Search:

Type: Posts; User: pherman

Page 1 of 13 1 2 3 4

Search: Search took 0.01 seconds.

  1. Thread: Oy Vey

    by pherman
    Replies
    18
    Views
    1,854

    Yes! This needs to be posted on the Tips and...

    Yes! This needs to be posted on the Tips and Tricks forum now!:eek2:
  2. Replies
    14
    Views
    1,292

    It looks legit. I have no idea what you guys are...

    It looks legit. I have no idea what you guys are crying about.:whistle:
  3. Replies
    45
    Views
    15,165

    That is because you are partially melting a thin...

    That is because you are partially melting a thin layer of the ice to remove the groves and gouges caused by the skate blades. Hard to do that with cold water.
  4. Replies
    51
    Views
    2,474

    I'm not following the thinking here why this...

    I'm not following the thinking here why this would be better than one properly sized coalescent type separator like a Temprite?
  5. Replies
    17
    Views
    2,696

    Sadly, I have have seen worse....

    Sadly, I have have seen worse....
  6. Thread: Luminotice

    by pherman
    Replies
    3
    Views
    686

    hahahaha. :grin2:

    hahahaha. :grin2:
  7. Thread: Job dedication

    by pherman
    Replies
    9
    Views
    2,863

    You found his napping spot. Too bad, that looked...

    You found his napping spot. Too bad, that looked like a good one. :yes:
  8. Replies
    16
    Views
    3,466

    I think that is the least of our worries here....

    I think that is the least of our worries here....
  9. Replies
    16
    Views
    1,438

    Do they ever wash the case? That helps a little...

    Do they ever wash the case? That helps a little bit to not have the coil sitting in 7 pounds of spilled olive salad....
  10. Oh please tell me you got a picture of that...

    Oh please tell me you got a picture of that gem....
  11. Replies
    17
    Views
    1,342

    These are what I meant by encapsulated pressure...

    These are what I meant by encapsulated pressure control.....

    http://www.emersonclimate.com/europe/ProductDocuments/AlcoLiterature/EN_PS3__35003.pdf
    ...
  12. Replies
    17
    Views
    1,342

    Just a thought....does the rack have encapsulated...

    Just a thought....does the rack have encapsulated pressure controls? I've seen them act erratic when they went bad, although two at a time is a stretch.
  13. Replies
    11
    Views
    790

    That makes more sense...

    That makes more sense...
  14. Replies
    19
    Views
    1,012

    Thanks ice! Didn't know you could do that.

    Thanks ice! Didn't know you could do that.
  15. Replies
    8
    Views
    627

    Hoshizaki has a branch in Brea. Get their tech...

    Hoshizaki has a branch in Brea. Get their tech manuals and find out when there next class is. They have one there once a year.
  16. Replies
    24
    Views
    2,552

    :hijacked:

    :hijacked:
  17. Got this manual-

    Got this manual-
  18. Replies
    15
    Views
    4,190

    I was on a call for an ice machine not working...

    I was on a call for an ice machine not working once at a restaurant. Opened it up and it was roachtropolis inside. Roaches everywhere. That was fun to work on....:whistle:
  19. Replies
    17
    Views
    3,731

    :cheers:

    :cheers:
  20. Replies
    17
    Views
    3,731

    That's out of the WEC book 2014. Wisconsin...

    That's out of the WEC book 2014. Wisconsin Electric Code.
  21. Replies
    12
    Views
    2,380

    Awesome! Thanks for sharing those.

    Awesome! Thanks for sharing those.
  22. Replies
    4
    Views
    554

    Glad it's going to a good home. I'll get it out...

    Glad it's going to a good home. I'll get it out as soon as I can.
  23. Replies
    7
    Views
    568

    What kind of probe is it? did you try to...

    What kind of probe is it? did you try to calibrate it? Checked voltage etc? Check this out if this it what you have there are calibration instructions on here....
  24. Replies
    4
    Views
    554

    JP-Ask and you shall receive. I added that for...

    JP-Ask and you shall receive. I added that for you.
  25. Replies
    4
    Views
    554

    Alnor Thermo-Anemometer

    If any one is interested I'm selling this.

    http://www.ebay.com/itm/191102365909?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
  26. I don't know where you are but I've had coils...

