How do the Novar pulses work with a IMP-1010
This is an older Novar controller. I've seen some newer ones that I think pulse something like .6 sec to 2.5 sec. I believe this one is on a 1 minute cycle on for 13 off for 47 etc. My question is about testing the IMP-1010 transducer. There is a momentary switch that will inflate/deflate the actuator but how can I test it with a relay or jumper wire? I tried constant on, constant off, manual pulsing, nothing works. Tried a few and they are all the same. I ordered a UCP-822 to replace one I am sure is dead but am unsure of how to set it up and test as well.