Search:

Type: Posts; User: texasmax

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    512
    Views
    170,244

    George- let me take my own stab at this- the...

    George- let me take my own stab at this- the power vent will keep the house cooler in the summer. But at what expense is the question. It will draw in outdoor air through the soffit baffles to help...
  2. Replies
    8
    Views
    791

    I've got 14 returns today (with 11 wall chases;3...

    I've got 14 returns today (with 11 wall chases;3 chases being split into two grills on opposite sides of the same wall), and will go down to 4-6, so same location- no, but evenly distributed (looking...
  3. Replies
    8
    Views
    791

    Dash- thanks for the help!- before discussing if...

    Dash- thanks for the help!- before discussing if they'd make the trip, we got to a rough quote and it looks like blocking off the existing returns and putting in new ones at the ceiling will be a lot...
  4. Replies
    8
    Views
    791

    I never got past the front desk, so let me give...

    I never got past the front desk, so let me give that a shot...

    The duct blaster I had done couldn't even get a solid reading, we're confident everything's sealed up EXCEPT the returns at ground...
  5. Replies
    8
    Views
    791

    Aeroseal in Dallas?

    Wanted to get a quote on Aerosealing my ductwork; I'm too far away for the closest listed contractor on Aeroseal's website. Did some searching, and the only shop I found that had it listed as one of...
  6. Original install was 4 years ago; the entrie...

    Original install was 4 years ago; the entrie triangle was replaced last year when I noticed it was leaky. Do I still have recourse at this point? And would the (minimally, at least) acceptable...
  7. 681- supply plenum, 2 18" round lines, the closer...

    681- supply plenum, 2 18" round lines, the closer one does a 180 degree curve and comes to...
    682- the triangle
    683- a close-up of some of the twists on the left-hand side (on which there are 4...
  8. Thanks for the replies! Will see if I have a pic...

    Thanks for the replies! Will see if I have a pic to post or will take one in the morning.
  9. Triangles: an efficient splitting mechanism?

    All-

    Going to have some return ducts added (sealing off the returns that run through the wall cavities and putting in return grills in the ceiling); debating getting some quotes on rejiggering...
  10. Replies
    4
    Views
    515

    There's actually a good deal of board down, just...

    There's actually a good deal of board down, just not as close as visible in the pics (excpet for those 3 or so boards that are seen, that come in handy when changing the filter :))
  11. Replies
    4
    Views
    515

    I'd love to, but let's see what the quote comes...

    I'd love to, but let's see what the quote comes back as... and the closest Aeroseal contractor (based on the Aeroseal website search) won't come to my area (too far- I've called in the past to at...
  12. Replies
    4
    Views
    515

    Efficient return air re-do...

    All-

    Recently had a duct blaster test done, and wouldn't you know it, we couldn't even get a reading. I'm thinking (as well as the tech) that the return air setup is the culprit- all return...
  13. Replies
    2
    Views
    484

    So, the one key piece of information I left out...

    So, the one key piece of information I left out was that there are two 90 degree turns in the blocks- sort of like a squared-off bay window. Techically an exterior storm window could be built, but...
  14. Replies
    2
    Views
    484

    "Insulating" glass block

    All-

    Have a 5'x8' section of glass block wall in our master bath. In Dallas, it's been getting into the 40s at night. IR thermometer tells me it's just 10 degrees warmer on the inside-facing...
  15. Replies
    6
    Views
    719

    me75006 - thanks for the info- didn't know Oncor...

    me75006 - thanks for the info- didn't know Oncor incentives were available...
  16. Replies
    2
    Views
    661

    Good to know- thanks!

    Good to know- thanks!
  17. Replies
    2
    Views
    661

    Mold on inside of supply vents

    All-

    Sealing up the last of my supply vents (mastic between the drywall and the sheetmetal boot). Vents and boots are 30 years old (with the house), all-new AC/furnace/air handler and flex duct...
  18. That makes sense, they're all pulling from a...

    That makes sense, they're all pulling from a common handler thus at the same pressure...
  19. That's funny- just last night I was passing a...

    That's funny- just last night I was passing a tissue over all my return vents, to see if any pulled stronger or weaker than the others (given that the larger-ducted, larger-registered returns will...
  20. From a temp gun at least, the temps at the supply...

    From a temp gun at least, the temps at the supply vents for the longer runs are warmer than the temps for the shorter runs, by 6-7 degrees F. The longest runs go through a 40' 18" run, triangle, 20'...
  21. Didn't think about checking the temp difference...

    Didn't think about checking the temp difference between the handler and the triangle- will definitely do that :)

    Yes- when the AC folks checked for leaks, it was feeling for air flow with the AC...
  22. Oh yes- I've been getting quotes and plan to do...

    Oh yes- I've been getting quotes and plan to do this soon.

    But, it still won't help the heat load on the ductwork in the attic...
  23. I've got anywhere from R-11 to R-19 right now. ...

    I've got anywhere from R-11 to R-19 right now.

    Most of the ductwork (the larger/longer runs, anyway) is hanging, bottoms 18" or more off the floor, so burying isn't an option unfortunately.
  24. Benefit to extra insulation around attic ducts?

    All-

    So I burned 3700 kWh cooling my 3,000 sqft house last month. I'm halfway through my radiant barrier job (stapling foil to the rafters myself, but with the heat in Dallas I'm going real...
  25. Our previous 12-month contract expried and we...

    Our previous 12-month contract expried and we paid 24.9 cents for the month of June :(, shame on me for not keeping on top of it.

    Along the same lines, we keep our house 73 all day long (we like...
Results 1 to 25 of 43
Page 1 of 2 1 2
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event