Search:

Type: Posts; User: kevincompass

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    482

    new job leak detector

    Has anybody one tryed this out supply house is pushing it big time
    http://www.jbind.com/products/Aurora-Refrigerant-Leak-Detector.aspx
  2. Replies
    17
    Views
    1,003

    more thin likely the forced compressor was...

    more thin likely the forced compressor was throwing off the controller next time you should check with a meter to see what is locking it ot
  3. Replies
    10
    Views
    559

    not on the rack unless its a new line up but on...

    not on the rack unless its a new line up but on splits and self contains yes I do
  4. Replies
    10
    Views
    559

    Just go to air gas a get a co2 regulator and a...

    Just go to air gas a get a co2 regulator and a flow meter that's where I got mine its a standers item for mig and tig welding and I have been purging with. Co2 and have no issues
  5. Replies
    5
    Views
    523

    what's they scale down there for a journeymen...

    what's they scale down there for a journeymen start up rack mechanic
  6. Replies
    5
    Views
    523

    union ?

    union ?
  7. Replies
    133
    Views
    5,759

    you could just torch the receiver to see if its...

    you could just torch the receiver to see if its full or just pull some gas in to a recovery cylinder and see when the glass flashes
  8. Replies
    3
    Views
    325

    how to properly a just h10 pm

    How do I properly set up my h10 in manual mode I have herd a least 3 different ways of doing so in manual mode dose the sensor adjustment that you need a screw driver to turn in the super rh corner...
  9. Replies
    8
    Views
    670

    we have been looking for orings for a wile the...

    we have been looking for orings for a wile the oring is very thin and square no orings I have tried have worked
  10. Replies
    8
    Views
    670

    target split condenser valve leaks

    has any one seen a huge number of target split condenser valves leaking I have found 21 in 2 months all are the dead winter condenser and all are sporlan oe35s1110 all of them have the large oring...
  11. Replies
    22
    Views
    1,217

    http://www.emersonclimate.com/europe/ProductDocume...

    http://www.emersonclimate.com/europe/ProductDocuments/AlcoLiterature/EN_PS3__35003.pdf

    I have a couple of older super plus racks running these the use to sell an adjustable one everything is...
  12. Replies
    1
    Views
    299

    you need to change the ip address of your lap go...

    you need to change the ip address of your lap go to network sharing center right click on Ethernet got to property's go down to tcip internet protocol right click go to property's change the ip and...
  13. Replies
    2
    Views
    463

    Those settings are very low

    Those settings are very low
  14. Replies
    6
    Views
    544

    I do it the way JP dose but some customers get...

    I do it the way JP dose but some customers get squimish when you back door in to there network . I also use a program called jump to control my lap top it works really good
  15. Replies
    43
    Views
    2,235

    you don't need to change the oil you need to find...

    you don't need to change the oil you need to find out why the oil is discolored and over heated its not oil like in your car it dose not just go bad a situation has to destroy it . I would definitely...
  16. Replies
    98
    Views
    6,655

    omg 41000 a year to run supermarket is insane I...

    omg 41000 a year to run supermarket is insane I would not touch that with a 10 foot poll
  17. Replies
    6
    Views
    435

    how big is the reclaim sounds like a good sized...

    how big is the reclaim sounds like a good sized one for that much gas we shift the pressure to get more heat from reclaim we need more info like what kina reclaim we are dealing with air water size...
  18. Replies
    4
    Views
    384

    Do they split and pump out or just shut off...

    Do they split and pump out or just shut off discharge
  19. you have to go to hill and buy it . its an oem...

    you have to go to hill and buy it . its an oem part
  20. any one have this Yellow Jacket 40852 Mini Refrigeration System Analyzer

    looks kind of cool now if only digi cool could make one not crazy about the k type probe but it would be nice to keep in the bag
  21. I am starting to see a lot of new stores that out...

    I am starting to see a lot of new stores that out side have transfer switches and portable generator hook ups out side iam sure Johnson controls or train or York have something in there chiller...
  22. just add bypass valves and hookups for temp...

    just add bypass valves and hookups for temp hoses so you could bypass the chiller that is down .
  23. Replies
    2
    Views
    422

    digi cool trouble

    my battery wire pulled out of my board and I was unsuccessful in sodering it back in could not remove old wire so my question is where do I get a new board .
  24. Replies
    19
    Views
    1,487

    the hand held is simple select the step rate and...

    the hand held is simple select the step rate and hold the button down to open and close the valve . if you are dealing with WalMart you can persuade them to make a change if its valid reason.
  25. Replies
    19
    Views
    1,487

    when it reaches set point it will fully close...

    when it reaches set point it will fully close also yes they can fail intermittently it has a throttle range programed in to the controller so some times it may dip below set point. cycling the power...
  26. Replies
    3
    Views
    299

    You need ultra site from cpc.

