No particular order.
Printable View
No particular order.
what! you don't put the stickers/magnets on upflows?:angel:
nice looking metal work
Nice looking work.
I was just admiring some of your work. I graduate in June and am still not sure if I want to do sales or install/service. I used to work for an HVAC wholesaler and was looking at some of the different products that you used. Like the filter drier, is it Alco? I also noticed that you use what I think is called "EZ Trap"? I think I saw a familiar tubing bender also. In the last picture with the condensing unit, I saw a yellow box with black bending blocks? We use that in school and I used to sell a ton of them. You can bend tubing with one finger!! Ok, ok, ok, I'll admit it, I'm a dork. I just find this work so interesting and fascinating. I've loved the 2 years I've been in school and can't wait to get a job and put my knowledge to good use!!
EZ Traps are the cats meow. Nice to use.
My first spiral duct job tomorrow, all overhead. This is a square to round we had made. 20x20 square to 18" round. Definitely flow better than using an 18" collar.
Nice looking job!
A 19 seer and a 16 seer systems from monday. Forgot to snap pics of the indoor units.
Always love the dryer vent being right next to the unit...
Nice, neat, clean.
Good work. :.02:
Very nice clean work, I like when people care... The home owner have no idea how lucky that you did there install.
Went and put dampers in and did all my low voltage on a 2 zone evolution system this morning. New construction. Finally done.