night and 40 during the day.

    Bald Loonie- Since it is only the two of us we don't generate much moisture since we don't...
  22. Replies
    5
    Views
    1,166

    Appropriate humidity level in new home

    My new home is heated with a HP with a 96% Infinity furnace for backup. Currently my humidity level is 32%. Is this sufficient? Mind you the daytime temps are still 40-50 and nighttime 28-35 where I...
  23. Replies
    6
    Views
    1,804

    Any other opinions?

    Any other opinions?
  24. Replies
    6
    Views
    1,804

    Based on Carriers site, Model 59tn6a is listed...

    Based on Carriers site, Model 59tn6a is listed as: Infinity 96 New Edition, and Model 58mvco is listed as: Infinity ICS Modulating Gas.

    It appears that these are both from the Infinity series. Am...
  25. Replies
    6
    Views
    1,804

    Need opinions on Carrier Gas Furnace

    I am in the process of building a new home. The builders hvac guy told me he was installing a carrier 58mvco furnace. I went to the home today and the furnace model installed is model 59tn6a. Looking...
  26. Replies
    13
    Views
    1,279

    I stand corrected. The rate is 8.41 cents.

    I stand corrected. The rate is 8.41 cents.
  27. Replies
    13
    Views
    1,279

    Got the rate from PPL's website. This is a new...

    Got the rate from PPL's website. This is a new home, being built, thus I don't have a bill to go by.
  28. Replies
    13
    Views
    1,279

    Looks like electric rate is 3.323 cents per kwh...

    Looks like electric rate is 3.323 cents per kwh through PP%L.
  29. Replies
    13
    Views
    1,279

    It is propane. Nat. gas is not available. I...

    It is propane. Nat. gas is not available.

    I also question why not Infinity all around. I can get it for $X. more.

    The evap coil model quoted to me is: cnpvp3617ata, tin plated. Is this ok?
    ...
  30. Replies
    13
    Views
    1,279

    Advice on new system

    Building a new home in NE Pa. Been quoted the following Carrier equipment. Please give advice.

    Furnace Infinity 58Mvc060-14
    HP Performance Comfort 25Hcc636
    Zoning cc2k1t01-b

    Is this HP two...
  31. Why do you have the center blowing towards the...

    Why do you have the center blowing towards the outside walls? Shouldn't they be aimed at the middle of the room?
  32. Replies
    24
    Views
    2,171

    The plastic mesh comes off easily. It's perfect...

    The plastic mesh comes off easily. It's perfect assuming that you are near ground level. The mesh holes are big enough that some smaller pieces of lint will pass right through.
  33. Replies
    24
    Views
    2,171

    Ace hardware has a vent that has a plastic mesh...

    Ace hardware has a vent that has a plastic mesh cover on the exterior. Should keep the meeces out.
  34. Replies
    32
    Views
    9,177

    Propane at $1.78? Damn, my supplier charged me...

    Propane at $1.78? Damn, my supplier charged me $4.26 back in Dec. Don't complain.
  35. Replies
    27
    Views
    2,170

    I was thinking the same. Running the HP is still...

    I was thinking the same. Running the HP is still much cheaper than the strips.
  36. Replies
    17
    Views
    1,835

    Gary- Thank you for your response. You stated...

    Gary- Thank you for your response. You stated exactly what I have heard before. Goes back to the responses to the OP question. Why did they say that if it is running for ten hours, there's a problem....
  37. Replies
    17
    Views
    1,835

    Update: Case in point- My units been running non...

    Update: Case in point- My units been running non stop since about 11:00 last night. OD temp is now 21. Stat set at 75, actual temp 75, so it's holding its own. Since I have a vision pro stat, it...
  38. Replies
    17
    Views
    1,835

    I'm confused. Hasn't it been stated many times on...

    I'm confused. Hasn't it been stated many times on this forum that at low temps it isn't abnormal for the hp to run continuously? Especially with the newer stats that maintain maybe 1/2-1 deg....
  39. Replies
    49
    Views
    3,493

    I was going to suggest a $500. discount. It's...

    I was going to suggest a $500. discount. It's true about an inspector if you sell the house. It's no different than buying a new car. It's either perfect or they do the right thing, period.
  40. Replies
    5
    Views
    644

    In a two stage sysetm both the condenser and a/h...

    In a two stage sysetm both the condenser and a/h are two stage.
  41. Replies
    8
    Views
    1,197

    My two year old Lennox uses the foil backed.

    My two year old Lennox uses the foil backed.
  42. Replies
    218
    Views
    19,233

    I think you have given him ample time to come out...

    I think you have given him ample time to come out and address your issues. It's time to get back to the CC company and have them do a reversal of his payment. I guarantee you that he will then come...
  43. Replies
    218
    Views
    19,233

    Go to: hvacpartsshop.com/service-manuals.aspx....

    Go to: hvacpartsshop.com/service-manuals.aspx. You can get your installation manuals for both the indoor and outdoor units.
  44. Replies
    218
    Views
    19,233

    You never mentioned. Did you pay for this yet? If...

    You never mentioned. Did you pay for this yet? If so, how? With that disaster, I would get financial recourse buy stopping the check if not too late or if you were lucky enough to pay by credit card,...
  45. Replies
    17
    Views
    1,115

    I'm also in SC. My bill for this January was...

    I'm also in SC. My bill for this January was $289. compared to $186 last January. All of my neighbors bills also increased dramatically. It's definately the abnormal weather we have been...
  46. Replies
    23
    Views
    2,406

    Well if the interior temp is dropping, the heat...

    Well if the interior temp is dropping, the heat strips should kick in if the unit is set up properly. Even if the HP alone can't keep up, whatever heat it does generate is better than the strips...
  47. Replies
    24
    Views
    1,925

    Think about it rationally. Why do people keep a...

    Think about it rationally. Why do people keep a different temp setting in the Summer vs. the Winter? We keep ours at 75 year round.
  48. Replies
    13
    Views
    744

    It is not a variable speed. As far as...

    It is not a variable speed.

    As far as monitoring temp from th a/h, that's easier said than done since it is in the attic and requires an 8 ft. ladder to get up there.

    Besides the return in the...
  49. Replies
    13
    Views
    744

    This is a two stage system with a bypass.

    This is a two stage system with a bypass.
  50. Replies
    13
    Views
    744

    Airflow is good with all zones. The a/h is a...

    Airflow is good with all zones. The a/h is a multi speed Lennox CBX27UH, with a Lennox LZP4 zone control.
Results 1 to 50 of 179
Page 1 of 4 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event