Search:

Type: Posts; User: Abuello

Search: Search took 0.01 seconds.

  1. Replies
    8
    Views
    380

    Thanks!, wasn't sure I understood the "lingo"....

    Thanks!, wasn't sure I understood the "lingo". So, it seem the T/S I've picked is correct for my application. Now, I'll cobble together the T/S , 7 conductor Ca, and a wiring harness for the T/S on...
  2. Replies
    8
    Views
    380

    OK, looked through a number of T/S trying to...

    OK, looked through a number of T/S trying to determine the correct one for my application with an Amana PTAC with AUX heating, heat pump heat and cooling. Not sure , but is this considered a 2 stage...
  3. Replies
    8
    Views
    380

    Thanks a bunch! I'll take a look through there.

    Thanks a bunch! I'll take a look through there.
  4. Replies
    8
    Views
    380

    Hi Here's what I have.... First the spec off...

    Hi
    Here's what I have....
    First the spec off the cover plate, the next pic is the T/S terminal strip connection.
    Hopefully you can read these. From what I'm finding, I do need a Heat Pump T/S as...
  5. Replies
    8
    Views
    380

    remote heat pump T/S

    Hi Guys,
    I have an Amana through-wall heat pump in my sunroom. I don't feel the built-in T/S is accurate. I can set the temp to, example 65, but, will "kick-on" well before as determined by...
  6. Replies
    12
    Views
    1,797

    Yesterday, the sun-room was about 80-82 deg. When...

    Yesterday, the sun-room was about 80-82 deg. When all of this freezing was happening. What I would do, is raise the cooling temp and place an oscillating fan in front of the coils and the frost would...
  7. Replies
    12
    Views
    1,797

    Thanks, I'll look in those two directions. Does...

    Thanks, I'll look in those two directions. Does an output at the coil of 62-64 degs. Indicate a low refrigerant level? Current ambient outside temps are high 80s.
  8. Replies
    12
    Views
    1,797

    Thanks, but, it's clean as I've previously...

    Thanks, but, it's clean as I've previously mentioned. Also note, thus far today, no icing issues.
  9. Replies
    12
    Views
    1,797

    Hi, Not a filter issue. I monitor it often and...

    Hi,
    Not a filter issue. I monitor it often and is clean, as is the coil.
  10. Replies
    12
    Views
    1,797

    Hi, Not that I recall. It's just been the past...

    Hi,
    Not that I recall. It's just been the past few days, this has occurred. The reason I'm thinking it might be unusually high humidity levels in this sun-room, there has been some condensation on a...
  11. Replies
    12
    Views
    1,797

    high humidity causing this?

    Hi Guys,
    With our recent high temps have come high humidity levels. I have a through-wall heat pump system in our add-on sun-room only. The rest of the house has a big time HVAC system. Lately, the...
  12. Replies
    20
    Views
    3,442

    Hi Guys, Thanks for all of your replies. I think...

    Hi Guys,
    Thanks for all of your replies. I think I have it figured out. As "beenthere" has mentioned, the Piezo is there to re-ignite the pilot at such time, it is needed. This unit still has a...
  13. Replies
    20
    Views
    3,442

    Hi, Can you expand on this? Thanks.

    Hi,
    Can you expand on this? Thanks.
  14. Replies
    20
    Views
    3,442

    OK, Here's where I was going when I mentioned...

    OK,
    Here's where I was going when I mentioned the thermo-couple sensing the drop in temp....
    "A thermo-couple sensor detects when the temperature of the water drops and sends an electrical impulse...
  15. Replies
    20
    Views
    3,442

    Yeah I get that part. But, I'm thinking when the...

    Yeah I get that part. But, I'm thinking when the temp drops, the water temp sensor (thermocouple/thermistor ckt) creates a miliovolt to fire the "Piezo", thus the gas valve opens(?)
  16. Replies
    20
    Views
    3,442

    Hi, Thanks for your patience... It's a "State"...

    Hi,
    Thanks for your patience...
    It's a "State" brand Model GS650YRBT. There is one wire leading from the top of the control valve to spark igniter(?) inside the unit.
  17. Replies
    20
    Views
    3,442

    I'm having a difficult time trying to figure this...

    I'm having a difficult time trying to figure this out. This is a gas system with "no" electrical connections? Is there an internal spark generator of some type?
  18. Replies
    20
    Views
    3,442

    Hi, Thanks. Yes, I've been looking at transfer...

    Hi,
    Thanks. Yes, I've been looking at transfer switches as I have a generator, but, thus far the outages have not been prolonged to the point of real concern. I was just thinking there can be a way...
  19. Replies
    20
    Views
    3,442

    pilotless hot water tanks

    Hi Guys,
    Can a natural gas pilotless hot water tank be manually started? I understand how my heating system (furnace) operates and know it needs power to operate. But, in times of outages, I would...
  20. Replies
    7
    Views
    1,551

    Thanks, that sounds very plausible and am going...

    Thanks, that sounds very plausible and am going to add one this coming week and change the wiring.
    Thinking through this, I'm sensing the circuitry on the digital control board has two sides (?)....
  21. Replies
    7
    Views
    1,551

    OK. I understand what it's supposed to do. Yes,...

    OK. I understand what it's supposed to do. Yes, the 400 model does require a pad change twice per season. The problem is the solenoid valve is not opening and has never opened from new. I thought my...
  22. Replies
    7
    Views
    1,551

    Hi, Are you meaning I need to fill the cup...

    Hi,
    Are you meaning I need to fill the cup reservoirs with water in order to initiate the continuing process of this system operating as designed? If this is true, there is no reference in any of...
  23. Replies
    7
    Views
    1,551

    Humidifier solenoid valve ?

    Hey guys,
    We have a Trane XV80 furnace and Aprilaire 400 humidifier. All of this was installed last spring. Since the weather has been, somewhat, mild I didn't notice the humidifier was not working...
  24. Replies
    0
    Views
    363

    Trane T/S Model 802A Programmable

    Hey Guys,
    HVAC System is a Trane XV80 with X16i condenser
    I think I'm reading my guide correctly, so based on my installer's guide, the 802A T/S can be programmed for "auto change-over" for those...
Results 1 to 24 of 24

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech 365