We never do anything with the secondary drain, no one around here does. If it has a overflow pan then we put a float switch in it.
I must be blind, because I dont see an auxiliary drain pan???
Looks great btw!
:cheers:Great job, its nice to see someone put that extra time and effort in.
Very nice work. Judging from the attention to detail I bet you got pressures right on the money, sh and sc to spec... I like the way the line set is just perfectly routed. I dont see anything wrong with that setup. Keep up the good work, thanks for sharing..
I came back after the building was down to temp and it was hot out to set pressures.
Here in Florida near the coast you have to put the dryer inside or it won't last.
I never put a safety pan with a switch in either unless it was in an attic, on a rare occasion, on a first floor set up.
By code we have to put a float switch in every install, wether it be in an attic or closet. It is a code I do agree with.
not too hateful....wierd spot though
Nice install, I would have liked to see a condensate float switch on the overflow, where is the trap for the condensate drain?
I know that Carried recommends that the filter drier be placed by the indoor unit, I take it that other manufacturers are also doing the same. Nice clean install.
Trap is down low, tied it into the sink drain. EZ trap.
We don't use overflow switches. Why all the sudden everyone pushing them with a horizontal application?
I have only been to 1 install we did to unclog a drain. Unico system in an attic with about 40' of drain with 6" of fall over that length. Took a few years but it finally plugged. Blow it out with nitro every spring now when we change filter. Takes an extra 5 minutes.