    I don't know where you are but I've had coils measured and custom made by a coil manufacturer in the LA area.
  27. Replies
    22
    Views
    1,544

    Anytime :cheers:

    Anytime :cheers:
  28. Replies
    22
    Views
    1,544

    PhaseLoss I've used these and they are...

    PhaseLoss
    I've used these and they are adjustable I can't recall how low I've gone but it was on a low temp 22 rack where I was having a similar problem. The model I used was the PSC-AJS I think. ...
  29. Replies
    11
    Views
    2,202

    Why didn't you use hydrazorbs on the liquid line...

    Why didn't you use hydrazorbs on the liquid line as well? you already have the strut there? That tape will fall apart then whats going to happen to those liquid lines?
  30. Replies
    13
    Views
    1,072

    if your contactor is bad single phasing the...

    if your contactor is bad single phasing the compressor and causing it to go off on internals, that will cause you to trip on oil. Far more likely to have a bad contactor than a bad internal over...
  31. Replies
    13
    Views
    1,072

    Check that compressor contactor also.

    Check that compressor contactor also.
  32. Woah tiger!

    Woah tiger!
  33. Thread: hourly pay

    by pherman
    Replies
    98
    Views
    8,593

    Haha me and mine too jimmy. I thought it was...

    Haha me and mine too jimmy. I thought it was pricey where we live, but WTH? $800K for a little fixer upper?
  34. Refrigerated trailer for outdoor hockey games.

    Hockey fan or not, I thought this was cool what they crammed into this trailer, though I don't know if I would want the joy of trying to work on it in that space. Neat though.
    ...
  35. Thread: hourly pay

    by pherman
    Replies
    98
    Views
    8,593

    It depends on the area. What I make in CA is...

    It depends on the area. What I make in CA is different from my brother in law in MN. It varies by area.
  36. Replies
    3
    Views
    2,998

    You can use a drag link socket. Otherwise your...

    You can use a drag link socket. Otherwise your copeland distributor can order one.
  37. Replies
    13
    Views
    3,897

    Probably not here since this post it from...

    Probably not here since this post it from 2011……I'm sure he either sold it by now or trashed it.
  38. Replies
    18
    Views
    4,807

    Very well done.

    Very well done.
  39. Replies
    6
    Views
    1,418

    Nice job. Looks clean!

    Nice job. Looks clean!
  40. Replies
    52
    Views
    4,875

    Nice!

    Nice!
  41. Be prepared for travel if you do ammonia

    Be prepared for travel if you do ammonia
  42. Replies
    5
    Views
    608

    Do you have the leads for it? Email me - email...

    Do you have the leads for it? Email me - email address in my profile. Thanks
  43. Replies
    19
    Views
    1,513

    Stater Bros Markets has in house crew, there's...

    Stater Bros Markets has in house crew, there's Hill Phoenix, Hussmann, Source, CTS, and Market Refrigeration Specialties.
  44. Replies
    19
    Views
    1,513

    Sounds like we're ready to move huh?

    Sounds like we're ready to move huh?
  45. Replies
    19
    Views
    1,513

    That sounds great! They're your stores you own...

    That sounds great! They're your stores you own them. If you're up on the maintenance and leak checking etc. The on call shouldn't be that bad once they're squared away….Just thinking though if...
  46. Replies
    19
    Views
    1,513

    It's great work and consistent. You'll learn a...

    It's great work and consistent. You'll learn a lot, but as it's already been said, if you have a wife and kids you might want to think about time away from them. If it's in house they most likely...
  47. Replies
    7
    Views
    534

    Dye maybe

    Dye maybe
  48. Replies
    52
    Views
    4,875

    It'd be nice to see some pics of that.

    It'd be nice to see some pics of that.
  49. Replies
    52
    Views
    4,875

    Cool thanks for the info.

    Cool thanks for the info.
  50. Replies
    52
    Views
    4,875

    Here's one that's unique. It's out of service...

    Here's one that's unique. It's out of service but still pretty cool.
Results 1 to 50 of 604
Page 1 of 13 1 2 3 4

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech365 Virtual Event