BARD Water Source Heat Pump StartUp Problem
Hello all. Open loop system out of a well. Well pump stopped working due to bad pressure switch which has been fixed. Purged all air out of waterlines and did restart procedure as outlined in installation manual. Green "check" light is on at thermostat and compressor will not kick on no matter what sequence of start up I try. Unit was working fine before well pump trouble.
I'm having a hard time finding a service tech in my area and was wondering if ANY competent tech can come out and check for lockout switch trouble, etc. etc or in your experience should I wait and find a service tech with good WSHP expertise?
Don't want you to get hurt.
If you tried to reset by turning off power and the lockout happens the moment you turn back on and call for heating or cooling, then it is time to call in a COMPETENT technician. If it runs for a little and then shuts off on lockout, try restarting a few times in the cooling mode. See prior post for explanation.
Again, good luck.