New Install HELP...serviceman coming tomorrow AGAIN!!!
First let me say THANK YOU for this site..Tons of Good People and INFO!
I need some help with a new Install that was done in my house a week ago.
The system is an Amana (Goodman) 14 Seer outside unit, (3 ton) matching Evaporator coil and a new Amana Gas Furnace.
It is set up in a downflow setup.
This will be the third time I have to have the service man out to address a condensation problem.
They installed the TXV outside of the Exaporator housing, and it leaks condensation all over my floor!
To tell the truth, I have never seen a TXV located outside of the housing before, and given the amount of condensation it generates..It seems like it should have been located inside the evaporator from the start!
They either Made or had a Neoprene "Can" that goes over the valve and secures with Velcro...it has filled up with water twice, then overflows on the floor!
Should this be moved inside the housing where the condensation can be controlled??
Please, any advice would be great!!!