    You need ultra site from cpc.
  27. Replies
    0
    Views
    422

    digi cool 1250 pin id

    On the bord of the drsa what pins are the subcooling sensor and what pins are for the super heat my plug has a broken wire and i wish to just soder them strait to the bord thanks
  28. Replies
    4
    Views
    575

    Thanks I will try and call the tomorrow.

    Thanks I will try and call the tomorrow.
  29. Replies
    4
    Views
    575

    digi cool 1250 sensor cable

    My digi cool 1250 has a broken wire going to the center jack for the temp sensor cable can I buy a replacement part for the 4 pin connector from some where besides digicool
  30. Replies
    138
    Views
    14,450

    http://hvac-talk.com/vbb/showthread.php?t=776942&h...

    http://hvac-talk.com/vbb/showthread.php?t=776942&highlight=digi+cool
  31. Replies
    13
    Views
    890

    Are there any cracked peaces of plastic causing...

    Are there any cracked peaces of plastic causing the water to not flow properly.
  32. you cant its junk order a new evap or a hole new...

    you cant its junk order a new evap or a hole new machine.
  33. Replies
    17
    Views
    2,279

    is the cold control properly inserted in the...

    is the cold control properly inserted in the coil. Also how are the door gaskets if it never shuts off it will defiantly freeze.
  34. What size and type fuses are you using.

    What size and type fuses are you using.
  35. Replies
    32
    Views
    2,293

    How dirty is the condesor? I would check the...

    How dirty is the condesor? I would check the subcoolng it sounds like u might have a pluged cap tube.
  36. Replies
    14
    Views
    2,853

    How bout pressures superheat and subcooling. How...

    How bout pressures superheat and subcooling. How clean are the coils?
  37. Replies
    14
    Views
    1,407

    45 degrees. Of subcooling is way to much I would...

    45 degrees. Of subcooling is way to much I would get a cap tube from true. Most of there boxes have a 18 degree. Cut out temp on the cold control but to be sure I would contact true to know for sure.
  38. Replies
    14
    Views
    1,407

    What is ur superheat and subcooling readings...

    What is ur superheat and subcooling readings sounds like u have a pluged cap tube .
  39. Replies
    6
    Views
    982

    What is ur superheat and subcooling ? What about...

    What is ur superheat and subcooling ? What about box manufacturer There's got to be a model number some where on the box.
  40. Where are you checking for subcooling before or...

    Where are you checking for subcooling before or after the receiver? What about superheat on the compressor or the evap. Need some more info
  41. Replies
    8
    Views
    2,120

    You might have to add a fitting to the crank case...

    You might have to add a fitting to the crank case or put a tee on an existing fitting.
  42. Replies
    2
    Views
    737

    I would check and make sure ur not locking out on...

    I would check and make sure ur not locking out on any safety's on the rtu unit first. need more info like model and serial ,and whats controlling the rtu.
  43. Replies
    6
    Views
    1,230

    discharge gas pulsation will make ur gages...

    discharge gas pulsation will make ur gages flutter to.
  44. Replies
    9
    Views
    1,327

    I work for jci and i have missed 3 days in a year...

    I work for jci and i have missed 3 days in a year gess it just depends on the branch.
  45. Replies
    6
    Views
    1,419

    Call Perlick tech support they will give u the...

    Call Perlick tech support they will give u the number.
  46. Replies
    25
    Views
    2,050

    could it be unequal circuit loading due to a...

    could it be unequal circuit loading due to a dirty evaporator making the bottom of the coil to get less airflow then the top
  47. Replies
    11
    Views
    1,295

    its the bord had the same problem the other day...

    its the bord had the same problem the other day put a new bord in and cut the old relay apart it was all pitted its an issiue with york bords
  48. Replies
    27
    Views
    6,327

    try all points food service they have pritty...

    try all points food service they have pritty good pricing hobart bownes every one
  49. Replies
    49
    Views
    3,193

    what about the termanels terminals of the...

    what about the termanels terminals of the compressor leeking buy
  50. Replies
    11
    Views
    2,002

    sounds like an Automatic expansion valve

    sounds like an Automatic expansion valve
Results 1 to 50 of 154
Page 1 of 4 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event